Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
I have a 2017 Ford F-150 5.0 and it stalls and shudders when
i have a 2017 Ford F-150 5.0 and it stalls and shudders when you stop after driving, its throwing a p0012 code … read more
DanielP121
DanielP121
Field Service Engineer
Certificate
436 satisfied customers
2007 Ford Edge 3.5 engine where is Cam Shaft Position
2007 Ford Edge 3.5 engine where is Cam Shaft Position Actuator at? I have code P0010 P0012… read more
Ron
Ron
Automotive Tech
Vocational, Technical or Trade Scho
42,427 satisfied customers
2016 FORD TRANSIT CONNECT 2.5. ENGINE CODE P0016. REPLACED
2016 FORD TRANSIT CONNECT 2.5. ENGINE CODE P0016. REPLACED CAM SENSOR...CRANK SENSOR...VVT SOLENOID AND CHANGED THE OIL. VEHICLE RUNS FINE JUST THROWS THAT CODE. … read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
10,867 satisfied customers
G'morning Gunvir, I took my truck to the Ford Dealership to
Second opinion] G'morning Gunvir, I took my truck to the Ford Dealership to have a diagnostic test ran on the engine because I wanted to know why it shudders when I get up between 50 to 70mph. Then it… read more
Malcolm Gillespie
Malcolm Gillespie
821 satisfied customers
08 f150 98000 miles can phaser advaced about 60 degrees on
08 f150 98000 miles can phaser advaced about 60 degrees on bank 1 normal on bank 2 about 10 degrees another tech replaced valve cover gaskets spark plugs and truck came back runing bad with codes set … read more
Master Auto Tech.
Master Auto Tech.
High School or GED
546 satisfied customers
I have a 1999 ford f-250 it has a misfire so what i have
i have a 1999 ford f-250 it has a misfire so what i have tried was changed plugs with that discoverd one of the coils was broke off at the boot. and one was broke where it mounts to block so changed b… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
10,867 satisfied customers
1999 ford contour. 2.0 VCT engine. Was idling badly. Ran good
1999 ford contour. 2.0 VCT engine. Was idling badly. Ran good down the road. Replaced: VCT solenoid, cam sensor, timing belt, belt tensioner. Set the timing. Idled great and ran great for about 500 mi… read more
Steve
Steve
Ford tech Specializing in electronics
Vocational, Technical or Trade School
6,766 satisfied customers
Runs rough..idles..coil pack, air flow meter, fuel pump and filter
i have a 1996 land rover discovery, it runs rough, idles up and down, sometimes it has good power and sometimes it's no power, I have replaced spark plugs twice, wires, coil pack, air flow meter, fuel… read more
Daniel
Daniel
Lead mech
Some college
5,053 satisfied customers
I drive a 2004 Lincoln Navigator. When I start the engine it
I drive a 2004 Lincoln Navigator. When I start the engine it makes a LOUD ticking noise(my neighbors have heard it across the street)! As the vehicle warms up it slowly disappears. Unfortunately this … read more
Ironmike
Ironmike
ASE Master ,Ford Certified Master Tech
Vocational, Technical or Trade Scho
3,563 satisfied customers
1998 Ford Focus: emission..obd code..Cam Timing..bulletin..is 03-15-14
My 1998 Ford Focus won't pass the emission test required by virginia. The OBD code is P1383, I see that it says P1383 Cam Timing Advance is excessive when looking up the code online. ford bulletin num… read more
Ron Z.
Ron Z.
Vocational, Technical or Trade Scho
23,721 satisfied customers
anti-lock..axle..20 mph and detect wheel-lock in 10 ms or less
A car anti-lock brake sensor uses a toothed wheel on the axle and a variable reluctance pick-up. It should operate above 20 mph and detect wheel-lock in 10 ms or less. How many teeth would you specify… read more
Chris (aka-Moose)
Chris (aka-Moose)
Technician
Vocational, Technical or Trade School
2,141 satisfied customers
95 GMC truck: TBI, 4x4 ... bogs down on acceleration, wont..mph..coil
'95 GMC truck, 5.0L auto, TBI, 4x4 ... bogs down on acceleration, wont go above 18 mph. Idles fine, seems to have good fuel supply, no intake manifold leaks, coil and wires check out ok. Distribitor i… read more
beneyce
beneyce
Bachelor's Degree
18 satisfied customers
2004 Ford F150 4x4, 5.4 engine, 109000 miles Sounds like a ...
2004 Ford F150 4x4, 5.4 engine, 109000 miles: Sounds like a lift noise from the passenger's side of engine. It appears to be a major problem to remove valve cover. Is this a common problem with this e… read more
CTFordTech
CTFordTech
Auto Technician
Vocational, Technical or Trade Scho
4,894 satisfied customers
You throttle it all the way ..it bogs down and dies..rev..cap..rotor
I got a 1992 Geo Metro...It idles fine..except if you throttle it all the way ..it bogs down and dies. But you can rev it up and down just not all the way open. I replaced all wires, plugs, condenser … read more
mackin1
mackin1
Vocational, Technical or Trade Scho
216 satisfied customers
97 Ford Escort LX: 146,000 miles..accelerating..gas pedal it will rev
I have a 97 Ford Escort LX, 5 speed manual transmission, with 146,000 miles on it. Just within the past couple of days it has started bogging down/hesitating during accelerating in 1st and 2nd gear an… read more
Brian9
Brian9
Automotive Technician
Vocational, Technical or Trade Scho
226 satisfied customers
F-150: tires..there is slight grinding and when brakes applied..rotor
I have a 04 F-150 that has a right front shimmy when going 65 mph and above, tires have already been balanced and rotated and checked for problems. Feels like there is slight grinding and when brakes … read more
Telles
Telles
Associate Degree
126 satisfied customers
93 Ford F-150: it reaches 55 mph or more it acts..somewhere..bucks
Hi, I have a 93 Ford F-150 with a 302 engine. Just gave it a complete tune up to try and remedy the problem. When I drive the truck and it reaches 55 mph or more it acts like it is bogging down like t… read more
john
john
Mechanic
High School or GED
154 satisfied customers
2001 Buick Regal: 60,000 miles that has lost power..accelerate..rpm
I have a 2001 Buick Regal with 60,000 miles that has lost power. Vehicle will barely accelerate or travel up hills. When floored max RPM is approximately 3000. Max speed is approximately 30 MPH. No EC… read more
Hammer Time
Hammer Time
Mastertech
Vocational, Technical or Trade Scho
2,650 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

The nearest Volvo dealer is 160 miles away. Best $15 bucks I have spent in a long time!

Paul MCorpus Christi, TX

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

2,141 satisfied customers

24 years of experience diagnosing & repairing

Ted G.

Ted G.

ASE Certified Technician

1,861 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,571 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

Amedee

Amedee

Former ASE Master Tech

2,912 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,103 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

704 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x