How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tristan Franklin Your Own Question
Tristan Franklin
Tristan Franklin, MASTER ASE CERTIFIED
Category: Car
Satisfied Customers: 1616
Experience:  8yrs. exp. engine repair performance brakes electrical air condition
10186415
Type Your Car Question Here...
Tristan Franklin is online now
A new question is answered every 9 seconds

Where is the water pump located on a 1992 Acura Integra

This answer was rated:

No Comment Added

the first illustration is for 1.8l the second is for a 1.7l engine. good luck. i hope i helped and please accept my answer. thanks T-MAN

REMOVAL & INSTALLATION

See Figures 1, 2, 3 and 4

It is necessary to remove the timing belt cover(s) and remove the timing belt from the water pump sprocket, to remove the water pump on all models. This procedure can be found later in this section.

A small amount of weeping from the bleed hole in the water pump is considered normal and no cause for replacement.

  1. Disconnect the negative battery cable. Remove the timing belt.
  2. Drain the cooling system.
  3. Remove the water pump-to-engine bolts and remove together with the drive sprocket.
  4. To install, use a new O-ring and reverse the removal procedures. Torque the 6mm bolts to 9 ft. lbs. (12 Nm) and 8mm bolts to 16 ft. lbs. (22 Nm).

Click image to see an enlarged viewFig. 1: Water pump mounting-Integra Click image to see an enlarged viewFig. 2: Water pump mounting-1986-90 Legend Click image to see an enlarged viewFig. 3: Water pump mounting-1991-93 Legend Click image to see an enlarged viewFig. 4: Water pump mounting-Vigor

  1. Refill and bleed the cooling system. Start the engine, allow it to reach normal operating temperatures and check for leaks. Check and/or adjust the engine timing.

REMOVAL & INSTALLATION

See Figures 1, 2, 3 and 4

It is necessary to remove the timing belt cover(s) and remove the timing belt from the water pump sprocket, to remove the water pump on all models. This procedure can be found later in this section.

A small amount of weeping from the bleed hole in the water pump is considered normal and no cause for replacement.

  1. Disconnect the negative battery cable. Remove the timing belt.
  2. Drain the cooling system.
  3. Remove the water pump-to-engine bolts and remove together with the drive sprocket.
  4. To install, use a new O-ring and reverse the removal procedures. Torque the 6mm bolts to 9 ft. lbs. (12 Nm) and 8mm bolts to 16 ft. lbs. (22 Nm).

Click image to see an enlarged viewFig. 1: Water pump mounting-Integra Click image to see an enlarged viewFig. 2: Water pump mounting-1986-90 Legend Click image to see an enlarged viewFig. 3: Water pump mounting-1991-93 Legend Click image to see an enlarged viewFig. 4: Water pump mounting-Vigor

  1. Refill and bleed the cooling system. Start the engine, allow it to reach normal operating temperatures and check for leaks. Check and/or adjust the engine timing.

 

Tristan Franklin and 2 other Car Specialists are ready to help you
Customer: replied 9 years ago.
Dear sir,

Thank you very much for your answer. It was extremely helpful.
thank you sir. and please click accept that would be a bonus to me. again thanks