How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask brownjeff Your Own Question
brownjeff, ASE Certified Technician
Category: Car
Satisfied Customers: 13886
Experience:  17 years experience, ASE certified, dealership certified, Service Manager for 15 years,
Type Your Car Question Here...
brownjeff is online now
A new question is answered every 9 seconds

how do i change the starter on a 2004 chrysler pacifica

Resolved Question:

how do i change the starter on a 2004 chrysler pacifica?
Submitted: 7 years ago.
Category: Car
Expert:  brownjeff replied 7 years ago.

Here is the information on the starter.


If you still need help just reply, if not click ACCEPT when we are done.








  1. Disconnect the negative battery cable.

Upper Radiator Cross Member

Upper Radiator Cross Member Removed

  1. Remove and relocate the upper radiator crossmember.

Fan Module In Vehicle

  1. Remove the radiator fan module.
  2. Remove the wiring harness clip from front mount.

Coolant Line Bracket

  1. Remove the coolant line clamp bolt.

Front Rubber Mount Upper Nut

  1. Remove the upper nut from the front mount.

Upper Starter Bolt

  1. Remove the upper starter mounting bolt.

Middle Starter Bolt

  1. Remove the middle starter bolt.
  2. Raise vehicle and support.

Front Rubber Mount In Position

  1. Remove the lower front mount nut.

Support Engine

  1. Raise and support engine.

Bracket Trans Bolt

  1. Remove the lower bracket bolt to transmission.

Bracket Engine Block Bolt

  1. Remove the lower bracket bolt to engine block.
  2. Relocate the front mount and bracket.
  3. Disconnect the positive battery cable from starter
  4. Disconnect the solenoid connector from starter.

Starter Lower Bolt

  1. Remove the lower starter bolt.
  2. Remove starter from vehicle.


Starter And Shield

  1. Install starter and shield to vehicle.
  2. Start the lower starter bolt.
  3. Connect the solenoid connector to starter.
  4. Connect the positive battery cable to starter
  5. Relocate the front mount and bracket.

Mount Alignment Pin


  • The front mount has an alignment pin, make sure that the mount and bracket line up together. The alignment pin goes toward the front of vehicle.
  • Make sure that the wire harness is in front of the front mount.
  1. Install the lower bracket bolt to engine block.
  2. Install the lower bracket bolt to transmission.
  3. Tighten both lower bracket bolts.
  4. Lower engine.
  5. Install the lower front mount nut and tighten .
  6. install and tighten the middle starter bolt .
  7. Install and tighten the upper starter mounting bolt .
  8. Lower vehicle.
  9. Install the upper nut to the front mount and tighten .
  10. Install the coolant line clamp bolt .
  11. Install the wiring harness clip to front mount.
  12. Install the radiator fan module.
  13. Relocate and install and the upper radiator crossmember.
  14. Connect the negative battery cable.
brownjeff and 7 other Car Specialists are ready to help you