Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
My daughter's 2005 1.2 Micra won't start, checked for codes
My daughter's 2005 1.2 Micra won't start, checked for codes it shows p0340, camshaft sensor malfunction, don't know where the sensor is, and read that it could be a timing belt issue … read more
Peter Bagley
Peter Bagley
master technition
Vocational, Technical or Trade School
1,551 satisfied customers
Motor runs and it stops when reaches normal running temp. It
Motor runs and it stops when reaches normal running temp. It won't start until temp cool down … read more
Chris
Chris
15,657 satisfied customers
2005 suzuki forenza: camshaft sensor..the check engine light went
i own a 2005 suzuki forenza where my engine light keeps going even after repairing what was wrong with my car recently. i failed the emissions test and the code that came up was for the camshaft senso… read more
OnlineHelp
OnlineHelp
Bachelor's Degree
3,390 satisfied customers
2003 mazda 6: it to miss..hold gas at 2-3 on tach..misfires..clears
I have a 2003 Mazda 6i (4cylinder) that has a hesitation when cold. It can get it to miss when I idle it and hold gas at 2-3 on tach. It hesitates or misfires for a couple of seconds and then clears. … read more
Amedee
Amedee
Former ASE Master Tech
Vocational, Technical or Trade Scho
2,597 satisfied customers
Lancer: cam and crank sensors, and swapped coils..timing
03 lancer---2.0 shut off going down road, no spark have checked cam and crank sensors, and swapped coils still no spark , timing is right on, any light on this would be great thanks… read more
Amedee
Amedee
Former ASE Master Tech
Vocational, Technical or Trade Scho
2,597 satisfied customers
pathfinder: p0340..engine ran with a slight miss..stall..distributor
I am got a p0340 code on my2000 pathfinder, it started up the engine ran with a slight miss. when put in drive it stall out. check plugs no spark, the after a while after moving the distributor slight… read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
25,590 satisfied customers
1995 Subaru Legacy L: stalls..idling..Diagnostic..Malfunction
I have a 1995 Subaru Legacy L that sometimes stalls when idling at traffic light, etc. Then it is usually difficult to start. Diagnostic is P0340 Camshaft Position Sensor A Bank 1 Malfunction. Is this… read more
Lamp
Lamp
Automotive Claims Inspector
Vocational, Technical or Trade Scho
114 satisfied customers
Fuel filter..air filter..an ICM attached, new spark plugs/wires..seat
My car continues to have random stalling and hard starting issues but I have always been able to restart it - eventually - but it seems to be getting worse. When the car stalls code P0340 Camshaft pos… read more
Bob
Bob
Vocational, Technical or Trade Scho
2,784 satisfied customers
New fuel filter, new air filter, used PCM, new spark plugs/wires and I
My car continues to have random stalling and hard starting issues but I have always been able to restart it - eventually. When the car stalls codes P0340 Camshaft position sensor and code P0336 Cranks… read more
Your Auto Inspector
Your Auto Inspector
Assistant Service Manager
In course of study for bachelor's d
847 satisfied customers
Neon: DOHC..manual trans..fuel pump..fuel pressure
1998 Plymouth Neon DOHC 95k miles, manual trans. fuel pump was just replaced crankshaft sensor replaced. fuel pressure OK. coil checks OK. Car stalls at times first restarted after 3mins now getting v… read more
diagman
diagman
Store leader
High School or GED
676 satisfied customers
I have a 2004 chrysler sebring gtc, the car started acting ...
I have a 2004 chrysler sebring gtc, the car started acting as if it wasn''t getting fuel and then died. It restated after 20 min. but it was running ruff and when I took the idle up to 4000 rpm it wou… read more
motor_Joe
motor_Joe
Vocational, Technical or Trade Scho
36 satisfied customers
1999 chrysler cirrus: camshaft..the fuel filter, fuel pump..egr valve
on a 1999 chrysler cirrus is there a camshaft and a crankshaft position sensor of just a crankshaft position sensor? if both when getting no error code and the car is dying often (getting longer betwe… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
2001 Hyundai Sonata: timing belt..it stalled..code reader..same code
I replaced the timing belt on a 2001 Hyundai Sonata, gave it back to my daughter and it stalled out on her. The code reader said it had a camshaft position sensor circuit malfunction. I replaced the c… read more
DoctorD
DoctorD
Retired Auto Shop Owner
Vocational, Technical or Trade Scho
807 satisfied customers
2001 f250: im driving along the engine cuts out..mins..pumping..rpm
i have a 2001 f250 superduty 7.3l and the problem is when im driving along the engine cuts out. i wait a couple of mins and try to start again, with pumping gas it will eventually start but will only … read more
MASTER TECH 07
MASTER TECH 07
AUTO / DIESEL MECHANIC
Vocational, Technical or Trade Scho
116 satisfied customers
96 Subaru Outback: Impreza..OBDII..the crankshaft position sensor, it
I have a '96 Subaru Outback Impreza with some computer problems. The OBDII test gives me a code P0340. This is the crankshaft position sensor, it also says 'Bank 1 circuit malfunction', what does this… read more
RIP
RIP
Lead Technician
Vocational, Technical or Trade School
469 satisfied customers
Jeep: position sensor..freeway..stalls..the check engine light is
Ok...I've replaced the camsaft position sensor code# XXXXX I'm driving on the freeway and the Jeep stalls out and the check engine light is on again. Now..I got CODES P0340, P0846, P1299, & P1391 at t… read more
david
david
Heavy Duty Repair Mechanic
Vocational, Technical or Trade Scho
500 satisfied customers
1996 Volvo 850: Wagon..running fine..this, ran fine, and did not run
I have a 1996 Volvo 850 Wagon. It was running fine, and all of a sudden will not start. It started once after this, ran fine, and did not run again. It turns over fine, I obtained a hand-held computer… read more
Steve
Steve
Service Manager/ Technician
5,473 satisfied customers
96 chrysler Concorde: generic scan tool..coil pack..spark plugs..relay
i have a 96 chrysler Concorde with a 3.5 i have a trouble code P0340 with is the camshaft sensor. I have a new one and it has a piece of carbord should i remove it before i install the sensor or insta… read more
Michael
Michael
Work Equip. Repair Foreman
Vocational, Technical or Trade Scho
554 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Excellent reply, and also very quick. Really sounds like the Expert knows what he is talking about. I will be back to use your service when I need more help with my RV.

DutchUSA

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,449 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,769 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,570 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

682 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,597 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,017 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x