Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
Intermittent groaning noise and vibrating brake pedal when
Intermittent groaning noise and vibrating brake pedal when turning left or right at very slow speeds. Noise appeared after I replaced left and right hub axle bearings. 2004 olds alero 3400 series. Bel… read more
Gary
Gary
Gold Certified Technician
Vocational, Technical or Trade School
2,160 satisfied customers
Wheel bearings and brake pads drove abot5-10 miles..hub..caliper
just changed wheel bearings and brake pads drove abot5-10 miles and started to feel a drag,,took off wheel and hub was hard to spin,,took off caliper and was a little easier but still to free. so i lo… read more
Jerry
Jerry
Master Mechanic
Vocational, Technical or Trade Scho
2,181 satisfied customers
2002 Suzuki: axle..the hub assy and the bearing preload retainer
2002 Suzuki, can't slide the bearing pak off the axle stub, I have the retainer screws off of the hub assy and the bearing preload retainer off, the outer bearing will move slightly but I cannot remov… read more
Randall C
Randall C
Auto Technician / Consultant
Vocational, Technical or Trade Scho
13,053 satisfied customers
2002 Mitsubishi Montero Sport: brakes..caliper..Rotor..new one
I have removed brakes and caliper. Having a tough time getting the Rotor off to replace it with new one. 2002 Mitsubishi Montero Sport AWD. Thanks!… read more
JamesH
JamesH
Associate Degree
432 satisfied customers
2001 Accent: my engine revs -the car does not increase speed
I have a 2001 Accent. When I am moving & I step on the gas fast, to pass, my engine revs -the car does not increase speed for a couple of seconds than it moves. Actually this happens any time I am mov… read more
JamesH
JamesH
Associate Degree
432 satisfied customers
Hyundai Elantra: the transmition as well as the clutch
Can i get the pictures or the instructions on how to set up the transmition as well as the clutch on a 99' Hyundai Elantra with an engine of 2.0 and a manual transmition?… read more
Jason
Jason
ASE Certified Technician
Vocational, Technical or Trade Scho
144 satisfied customers
1973 dodge: rebuilt..brakes..back bearings do i pack them..rear end
I have a 1973 dodge sportsman think its a 4 ton. rebuilt all brakes need to know about back bearings do i pack them with bearing grease or just dip them in rear end grease. what I dont know if I pack … read more
Bob
Bob
Vocational, Technical or Trade Scho
2,784 satisfied customers
my truck to a co..long story short, 1 rotor was severely damaged.
i loaned my truck to a co-worker so he could move. long story short, 1 rotor was severely damaged. to the point that they will need to be changed. i am capable of changing pads but have never changed … read more
CarQuestionGuy
CarQuestionGuy
1,257 satisfied customers
2005 hyundai elantra: release lever will not come..cylinder
i have a 2005 hyundai alantra and i am trying to put in a clutch but after i got it put to gether the release lever will not come back enough to attach to the clutch cylinder… read more
Eric
Eric
Retired
N/A
35,272 satisfied customers
I have a 1993 Ford F-150 Super Cab 4-wheel drive pickup. I ...
I have a 1993 Ford F-150 Super Cab 4-wheel drive pickup. I want to change the brake pads and rotor. How do I do that? I am having problems getting the hub and rotors off. Thank you.… read more
Brad
Brad
Lead Diagnostic Technician
Vocational, Technical or Trade Scho
2,361 satisfied customers
1989 volvo 740 gl: wagon..strut..the wheel bearings out so the rotors
I have a 1989 volvo 740 gl wagon I replaced the strut cartriges and when I took it apart I pulled the wheel bearings out so the rotors could be turned. Well I forgot what direction the outer ball bear… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
1991 Pontiac firebird: bad oil leak out of my rear end..axel..bearings
I have a 1991 Pontiac firebird (5.0, 305, E, engine). I had a bad oil leak out of my rear end at the pinion and axel seal. I changed out the pinion seal and the two axle seals along with the axle bear… read more
Steve
Steve
Service Manager/ Technician
5,473 satisfied customers
Gm: axle..my truck with disc brakes and need to know what the torque
I am repairing a gm drive axle on my truck with disc brakes and need to know what the torque is on the repair… read more
Michael
Michael
Work Equip. Repair Foreman
Vocational, Technical or Trade Scho
554 satisfied customers
98 dodge dakota: directions on how to replace my clutch..clutch kit
How can I get directions on how to replace my clutch on a 98 dodge dakota Optional Information: 1998 Dodge dodge 2.5 L 4 cycl Already Tried: Ordered clutch kit… read more
Steve
Steve
Service Manager/ Technician
5,473 satisfied customers
1991 Honda CIVIC: I CHANGE CLUTCH ON A 91 CIVIC? Optional Information
HOW DO I CHANGE CLUTCH ON A 91 CIVIC? Optional Information: 1991 Honda CIVIC D-SERIES Already Tried: NOTHING… read more
autodoc_2000
autodoc_2000
Automotive Technician/Asst Service Manag
Vocational, Technical or Trade Scho
2,556 satisfied customers
1986 Toyota: would like to be able to see pitcher of clutch asb.
would like to be able to see pitcher of clutch asb. while in car Optional Information: 1986 Toyota tersal 3a… read more
autodoc_2000
autodoc_2000
Automotive Technician/Asst Service Manag
Vocational, Technical or Trade Scho
2,556 satisfied customers
1992 bronco: bearing locknut..u send me diagram of 4 wheel drive..hub
i have a 1992 bronco 5.0 i went to do my front brakes today and cudnt figure out how to get bearing locknut off it comes all the way off till near end and stops...i have a manual but doesnt show it ca… read more
Hammer Time
Hammer Time
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
2000 toyota tundra: two wheel drive..wheel bearings from the hub
on a 2000 toyota tundra two wheel drive how do i remove the wheel bearings from the hub on the front.… read more
Tech501
Tech501
Lead Technician
390 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

The nearest Volvo dealer is 160 miles away. Best $15 bucks I have spent in a long time!

Paul MCorpus Christi, TX

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,449 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,769 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,570 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

682 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,597 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,017 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x