How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Eric Your Own Question
Eric
Eric, Automotive Repair Shop Manager
Category: Car
Satisfied Customers: 32378
Experience:  Automotive Repair Shop Manager, Technician/JA Mentor
3195632
Type Your Car Question Here...
Eric is online now
A new question is answered every 9 seconds

Isuzu Trooper LS: Vehicle: 1995 Isuzu Trooper 3.2 SOHC. V-Belt

This answer was rated:

Vehicle: 1995 Isuzu Trooper 3.2 SOHC. V-Belt setup. Alternator located on passenger side, right under power steering pump. Getting overvoltages so want to bench test alternator. Cannot get access to electrical connections at back of alternator. Chiltons has not diagram or procedure for this setup. Alternator is currently unbolted but cannot wiggle it out. (Was hoping I could move things enough to get to the wires.) Can get fingers on the connector but can't see it or tell what I'm dealing with back there! What's the proper procedure for doing this? Advice?
Hi,

Alternator comes out from below and is accessed from below with engine splash shield(undercover removed). It is tight but doable.

1995 Isuzu Truck Trooper (2 Door) V6-3165cc 3.2L SOHC (6VD1)

graphic
Preparation:
^ Battery ground cable

1. Front under cover
2. Generator fixing bolt
^ Loosen fixing bolt.
3. Fan Belt
^ Loosen lock bolt.
^ Loosen adjust bolt.
4. Adjuster
5. Generator fixing bolt
^ Remove the fixing bolt.
6. Wiring connector
^ Disconnect terminal "B" and connector.
^ From generator, supporting generator assembly by hand.
7. Generator assembly
^ Take out generator below.

INSTALLATION
7. Generator assembly
^ Direct terminal "B" to below side and bring generator assembly to the position to be installed.
6. Wiring connector
^ Connect harness connector and direct terminal "B" to above side.
5. Generator fixing bolt
^ Temporarily secure with bolts.
4. Adjuster
3. Fan Belt
^ Refer to item "Drive belt adjustment".
2. Fan belt
1. Front under cover
^ Battery ground cable
Eric and 8 other Car Specialists are ready to help you
Customer: replied 4 years ago.

Perfect! I had actually accomplished this before getting yer answer BUT that is exactly how to do it. Good answer and I'm payin' for that anyway.