Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
2000 Ford expedition: fuel pump..pump located..two wheel drive/4.6 &
where is the fuel pump located in a 2000 ford expedition/two wheel drive/4.6 & how do you know it went out/having problem of truck not staying on even after buying a new battery/HELP PLEASE!!! Optiona… read more
Jacob
Jacob
Ford Fleet technician
Vocational, Technical or Trade Scho
154 satisfied customers
1994 cadilac elderado 4.6 engine. catalytic converter cherry red.
1994 cadilac elderado 4.6 engine. catalytic converter cherry red. runs a little rough. fuel regulator 40 psi, drops 3 psi when started, drops to 30 psi at higher rpm. injectors not leaking. someone sa… read more
Ms. Wrench
Ms. Wrench
High School or GED
328 satisfied customers
2002 Mustang GT: starting problems..no fuel pressure at the fuel rail
my 2002 Mustang GT 4.6 has intermittent starting problems. When it will not start, I have no fuel pressure at the fuel rail. I did the test on the FPDM, and came up with more than 10.5v. However I don… read more
CTFordTech
CTFordTech
Auto Technician
Vocational, Technical or Trade Scho
4,894 satisfied customers
I have a 1996 lincoln 4.6 dohc,with over 100 psi oil pressure
I have a 1996 lincoln 4.6 dohc,with over 100 psi oil pressure until water temp reaches 210,still have 75 psi at 1500 rpm.Have removed left side valve cover,looks o.k. engine is in 34 ford hot rod with… read more
Matt
Matt
Engineer
Bachelor's Degree
16,307 satisfied customers
1996 saab: i was driving and my clutch started to have little pressure
i was driving and my clutch started to have little pressure to none at all.. what is wrong? its a 1996 saab 900s… read more
Ivan
Ivan
Automotive Instructor
Bachelor's Degree
4,857 satisfied customers
2002 camaro: 3.8L..a little bit of oil pressure but the rpms..slowing
i have a 2002 camaro 3.8L im loosing a little bit of oil pressure but the rpms keep droping to about 300 rpms when im slowing to a stop… read more
Ms. Wrench
Ms. Wrench
High School or GED
328 satisfied customers
97 mitsubishi: curb..oil pressure guage showes little..sending unit
I have a '97 Mitsubishi GST. At curb idle the oil pressure guage shoXXXXX XXXXXttle or no pressure. But a manual check guage at the sending unit port showes 15 PSI. At 3k RPM the needle rides at just … read more
Randall C
Randall C
Auto Technician / Consultant
Vocational, Technical or Trade Scho
12,939 satisfied customers
1996 mercury cougar: the rev..running fine..neutral..bogs down
i have a 1996 mercury cougar 4.6 liter and i used a programmer to beef it up a little bit, i changed the rev limiter and the air/fule ratio,...it was running fine for about a month now all of the sudd… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
2000 cadillac deville: it comes on when i turn the wheel a little bit
i have a 2000 cadillac deville with the service stabillity system on, it comes on when i turn the wheel a little bit. it use to be every time drive it about 20-30miles. now it comes on a the time… read more
Lamp
Lamp
Automotive Claims Inspector
Vocational, Technical or Trade Scho
114 satisfied customers
2000 Pontiac Bonneville: Oil pressure gauge..psi..engine temp..Freeway
Oil pressure gauge at 120 psi, engine temp was 200. Noticed while driving on Freeway. Have a 2000 Pontiac Bonneville. Is it safe to drive until I can get it looked at?… read more
Robert
Robert
RV Tech Support
Vocational, Technical or Trade Scho
16,174 satisfied customers
92 Dodge Dakota: two wheel drive..92 and earlier v6 and v8 models
I have a '92 Dodge Dakota with a 318 and its two wheel drive. The ignition timing seems to be off. But with the '92 and earlier v6 and v8 models you can not adjust the timing your self. The rotor is n… read more
Dan
Dan
Auto Technician
Associate Degree
My 2002 Olds Bravada All Wheel Drive is not working. I have
My 2002 Olds Bravada All Wheel Drive is not working. I have checked All Wheel Drive fuse under seat and the two under the hood, which all look good. Had same problem few years back and thought they to… read more
Mad Mike
Mad Mike
Vocational, Technical or Trade Scho
255 satisfied customers
1985 jaguar xj6: The fuel pressure at the cold start inj, is 150 psi
I have a 1985 jaguar xj6. The fuel pressure at the cold start inj, is 150 psi? I was told it should 34 psi. Car will not run.… read more
Dr. Hamman
Dr. Hamman
Vocational, Technical or Trade Scho
6,151 satisfied customers
Gmc: 2500 hd..drained..fuel filter..the enging cuts out at high rpms
have a gmc 2500hd 2003 with high and low pressure codes showing service engine light is on and i have drained the fuel filter lots of water then just replaced it . the enging cuts out at high rpms and… read more
Dan
Dan
Auto Technician
Associate Degree
2001 suzuki esteem: fuel pump..it runs fine..it comes back and runs ok
I have a 2001 Suzuki Esteme. I changed the fuel pump in it but it runs fine for a little bit then stalls out. Then it comes back and runs ok for a little bit and stalls out again. Can I get advise on … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,060 satisfied customers
2001 Suzuki Esteem: the fuel pump in it..runs fine..stalls..comes back
I have a 2001 Suzuki Esteem. I changed the fuel pump in it but it runs fine for a little bit then stalls out. Then it comes back and runs ok for a little bit and stalls out again. Can I get advise on … read more
Dr. Hamman
Dr. Hamman
Vocational, Technical or Trade Scho
6,151 satisfied customers
Danny: I have checked the fuel pump 100 psi. At the engine
Danny:I have checked the fuel pump 100 psi. At the engine it is 40 psi. The ecu side of the injectors is not getting the negitive charge. do you have any other ideas.… read more
eric remington
eric remington
FORMER SHOP OWNER/TECHNICIAN/INSPECTOR
associates degree
1,608 satisfied customers
perfomance programmer fuel pressure reads..without damaging
just installed perfomance programmer fuel pressure reads one psi.can I drive conservatively for a little while without damaging anything… read more
OnlineHelp
OnlineHelp
Bachelor's Degree
3,390 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Excellent reply, and also very quick. Really sounds like the Expert knows what he is talking about. I will be back to use your service when I need more help with my RV.

DutchUSA

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,449 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,769 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,570 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

682 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,597 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,017 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x