Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
07 Nissan frontier, mushy brake pedal, replaced master
07 Nissan frontier, mushy brake pedal, replaced master cylinder, abs module, pads, booster holds vacuum, calipers aren't leaking, vacuum bleed a couple times. still mushy … read more
John
John
Associate Degree
732 satisfied customers
I have Holden Cruze 2010. I flash out brake fluid and I
I'm Reza, I have Holden Cruze 2010. I flash out brake fluid and I grease all brake caliper pin. I did brake bleeding by scan tools (MK808) and also all four wheels line for six times. The brake is normal (hard and goes down about 1/3 of course) when the engine is off. which shows me master cylinders is ok also there is no air in the system. but when the engine is on, The brake is very soft and goes down to the floor. The brake padel will back to original position in both engine off and engine on, but when the engine is on brake back slowly and with some noise which I think it is ABS pump. I'm suspect to the booster check valve. Please tell me what's wrong with my brake system and instruct me how to fix it. Thank you. … read more
Eric
Eric
Retired
N/A
35,674 satisfied customers
2002 ford f150: calipers..brakes..right rear..up pedal has fade half
replacedrear roters and calipers on 2002 ford f150 having hard time bleeding brakes done several times as per manual right rear left rear front right left front pedal seems hard and then after start u… read more
autopro
autopro
Lead Tech.
Vocational, Technical or Trade Scho
17 satisfied customers
Brake pedal..it goes way down with slight resistance..booster
My brake pedal seems low . it goes way down with slight resistance four inches before it hits solid four inches from the floor. I've tried the three pedal tests for the power booster and they all seem… read more
ASEMaster35yrs
ASEMaster35yrs
Vocational, Technical or Trade Scho
2,061 satisfied customers
95 4runner: brake pedal..floor on highway..power brake booster..3.0 V6
brake pedal went to the floor on highway. have fluid, new master cylinder, power brake booster and the pedal still goes to the floor when the truck is turned on or started. it is a 95 4runner, 3.0 V6 … read more
JamesH
JamesH
Associate Degree
432 satisfied customers
1999 gmc suburban: 4x4..new pads,rotors,calipers,lines..hoses..pedal
1999 gmc suburban 4x4 put new pads,rotors,calipers,lines,master cylinder, bleed them well i can clamp the front hoses and get a better pedal but not after i take them off i get good pedal with the tru… read more
autodoc_2000
autodoc_2000
Automotive Technician/Asst Service Manag
Vocational, Technical or Trade Scho
2,556 satisfied customers
trying to bleed the brakes on a Chev Blazer 1999 abs ...
trying to bleed the brakes on a Chev Blazer 1999 abs system. Replaced the brake pads and calipher on the driver rear. We have tried to bleeed manually and with a pump and no fluid comes out the bleede… read more
Jerry
Jerry
Master Mechanic
Vocational, Technical or Trade Scho
2,181 satisfied customers
HOW DO I BLEED THE BRAKES AND ROTORS ON 99 SUBURBAN I ...
HOW DO I BLEED THE BRAKES AND ROTORS ON 99 SUBURBAN I HAD TO BUY A NEW ROTOR ON THE FRONT PASSANGER SIDE AND BRAKES BUT I PUT ON EVEN THINK CORRECTLY BUT I HAVE TO STAND ON THE BRAKES TO THEY TOUCH TH… read more
Dan
Dan
Auto Technician
Associate Degree
Ford Ranger: 4WD..Cab..the pads wear excessively and damages the rotor
I have a 1993 4.0L 4WD Extra Cab Ford Ranger and the right front brake caliper sticks closed after the brakes are depressed and released. It makes the pads wear excessively and damages the rotor. When… read more
mackin1
mackin1
Vocational, Technical or Trade Scho
216 satisfied customers
1979 Corvette, brakes, plenty of pedal until I start the ...
1979 Corvette, brakes, plenty of pedal until I start the car, then the pedal goes almost down to the floor until I have a little bit of brake. I have replaced a caliper and pads in the rear, the front… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,420 satisfied customers
1993 volvo 940: ABS brakes..brake pads..calipers..the brake pedal is
I have a 1993 volvo 940 with ABS brakes. We replaced the brake pads and the calipers all the way around. Yet the brake pedal is not firm. Could this be because of the master cylinder or what could it … read more
Eric
Eric
Retired
N/A
35,674 satisfied customers
1990 Chrysler New Yorker: piston..front caliper and pads..brake pedal
I have a 1990 Chrysler New Yorker,Been working on cars for over 40 years as a hobby as job was plant supervisor for large papermill,Had a right front wheel didk brake piston stick,Replaced assb and ho… read more
Mike V.
Mike V.
technician
Subaru and Nissan factory training.
28,825 satisfied customers
2001 ford: replaced front rotors,pads and calipers..driveway..loses
i just replaced front rotors,pads and calipers on my 2001 ford sport trac bled brake system back to front . it has pedal pressure in the driveway but when i drive the pedal loses pressure and pulsates… read more
Eric
Eric
Retired
N/A
35,674 satisfied customers
2006 Mercedes Benz ML350: brake pads..Rear Brake..Rotor..special tools
I need to know the DIY for replacing brake pads for 2006 Mercedes Benz ML350 Front and rear include Front and Rear Brake Discs (Rotor?) too. Do I need any special tools for doing this?39275.585043206… read more
AutoTechGuy
AutoTechGuy
Bachelor's Degree
170 satisfied customers
2005 Kia Sedona Lx: replaced my..my front..brake pedal..front brakes
I replaced my front pads in a 2005 Kia Sedona Lx. The brake pedal now goes to the floor and the front brakes do not work at all. Tried bleeding the front line and barely any fluid is coming out of the… read more
Pete
Pete
High School or GED
22 satisfied customers
1990 Chevy Suburban: brakes..cyl..abs unit, rotors, drums, calipers
Have a 1990 Chevy Suburban 1/2 ton with rear ABD brakes. Pedal goes to floor and wont stop well. EVERYTHING has bee replaced--master cyl, booster, valve, ABS unit, rotors, drums, calipers, ALL. Two ch… read more
Hammer Time
Hammer Time
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
1999 GMC: the caliper rotor and pads...cant seem to get the brakes
how do you bleed the brakes on a 99 jimmy i just replaced the caliper rotor and pads...cant seem to get the brakes bled Optional Information: 1999 GMC Jimmy 4.3 Already Tried: I have replace the back … read more
john
john
Mechanic
High School or GED
154 satisfied customers
2000 Regal: Left front brake gets extremely HOT...rebuild..re-built
2000 Regal GS. Left front brake gets extremely HOT. On last rebuild I installed a re-built calipher and followed manual to a tee. After 17,000 pads completely worn out and rotor scored. Right front ha… read more
Kenny
Kenny
GM technician
High School or GED
2 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

The nearest Volvo dealer is 160 miles away. Best $15 bucks I have spent in a long time!

Paul MCorpus Christi, TX

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,449 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,769 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,570 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

682 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,597 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,017 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x