How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bob Your Own Question
Bob, Auto Tech
Category: Chevy
Satisfied Customers: 4087
Experience:  Plus 40 years GM, over 30 certified with Chevrolet, ASE certified Master Tech. (Expired, Retired)
Type Your Chevy Question Here...
Bob is online now
A new question is answered every 9 seconds

how to bleed slave cylinder on a 2000 s10 blazer

Customer Question

No Comment Added
Submitted: 9 years ago.
Category: Chevy
Expert:  Bob replied 9 years ago.

Hello below you will find instructions on the bleeding procedure right out of the S10 service manual. I hope this help you. Thanks

Document ID# XXXXX
2000 Chevrolet S10 Pickup

Hydraulic Clutch Bleeding

Important: Do not use fluid that you have bled from a system to fill the reservoir. The fluid may be aerated or contaminated.

  1. Ensure the reservoir is filled to the fill line with new brake fluid. Add fluid if required. Use Delco Supreme® Brake Fluid GM P/N(NNN) NNN-NNNNor equivalent.
  2. Push the clutch pedal all the way down to the floor panel.
  3. Open the bleed screw on the concentric slave cylinder in order to expel the air.
  4. Close the bleed screw and release the clutch pedal.

    Important: Ensure no air is drawn into the clutch system.

  5. Repeat steps 2, 3, and 4 until all the air is out of the clutch system.
    1. Check and refill the reservoir as needed while bleeding.
    2. After bleeding, pump the clutch pedal several times. If the clutch engagement is not satisfactory, repeat the bleeding procedure.
  6. If the previous procedures are unsuccessful, perform the following steps.
    1. Pump the clutch pedal very fast for 30 seconds.
    2. Stop pumping and let the air escape into the reservoir.
    3. Repeat this procedure as necessary.

Document ID# XXXXX
2000 Chevrolet S10 Pickup