Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
What could be causing my 2008 4.0l SOHC ranger to idle at
What could be causing my 2008 4.0l SOHC ranger to idle at 2000 rpm unless slowed to less than 5mph? I have had the thermostat, temp sensor and spark plugs replaced and tbe MAF and throttle body cleane… read more
Canuck Tech
Canuck Tech
Associate
501 satisfied customers
Qx4 1998. Miles=160k. Drives same as before. But at idling
Qx4 1998. Miles=160k. Drives same as before. But at idling speed, the engine noise is noticeably at a higher pitch recently, and the idling speed has increased to a little above 1k rpm. What could be … read more
Chris (aka-Moose)
Chris (aka-Moose)
Technician
Vocational, Technical or Trade School
1,413 satisfied customers
I have a mitsibishi mini truck. It will start and run fine
I have a mitsibishi mini truck. It will start and run fine until it warms up. Then it idles down until it shuts off. Is that a governor controlled by a thermostat and something wrong?… read more
gomi_otaku
gomi_otaku
Auto Technician (dealership)
Vocational, Technical or Trade Scho
3,445 satisfied customers
1998 Suzuki Sidekick Sport: 000 miles/ 5 spd/ 4wd..drives..idles..dies
I have a 1998 Suzuki Sidekick Sport. 115,000 miles/ 5 spd/ 4wd. Starts well drives well, except when I slow down to come to a start, it idles down and intermitantly dies on me. It may rough idle for a… read more
Ted G.
Ted G.
ASE Certified Technician
Vocational, Technical or Trade Scho
1,754 satisfied customers
Mazda 626: I drove the idle speed screw clockwise..slow down..ecu
My car is Mazda 626, 2000 year model, I drove the idle speed screw clockwise, idle speed increase at that moment, but after driving the car for a while, idle speed slow down again, do you think I need… read more
Jerry
Jerry
Master Mechanic
Vocational, Technical or Trade Scho
2,181 satisfied customers
1999 olds bravada: rpms..cruise control was on..iac valve
Vehicle maintains rpms after letting up on gas, as if cruise control was on. Have reomved and cleaned iac valve. 1999 olds bravada… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
06 Isuzu Ascender-check engine light on-506 & 1400 ...
06 Isuzu Ascender-check engine light on-506 & 1400 computer codes-started having no crank/no start problem. Replaced throttle body assy. & battery. Repair company said they couldn''t get it to malfunc… read more
supertech
supertech
Vocational, Technical or Trade Scho
2,235 satisfied customers
How do I tune my 1983 mazda RX7. It is not running ...
How do I tune my 1983 mazda RX7. It is not running smoothly, new plugs, new fuel pump and filter. cannot get it to idle and stay running at recommended rpm. I think it is 750rpm. Can you help me?… read more
westrope65
westrope65
Associate Degree
156 satisfied customers
1992 Ford F150: cruising speeds after 2 mile warm-up..miss..gears
1992 Ford F150 4.9L with severe engine "miss" at cruising speeds after 2 mile warm-up. Does not miss at idle or during acceleration up through gears. Runs best at full throttle. Check engine indicator… read more
Amedee
Amedee
Former ASE Master Tech
Vocational, Technical or Trade Scho
2,562 satisfied customers
I have a vauxhall vectra 2.5 v6. On start up, the engine ...
I have a vauxhall vectra 2.5 v6. On start up, the engine revs at 1200 rpm for a minute or two depending on cold weather, then drop to a normal idle speed of 600. If I tap the accelerator immediately o… read more
Matt Kesler
Matt Kesler
Business Owner/Law Student
Doctoral Degree
1,646 satisfied customers
2003 Ford Taurus: with a 3.0L vulcan engine..slow down..idle speed
I have a 2003 Ford Taurus with 40,000mi. with a 3.0L Vulcan engine which idles fast when the engine is cold for 2-3 minutes. Is there a way to get the engine to slow down to normal idle speed any soon… read more
Chris (aka-Moose)
Chris (aka-Moose)
Technician
Vocational, Technical or Trade School
1,413 satisfied customers
advantages of a high revving engine..high rev is better?
exactly what are the advantages of a high revving engine? I know high rev is better? but why?… read more
Steve
Steve
Service Manager/ Technician
5,472 satisfied customers
Rpms..it is starting to shift harder from park to drive, that
my car's rpms are running about 1000 revolutions higher than normal and it is starting to shift harder from park to drive, that might just be because of the rpms. do you know why my rpms are running s… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
1990 jeep cherokee laredo: when car gets..temperature..jerks..reverse
1990 jeep cherokee laredo, auto, 135k. when car gets to normal running temperature it jerks agressively when placed any gear. forward when placed into drive, backward when placed into reverse. the idl… read more
Steve
Steve
Service Manager/ Technician
5,472 satisfied customers
BOOST,..CAR IS IDLING OR DOES THE ENGINE HAVE TO REV MORE TO CHARGE
IF A BATTERY IS RUN DOWN AND NEEDS A BOOST, WILL IT CHARGE WHEN THE CAR IS IDLING OR DOES THE ENGINE HAVE TO REV MORE TO CHARGE THE BATTERY?… read more
Danny
Danny
Service Manager / Foreman
Vocational tech. and College
418 satisfied customers
Prizm: the first thing in the morning, it revs about 2000 RPM..warming
I have a 1997 GEO Prizm. When starting the engine the first thing in the morning, it revs about 2000 RPM and after warming up it starts to drop back to normal readings but this takes about 45 seconds … read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
92 mercury cougar: runs fine..wont run..fuel pump..distributor
have a 92 murcury cougar starts runs fine sitting but won't run in gear have replaced ignition parts and fuel pump,filter complete distributor as these were suggested now what… read more
32roadster
32roadster
Service Technician
Vocational, Technical or Trade Scho
30 satisfied customers
1989 ford f350: it drops low then stalls..egr..idles fine
1989 ford f350 with a 351 truck will not idle it drops low then stalls replaced the idle air control and the egr positions sensor and no change ... when i unplug the vacum from the egr it idles fine… read more
Marc
Marc
fleet supervisor
Vocational, Technical or Trade Scho
1,140 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

Highly recommend this RV expert. Prompt, good and detailed answers were given. Very willing to help with genuine concern. I will ask for him next time.

JackUSA

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,413 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,754 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,564 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

680 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,562 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,009 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x