How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff
brownjeff, ASE Certified Technician
Category: Car
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
11021861
Type Your Car Question Here...
brownjeff is online now
A new question is answered every 9 seconds

daewoo nubria how do I change a crankshaft position sensor

Resolved Question:

how do I change a crankshaft position sensor on a 2000 daewoo nubria?
Submitted: 5 years ago.
Category: Car
Expert:  brownjeff replied 5 years ago.
Hello and Welcome to JustAnswer,

My name is XXXXX XXXXX I am here to try and assist your with your question.

  1. Disconnect the negative battery cable.
  2. Remove the power steering pump, if equipped.
  3. Remove the A/C compressor, if equipped.
  4. Remove the rear A/C compressor mounting bracket bolts and the rear A/C compressor mounting bracket, if equipped.
  5. Remove the accessory mounting bracket by removing the bolts.

  1. Disconnect the Crankshaft Position (CKP) sensor connector from the fuel injector channel cover.
  2. Remove the CKP sensor retaining bolt.
  3. Gently rotate and remove the CKP sensor from the engine block.
Installation Procedure
  1. Insert the CKP sensor into the engine block.
  2. Install the CKP sensor retaining bolt.

Tighten
Tighten the crankshaft position sensor retaining bolt to 58 lb-in (6.5 N.m) .

  1. Connect the CKP sensor connector to the fuel injector channel cover.
  2. Install the accessory mounting bracket.
Tighten
Tighten the accessory mounting bracket bolts to 26 lb-ft (35 N.m) .
  1. Install the rear A/C mounting bracket, it equipped.

Tighten
Tighten the rear A/C mounting bracket bolts to 26 lb-ft (35 N.m) .

  1. Install the A/C compressor, if equipped.
  2. Install the power steering pump, if equipped.
  3. Connect the negative battery cable.
brownjeff and 5 other Car Specialists are ready to help you