Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
Ron. Mazda CX-7 2.3L Turbo 2008. Has low power, struggles to
Mazda CX-7 2.3L Turbo 2008. Has low power, struggles to get past 4000 rpm. Feels like it's surging but it's not bringing up an engine light or any fault codes. Fuel pressure at idle is about 250 kpa and then goes up to 1100 kpa with hard acceleration using a snap on scanner. … read more
shawn24_91
shawn24_91
Automotive Technician
Associate Degree
231 satisfied customers
09 lexis is250 wont strt and keep running- no fuel-replaced
09 lexis is250 wont strt and keep running- no fuel-replaced both fuel pumps, fi relay, edu injector driver(used) … read more
Danny
Danny
Owner, lead mechanic
High School or GED
4,775 satisfied customers
my transit connect engine cut out while going along the road
my transit connect engine cut out while going along the road and would not start again engine turning over and over and glow plug light flashes took to garage and they said low injector pressure but t… read more
sprinkles08
sprinkles08
Technician
High School or GED
19,325 satisfied customers
2002 Land Rover Freelander V6 2.5L. Just put a used engine in it.
I have a 2002 Land Rover Freelander V6 2.5L. Just put a used engine in it. Replaced the thermostat assy., had radiator cleaned and flow tested. Engine runs good. The only problem is overheating while … read more
Neal
Neal
Auto repair pro, 30 years experience
Associate Degree
8,342 satisfied customers
idles perfect...ive replaced coil pack..starter motor,fuel filter
having troble with my vt hard starting hot or cold cranking fine but wont fire have to crank 3-6 times before it will fire, car runs fine and idles perfect...i've replaced coil pack,plugs and leads ,b… read more
Daniel
Daniel
Lead mech
Some college
5,053 satisfied customers
1992 pontiac firebird: key the engine heat needle goes all the way
i just went out to turn my 1992 pontiac firebird on and it will not turn over at all i noticed when i turn the key the engine heat needle goes all the way up to 260 and pinns out what is wrong?… read more
MikeD'
MikeD'
Diagnostic Technician
Associate Degree
416 satisfied customers
1990 Dodge Spirit: cyl..the head gasket..heater core..water pump
My 1990 Dodge Spirit with 4 cyl non turbo engine has run nice and cool since the head gasket was replced over a year ago. Car has 85K miles on it. By the way, the heater core, thermostat and water pum… read more
MikeD'
MikeD'
Diagnostic Technician
Associate Degree
416 satisfied customers
1994 JEEP wrangler: tuneup,INJECTORS,DISTRIBUTOR..REGULATOR..CRANK
1994 JEEP WRANGLER 4.0, MT EXPERIENCES HARD START FIRST START AND AFTER SITS 2 OR MORE HOURS, HAVE ALREADY INSTALLED COMPUTER,TUNEUP,INJECTORS,DISTRIBUTOR,FUEL PUMP AND REGULATOR, MODULES AND CRANK, O… read more
Derrick
Derrick
Associate Degree
920 satisfied customers
1998 Ford Mustang: V..that has problems starting..runs perfect..smooth
I have a 1998 Ford Mustang 3.8 V-6 that has problems starting when cold. It runs perfect very smooth both at idle or high speeds. Gas mileage is as high as you could expect for this engine. It starts … read more
MechanicMan
MechanicMan
High School or GED
478 satisfied customers
2000 Nissan Maxima: car it cranks but has trouble starting
I have a 2000 Nissan Maxima. When you try to start the car it cranks but has trouble starting. It sometimes takes 5 minutes are so to finally get it started. We replaced the alternator but it still ha… read more
Mike V.
Mike V.
technician
Subaru and Nissan factory training.
30,569 satisfied customers
98 Grand Cherokee Laredo: itsitsforabout20minutes..restarted..stalls
We have a 98 Grand Cherokee Laredo 4.0. The vehicle was just perfect has only 60k miles. When started cold, or after it sits for about 20 minutes hot, and is restarted, the idle rolls high and low to … read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
25,738 satisfied customers
87 nissan pathfinder: my stock oil presser gauge..more power..cams
i have a 87 nissan pathfinder and its running better than ever but my stock oil presser gauge is reading 0 and this morning i put a new fuel fillter on and now there is more power and it sort of runni… read more
MechanicMan
MechanicMan
High School or GED
478 satisfied customers
1993 Jeep Grand Cherokee Laredo: a 4.0 6cyl..Snap..scanner..pulling
Help... I have a 1993 Jeep Grand Cherokee Laredo with a 4.0 6cyl in it. I am using a Snap on scanner MT2500 and pulling no codes. Here are the symptoms and what I have replaced chasing this problem: I… read more
Pete
Pete
High School or GED
22 satisfied customers
90 Nissan 300zx: non turbo..thin and engine hard to start and stalls
90 Nissan 300zx non turbo oil mixing with gas . oil to thin and engine hard to start and stalls… read more
Sam C
Sam C
Service Manager
Almost a liberal arts!
792 satisfied customers
96 Olds: L..starter had multi cyclinder misfire code
96 Olds acheiva 2.4 L . Your help with prior question . Was hard to start kicked back on starter had multi cyclinder misfire code . We have replaced crank and cam sensors , checked cam time, ignition … read more
Hammer Time
Hammer Time
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
2000 Dodge Grand Caravan: the 3.3L flex fuel engine..sat..cranks fine
My 2000 Dodge Grand Caravan with the 3.3L flex fuel engine is hard to start in the morning or if it's sat for a couple of hours. It cranks fine, but doesn't fire. I must crank it 10 - 15 seconds or so… read more
GENE
GENE
service manager/lead technician
Vocational, Technical or Trade Scho
316 satisfied customers
Nissan 300zx: twin turbo..original owner)..rebuild..covered garage
I have a really nice Nissan 300zx twin turbo with only 24k miles on it, (I am the original owner). We recently rebuild our home and I moved the car to a covered garage and put it under a blanket; sadl… read more
john
john
Mechanic
High School or GED
154 satisfied customers
1993 GMC: z71..V8..several cranks and pumps..pedal to get it going
I have a 1993 GMC Sierra z71, its a V8. After the truck sits for just a little while it takes several cranks and pumps on the pedal to get it going, after it starts it seems to have full power and is … read more
Hammer Time
Hammer Time
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Excellent reply, and also very quick. Really sounds like the Expert knows what he is talking about. I will be back to use your service when I need more help with my RV.

DutchUSA

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,679 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,843 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,571 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

John

John

Master Automotive Technician

1,004 satisfied customers

ASE A1-A8 & L1 Master GM Tech 40 years experience

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

690 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,721 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x