Car

Ask a mechanic online and get answers to your car questions

Ask an Expert,
Get an Answer ASAP!

Related Car Questions
2003 S10 CHEVY PU VIN 1GCCS14X238256523 Codes P0300 P1381
Amedee,2003 S10 CHEVY PU VIN 1GCCS14X238256523Codes P0300 P1381Customer performed ignition tune up - plugs, wires, cap, rotor and ignition coil.Fuel pressure and flow -ok No arcing from installed part… read more
Amedee
Amedee
Former ASE Master Tech
28,857 satisfied customers
I have 97 S-10 4.3L Vin W. Replaced intake manifold gasket,
I have 97 S-10 4.3L Vin W. Replaced intake manifold gasket, had to pull distributor. Cant determine where TDC is on #1 to replace distributor. There are two marks on the crankshaft pulley and a notch … read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,359 satisfied customers
i replaced fuel pump..fuel injector..i placed a fuel gauge..it drops
i replaced fuel pump and fuel injector spider.because it didnt start after a couple of days sitting . i placed a fuel gauge and still getting the same numbers.when i turn the key on its at 64 and when… read more
autotech155
autotech155
Head Technican
Vocational, Technical or Trade Scho
182 satisfied customers
2000 CHEVY BLAZER: VORTEC..FUEL PUMP, IT..ETHER..PROBLEM.
I HAVE A 2000 CHEVY BLAZER 4.3 VORTEC AND WE HAVE REPLACED THE IGNITION CONTROL MODUAL, FUEL PUMP, IT WILL NOW RUN WITH ETHER, AND BY POURING GAS INTO THE CARBORATOR. IT WILL RUN UNTIL THE GAS RUNS OU… read more
Your Auto Inspector
Your Auto Inspector
Assistant Service Manager
In course of study for bachelor's d
847 satisfied customers
1998 Chevrolet Blazer: 4x4..rotor..fuel pump, fuel filter..rail
1998 Chevrolet Blazer 4x4, 4.3L V-6.Replaced part, plugs, wires, distributor cap, rotor, MAP sensor, fuel pump, fuel filter, Mass airlow sensor. The truck will run fine for a few days and then, when s… read more
Carhelp4u
Carhelp4u
GM Service Training
2,560 satisfied customers
99..a bump and died.Engine cranks fine ,has fuel pressure..sensors
'99 S-10 4.3L...hit a bump and died.Engine cranks fine ,has fuel pressure,ignition fine.Scan shows codes 122 and 1361...checked sensors signal and reference voltages,once again okay.What else could po… read more
Jerry
Jerry
Master Mechanic
Vocational, Technical or Trade Scho
2,181 satisfied customers
2000 gmc safari: accelerating..plugs wires cap rotor..fuel filter..cyl
I have a 2000 gmc safari 4.3 L that has a miss at cruising speed only when engine is warm and not accelerating or decelerating but holding a constant speed above 60 mph. The dealer has replaced plugs … read more
autotech36
autotech36
High School or GED
164 satisfied customers
2000 chevy blazer: throttle body..the fuel filter, fuel pump..meter
i have a 2000 chevy blazer ( 2 door ) 4.3 vortec.....while driving the motor stopped running. motor turns over good but will only start if i pour a little fuel in the throttle body have replaced the f… read more
Bill W.
Bill W.
Auto Tecnician
46 satisfied customers
Fuel Injectors..idle it vibrates and runs rough, when you get..cars
Idling rough----Fuel Injectors OK....Plugs/wires OK.....at idle it vibrates and runs rough, when you get on hi way and speed it up, it runs ok....some one told me the plenum (was a common fule problem… read more
Hammer Time
Hammer Time
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
1991 chevy s10 blazer: 4x4..it idles..throttle body and intake
I have a 1991 chevy s10 blazer 4.3 4x4 that is smoking on startup and when it idles for long periods. the smoke does not smell like oil smoke but smell like the engine is running too rich. Have replac… read more
james
james
Vocational, Technical or Trade Scho
254 satisfied customers
My 1995 GMC Jimmy 4.3 Vortec engine stalls whenever it ...
My 1995 GMC Jimmy 4.3 Vortec engine stalls whenever it wants. Sometimes it won't start. It has a rebuilt engine, a new computer, anew spider, a new fuel pump and pulsator. We've change all the sensors… read more
cardoctor1989
cardoctor1989
Shop owner, all make and models r
Vocational, Technical or Trade Scho
144 satisfied customers
Chevy: I put an old 4.3..trunk..gmc..intake..Im getting
I put an old 4.3 out of a Chevy trunk in my gmc blazer(93) and used my old spider intake. Im getting no fire in 6 cylinder(most of the time) and i think thats what makes it shake(rumble). Could it be … read more
joseph carrillo
joseph carrillo
automotive drivability tech
Vocational, Technical or Trade Scho
314 satisfied customers
1995 chevy blazer: no sounds, lights, etc. had a friend jump..reverse
i have a 1995 chevy blazer. went to start it and nothing-no sounds, lights, etc. had a friend jump it. it started, but as soon as i stepped on the brake to put in reverse, it died. anytime something m… read more
John Baker
John Baker
Retired And now self employed
Bachelor Degree
204 satisfied customers
1997 Tahoe: vortec..random misfires..compression check..cylinders
I have a 1997 Tahoe 5.7 vortec with random misfires mostly on 6 5 and 7. I have done compression check and it is good 150 all cylinders. I did not do a leak down test. I have changed fuel pump twice c… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
1992 S10 blazer: I had to replace the fuel injector 6 months ago
Hi I Have a 1992 S10 blazer with a 4.3 vortec. I had to replace the fuel injector 6 months ago. and It was working fine till a few weeks ago. The truck seem to be holding back and the gas mileage went… read more
Davo
Davo
Master Auto Tech/manager of auto shop
Vocational, Technical or Trade Scho
1,644 satisfied customers
10 blazer: 3 v-6..run rough..chock..it only lasts for about 15 seconds
I have a 1991 chevy s-10 blazar 4-3 v-6 when i start the vehicle in the morning when it's cold. it will run rough like the chock is closed which it dose not have. it only lasts for about 15 seconds an… read more
Steve
Steve
Service Manager/ Technician
5,472 satisfied customers
Blazer: a the fuel injector spider assembly..full tune..shutters
i recently had a the fuel injector spider assembly replace and a full tune-up. Now after the blazer is warm the motor shutters as if it is going to shut off. Any help is greatly appreciated... Optiona… read more
Steve
Steve
Service Manager/ Technician
5,472 satisfied customers
93 Chevy Blazer: first cranks it runs fine...brakes and gas..shutting
I have a 93 Chevy Blazer with a 4.3. When it first cranks it runs fine. When I come up to a stop, I have to hold the brakes and gas to keep it from shutting off. After running the engine for an excess… read more
Steve
Steve
Service Manager/ Technician
5,472 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

The nearest Volvo dealer is 160 miles away. Best $15 bucks I have spent in a long time!

Paul MCorpus Christi, TX

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,402 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,754 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,564 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

680 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

28,857 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,009 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x