Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
1992 Buick Lesabre: speeds of 50 and up it jerks..few minutes..dies
1992 Buick Lesabre--at speeds of 50 and up it jerks,if I take my foot off it stops but after a few minutes it dies . I let it sit for 15 or so minutes and it starts again. The camshaft sensor has been… read more
Tim West
Tim West
Service Manager
Computer/ Automotive certifications
16 satisfied customers
1993 oldsmobile cutlass supreme: COIL..wont start..the fuel injectors
WHAT DOES THE SENSOR READ FROM THE CRANK SHAFT FOR IT TO FIRE THE FUEL INJECTORS AND COIL PAK? My 1993 oldsmobile cutlass supreme won't start ... it will turn over, but there is no fire to the fuel in… read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
14,792 satisfied customers
2003 saab: arc..cold weather..it runs great, but have to crank
I have a 2003 Saab 9.5 Arc 3.0T that is difficult to start in cold weather. Once it starts, it runs great, but have to crank quite a bit before starts. Any Ideas?… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,291 satisfied customers
I have a 2000 Cadillac Eldorado the engine dies now and then
I have a 2000 Cadillac Eldorado the engine dies now and then when warming up. The only code that shows up now and then is the crankshaft sensor. I thought that is only had one which is located below t… read more
Eric
Eric
Retired
N/A
35,674 satisfied customers
Aerio sx: I need to replace the crank position sensor..easiest way
I need to replace the crank position sensor on my 03 aerio sx. Could you please help me to locate and inform me on the easiest way to replace? Thank you.… read more
Trouble shooter 1
Trouble shooter 1
Associate Degree
108 satisfied customers
2003 Cadillac DeVille: engine code..crank position..diagram..cant find
I have a 2003 Cadillac DeVille with engine code p0335 (ckp). Ive read that the crank position sensors tend to go bad and I even found a diagram of where it is in relation to the oil filter. From under… read more
Randall C
Randall C
Auto Technician / Consultant
Vocational, Technical or Trade Scho
13,111 satisfied customers
2004 hyundai santa Fe: code reads..crankshaft sensor malfuncation what
2004 hyundia Santa Fe [email protected] code reads po335some thiing about crankshaft sensor malfuncation what do I need to look at.… read more
Lamp
Lamp
Automotive Claims Inspector
Vocational, Technical or Trade Scho
114 satisfied customers
2000 Cadillac: crankshaft sensors..with a 4.6 ltr northstar engine
Service procedure to replace the crankshaft sensors on a 2000 Cadillac with a 4.6 ltr northstar engine… read more
Joe
Joe
Shop supervisor
Vocational, Technical or Trade Scho
708 satisfied customers
1997 Pontiac: faulty..My Haynes repair manual says
I have a 1997 Pontiac Transport with the 3.4 L engine. The check engine code indicates a faulty crankshaft position sensor problem. My Haynes repair manual says that once the sensor(s) is replaced, a … read more
Roadside Jerry
Roadside Jerry
Auto Expert on Just Answer
Vocational, Technical or Trade Scho
2,945 satisfied customers
92 mazda miata: because of burnt valves..it acts..getting spark
i got head job on my 92 mazda miata because of burnt valves now when i set the cam timing and try to start it acts like its 180 deg. off. but its not what do i try it also sais no ignition feedback si… read more
TrevHelpsYou
TrevHelpsYou
High School or GED
28 satisfied customers
97 saturn: wont start..fuel getting to the injectors..ignition module
i have a 97 saturn sl1 that wont start. the battery is good, there is fuel getting to the injectors. i have replaced the ignition module. i have an oil leak on the intake side, could the oil damage my… read more
DoctorD
DoctorD
Retired Auto Shop Owner
Vocational, Technical or Trade Scho
807 satisfied customers
1996 Oldsmobile: runs great..going down..it will die..stop sign
1996 Oldsmobile 88. runs great most of the time yet sometimes it stumbles while going down the road, even at a steady speed. The most troublesome problem is that on occasion it will die while coasting… read more
Ted G.
Ted G.
ASE Certified Technician
Vocational, Technical or Trade Scho
1,769 satisfied customers
1996 Pontiac Bonneville: diagnostics..I needed a new crank sensor
I took my car to a shop and had it hooked up to a diagnostics machine and they told me that the reason my car wasn't starting all the time was because I needed a new crank sensor. I purchased the sens… read more
Bob
Bob
Vocational, Technical or Trade Scho
2,784 satisfied customers
1999 chrysler cirrus: camshaft..the fuel filter, fuel pump..egr valve
on a 1999 chrysler cirrus is there a camshaft and a crankshaft position sensor of just a crankshaft position sensor? if both when getting no error code and the car is dying often (getting longer betwe… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
2001 camry LE: cylinder..crank position sensor..magnet..worn down
I have a 2001 camry LE 4 cylinder. The crank position sensor was changed, because it was bad...but where the magnet of the sensor and the crank shaft meet to turn the car over when starting the car...… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,666 satisfied customers
Car to a garage and they said the crank sensor is bad and they
sent car to a garage and they said the crank sensor is bad and they need to get in the engine to fix it.… read more
Don - Mo Lurch
Don - Mo Lurch
Owner
Vocational, Technical or Trade Scho
10,864 satisfied customers
1994 lumina: you change crank sensor..van..plugs coils wires egr
how do you change crank sensor on 1994 lumina van 3.8 motor i cant figure out whats wrong it surges at 2500 to 3000rpms changed plugs coils wires egr valvestill surges… read more
Jaxer Smith
Jaxer Smith
Owner
Technical
1,272 satisfied customers
2001 chevy: 3/4 ton with a 4.3 liter engine..dtc..It Runs great
A 2001 chevy express 3/4 ton with a 4.3 liter engine. Dtc P0335b sets at high RPMs above 6000. It Runs great at normal driving. The wiring to the PCM is good. I get the 5 volt referance and the 12 vol… read more
Davo
Davo
Master Auto Tech/manager of auto shop
Vocational, Technical or Trade Scho
1,644 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

The nearest Volvo dealer is 160 miles away. Best $15 bucks I have spent in a long time!

Paul MCorpus Christi, TX

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,505 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,769 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,570 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

682 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,597 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,017 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x