Car

Ask a mechanic online and get answers to your car questions

Ask an Expert,
Get an Answer ASAP!

This answer was rated:

Code po344 in a 2012 Chrysler 300 3.6. Camshaft sensor. I…

Code po344 in a...

Code po344 in a 2012 Chrysler 300 3.6

Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it?

Camshaft sensor

Mechanic's Assistant: Are you fixing your 300 yourself? What have you tried so far?

Yes

Mechanic's Assistant: Anything else you want the mechanic to know before I connect you?

I replaced the rockers and the appeared

Show More
Show Less
Ask Your Own Car Question
Customer reply replied 5 months ago
I reset the code and replaced the sensor
Customer reply replied 5 months ago
it all started when I replaced the rockers
Answered in 33 minutes by:
1/23/2018
CurtisE
CurtisE, Mechanic
Category: Car
Satisfied Customers: 1,741
Experience: Qualified Automotive Mechanic, LPG, Airconditioning & Vehicle Diagnostics
Verified
Remove camshaft sensor and look inside where reluctor pickup is. You will find the pickup is damaged and will need to be replaced
Ask Your Own Car Question
Customer reply replied 5 months ago
I've already replaced the sensor and the problem persists
No im not referring to the sensor. Im referring to the reluctor wheel the sensor picks up signal from.
CurtisE
CurtisE, Mechanic
Category: Car
Satisfied Customers: 1,741
Experience: Qualified Automotive Mechanic, LPG, Airconditioning & Vehicle Diagnostics
Verified
CurtisE and 87 other Car Specialists are ready to help you
Ask your own question now
Customer reply replied 5 months ago
The tone ring?
Customer reply replied 5 months ago
Hello are you still their?
Amedee
Amedee, Former ASE Master Tech
Category: Car
Satisfied Customers: 2,557
Experience: ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector
Verified
Phone call session started
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with an auto mechanicLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask CurtisE Your Own Question
CurtisE
CurtisE
CurtisE, Mechanic
Category: Car
Satisfied Customers: 1,741
1,741 Satisfied Customers
Experience: Qualified Automotive Mechanic, LPG, Airconditioning & Vehicle Diagnostics

CurtisE is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

The nearest Volvo dealer is 160 miles away. Best $15 bucks I have spent in a long time!

Paul MCorpus Christi, TX

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,330 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,754 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,560 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

678 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,557 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,008 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Related Car Questions
This 2012 Chevy Cruze seems to run OK but I'm getting these
This 2012 Chevy Cruze seems to run OK but I'm getting these codes. P0106, P0171, P1101, P015B, P0502. It has a 1.4 L motor with turbo and manual transmission. What do you recommend?… read more
fordguy4u
fordguy4u
Automotive Tech
Vocational, Technical or Trade Scho
70 satisfied customers
Camshaft sensor. Check engine triggered, camshaft position
Yes check engine triggered, camshaft position sensor … read more
3pac2222
3pac2222
nissan master auto tech
Associate Degree
2 satisfied customers
2007 sebring with check engine code po344. The code was read
Haven't tried anything yet. was told it could be a cam shaft positioning sensor. I am a student on a tight budget so I would like to repair it myself if possible. … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
5,653 satisfied customers
Changed timing belt, car runs great, p0016 code, should i
changed timing belt, car runs great, p0016 code, should i have disconnected my battery to reset pcm,cam,crank sync … read more
Peter Bagley
Peter Bagley
master technition
Vocational, Technical or Trade School
1,290 satisfied customers
After car has been running shutting it off for a while then
after car has been running shutting it off for a while then go to restart it it cranks over but does not start, wait for a few minutes then starts… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
5,653 satisfied customers
I am looking for Suzuki Mechanic with a lot of knowledge
I am looking for Suzuki Mechanic with a lot of knowledge with a 2008 XL7 LIMITED 3.6 Codes for throttle position sensor on the pedal Replaced this pedal sensor and replaced throttle body Also code wil… read more
indy-tech
indy-tech
Shop owner, technician
Vocational, Technical or Trade Scho
11 satisfied customers
Are the Camshafts or the reluctors different between a 2006
Are the Camshafts or the reluctors different between a 2006 ly7 3.6 engine and a 2007 one? what about the sensors. I swapped engines from a 2006 cadillac CTS into my 2007 Suzuki XL-7. i used all the o… read more
Pete
Pete
Independent Auto Technician
Vocational, Technical or Trade Scho
138 satisfied customers
Sebring: I have a 2005 Chrysler Sebring coupe with the 4 cylinder
I have a 2005 Chrysler Sebring coupe with the 4 cylinder engine. The check engine light has started coming on and staying on, and the engine starts surging at about 3500 rpm in neutral, or at 2000 rpm… read more
TIM MOHR
TIM MOHR
SHOP OWNER
Master's Degree
8,037 satisfied customers
Metro: cyl..valves..rockers..the camshaft be the problem
I have a 97 geo metro 1.3 four cyl motor valves are taping I replaced rockers and still same situation could the camshaft be the problem?… read more
Randall
Randall
Auto Technician / Consultant
Vocational, Technical or Trade Scho
69 satisfied customers
pathfinder: p0340..engine ran with a slight miss..stall..distributor
I am got a p0340 code on my2000 pathfinder, it started up the engine ran with a slight miss. when put in drive it stall out. check plugs no spark, the after a while after moving the distributor slight… read more
HondaPlatinum
HondaPlatinum
High School or GED
148 satisfied customers
2003 Chrysler Town and Country 3.8L cranks but wont start. Trouble
2003 Chrysler Town and Country 3.8L cranks but won't start. Trouble starting. Engine cranks but lacking spark. Once it starts it will continue to start anywhere from a couple days to a number of month… read more
Anthony
Anthony
Master Automobile Technician
Vocational, Technical or Trade Scho
8,789 satisfied customers
1994 chrysler concord: the computer codes..camshaft position
i have a 1994 chrysler concord when i turn the key the engine just turns over but want start. i looked up the computer codes and was given code 11 camshaft position sensor.could thi be the problem and… read more
Derrick
Derrick
Associate Degree
920 satisfied customers
2006 Volvo S60: was in an accident, the air bags went..car cranks
Recently my 2006 Volvo S60 was in an accident, the air bags went, also there was some front damage. I have fixed the damaged and replaced the bags, all appears to be OK the car cranks but will not sta… read more
Eric
Eric
Retired
N/A
14,436 satisfied customers
1999 chrysler cirrus: camshaft..the fuel filter, fuel pump..egr valve
on a 1999 chrysler cirrus is there a camshaft and a crankshaft position sensor of just a crankshaft position sensor? if both when getting no error code and the car is dying often (getting longer betwe… read more
RIP
RIP
Lead Technician/ JA Car Category Mentor
High School or GED
452 satisfied customers
CAR DIES..TIME AND IT START RIGHT UP AGAIN I HOOKED IT UP TO A TESTER
HELLO MY CAR DIES OUT ON ME FROM TIME TO TIME AND IT START RIGHT UP AGAIN I HOOKED IT UP TO A TESTER AND IT SAID THAT MY CAMSHEFT POISTION SENSOR PO344 WHAT DOES THAT MEAN.… read more
DoctorD
DoctorD
Shop Owner
Vocational, Technical or Trade Scho
652 satisfied customers
1999 chrysler concord: check engine light..it idles..intermittent
i have a 1999 chrysler concord that check engine light keeps going on when its on it idles poorly and at full speed it decellerates. i just took it to a small shop and the computer says error code p13… read more
Matt Kesler
Matt Kesler
Business Owner/Law Student
Doctoral Degree
1,646 satisfied customers
99 Chrysler: crankshaft sensor replaced, a tune..die..it wont start
I have a 99 Chrysler 2.5 that has had the ERG valve replaced, the crankshaft sensor replaced, a tune up and still having problems. It started out that it would idle just fine but when accelerated, it … read more
JONATHAN
JONATHAN
JAGUAR/LAND ROVER SHOP FOREMAN
High School or GED
286 satisfied customers
1994 Chrysler concorde: 000 miles..wouldnt start..about 10 minutes
I own a 1994 Chrysler concorde with just over 100,000 miles on it.3.5 engine. From new every once in a while it would stall at idle, although it would start right back up. Most recently it wouldn't st… read more
Steve7654
Steve7654
Service Manager/ Technician
4 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x