How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Pete Your Own Question
Pete, Technician
Category: Car
Satisfied Customers: 27833
Experience:  17 years automotive training and experience.
Type Your Car Question Here...
Pete is online now
A new question is answered every 9 seconds

Saab 9-3 2.0T: Saab 9-3 2.0 t 2008My dashboard is reading

This answer was rated:

Saab 9-3 2.0 t 2008
My dashboard is reading alarm failure along with reading all tires are low and left reverse light is out. However the tires and the reverse light are in good order. Whats my next step.

Also Driver Side Rear passenger door has no power going to it. I have checked connections and all seem in good order, connected and not frayed. The window will not roll down at all.

Lastley, driver door window when automatically rolling up , goes completely shut then fall back down to 3/4 the way shut. I am completely lost and any shop I call has no idea .
My name is XXXXX XXXXX I am a professional here at Just Answer/Pearl. I noticed that your question was not getting a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.

If all of these issues occurred at the same time this sounds like an electrical fault has caused these issues and may be a short in wiring at fault.

If any wiring repair or damage has occurred recently before these faults occurred I would inspect the area of damage/repair and see if the fault is located.

If all of these issues occurred at separate times or if no wiring damage or repairs had been performed recently let me know and we can continue.This may also be a fault with a control unit/ecu.If you can get the fault codes read out of all computers using a scan tool that can communicate with all of them on this vehicle let me know what code numbers come up.

Thanks Pete
Pete and 5 other Car Specialists are ready to help you
Customer: replied 3 years ago.
So I need to run a dyno to get anywhere with it ?
A scan tool should be plugged in to see if any codes have set.If any have set these would need diagnosed to locate and correct this fault here.

Thanks Pete

I am following up with you to see if you still needed help with your question you had asked.If my help didn't satisfy your question please let me know so we can continue.

Thanks Pete