How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Certified Technician
Category: Car
Satisfied Customers: 12803
Experience:  32 years Foreign / Domestic Cars All aspects of Diag and Repair
Type Your Car Question Here...
Randall C is online now
A new question is answered every 9 seconds

how do you install a shifter cable on a 2001 rodeo isuzu auto

Customer Question

how do you install a shifter cable on a 2001 rodeo isuzu auto transmission?
Submitted: 8 years ago.
Category: Car
Expert:  Randall C replied 8 years ago.

hello , here are the step /step book instructions. Hope it helps and thanks




  1. Set selector lever in "P" position.
  2. Remove transfer control lever knob, lower cluster assembly, rear console, center console, selector lever knob and cover.

  1. Disconnect inner cable by pulling projection on pin.

  1. Press down claws and disconnect cable assembly.
  2. Disconnect PCM harness connectors and remove nuts that fasten grommet in select cable assembly.
  3. Disconnect inner cable.


  1. Slide sleeve and disconnect cable assembly.

  1. Pull lock.
  2. Draw select cable assembly into the interior side.


  1. Set selector lever in "P" position.
  2. Let out select cable transmission side end from floor hole.

  1. Fit outer cable into bracket in selector lever assembly.
  2. Set inner cable end in selector lever and push pin into selector lever hole and inner cable end.


  1. Check that lock projects.
  2. Connect adjust end fitting attachment to the bracket on transmission.
  3. Set select lever "P" position and connect inner cable to select lever.


  1. Push lock into adjust end fitting attachment.
  2. Install grommet.