Car

Ask a mechanic online and get answers to your car questions

Connect one-on-one with {0} who will answer your question

Related Car Questions
2012 Mitsubishi Lancer 130k miles. A/c stopped working. I
A/c stopped working. I replaced the expansion valve, didn't help. I noticed the high side pressure was too high so I replaced the condenser, vacuumed the system, and recharged. Now the a/c works, hi and Lo pressures seem right, blows cold, but the compressor clutch cycles every 10 seconds. Clutch engages for 6-10 sec, disengaged for 6-10 seconds at idle. It's even worse when driving, when I apply gas, it cycles every 4-5 seconds. I found out that it's the evaporator temperature sensor (thermo probe) that keeps disengaging the clutch at 32F degrees. According to the car's specs, when the temp sensor sees 32F, it tells the ecu to disengage the comp. clutch, which is exactly what it's doing. Why is the evap getting so cold? Temp out the vents is 40F. But the clutch is cycling too frequently (every 5 seconds when driving). I understand the temp sensor is disengaging the clutch so the evap doesn't freeze over, but the cycle time is way too frequent. Why? … read more
Richard Greer
Richard Greer
Vocational, Technical or Trade School
1,033 satisfied customers
2007 Saturn Ion - will not move in any gear with the clutch
2007 Saturn Ion - will not move in any gear with the clutch out. Acts like maybe clutch is fully engaged & will not disengage; a mechanic informed me maybe the linkage between the pedal & the master c… read more
Clifton B.
Clifton B.
nissan master auto tech
Associate Degree
4,751 satisfied customers
1992 honda accord: a clutch, flywheel..bearing..master cylinder..pedal
I just did a clutch, flywheel,pressure plate ,throw out bearing ,slave cylinder and master cylinder on a 1992 honda accord but the clutch will not disengage,but the fork on the throw out bearing moves… read more
Matt fixall
Matt fixall
Fleet Manager
Vocational, Technical or Trade Scho
16 satisfied customers
1993 grand cherokee: with a 4.0 engine..main bearings be replaced
I have a 1993 grand cherokee with a 4.0 engine. My question is besides the rod bearings can the main bearings be replaced from under the vehicle the same as the rod bearings or is it more detailed. If… read more
mlappert
mlappert
High School or GED
34 satisfied customers
1998 Olds Bravada: V6 engine..the SUV around town it runs fine..45 mph
I own a 1998 Olds Bravada with the V6 engine. When I drive the SUV around town it runs fine. If I drive anywhere over 45 mph, the engine begins to overhead. Sometimes I hear a gurgling sound in the da… read more
Dan
Dan
Auto Technician
Associate Degree
2004 Cadillac Escalade: hot air after replacing the battery
Why does my 2004 Cadillac Escalade air conditioning now blow hot air after replacing the battery?… read more
Rexcars27
Rexcars27
Bachelor's Degree
80 satisfied customers
1997 Chevy Blazer: V6..I run The AC Have new radiator water pump edt
How do I check the Fan cluch on a 1997 Chevy Blazer with a V6 4.3L It over heats when I run The AC Have new radiator water pump ect. Fluids are full… read more
Dan
Dan
Auto Technician
Associate Degree
GMC: first start..loud..comming..race car till this fan shuts off.I
I just bought a GMC Jimmy, 2000.When I first start it and start to go,I get a loud roar that lasts till I reach around thirty five mph.The dealer said that the way these Jimmys are and they all make t… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,660 satisfied customers
2000 Jeep Cherokee: liter..a/c clutch bearing..cooling
Have a 2000 Jeep Cherokee 4-liter. Sounded like the a/c clutch bearing was starting to go, high pitched squeal when it engaged. Didn't get around to replacing it and then the squeal stopped and so did… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,420 satisfied customers
Engine running..shifter..all the gears w/o depressing the clutch pedal
with the engine running I can move the shifter through all the gears w/o depressing the clutch pedal. there's no noise or change in engine speed. I bled the clutch and damper. i got the vehicle in thi… read more
Pete
Pete
High School or GED
22 satisfied customers
1997 corvette: flywheel..manual transmission..bled..engage
i changed the clutch, pressure plate, flywheel, and slave cylinder on a 1997 corvette, manual transmission, I bled the system but the clutch still does not fully engage. what can i do?39172.7665209144… read more
32dmadden
32dmadden
Owner Emergancy Auto Service
Associate Degree
1,207 satisfied customers
97 Ford Probe: SE...slave cylinder, nothing..clutch master cylinder
I have a 97 Ford Probe SE. Over the course of the last month I have been having more and more trouble getting the car to go into gear until it finally just won't go at all. I replaced the slave cylind… read more
Marc
Marc
fleet supervisor
Vocational, Technical or Trade Scho
1,140 satisfied customers
1993 toyota: clutch..RPM..wouldnt start..the spark plugs, or timming
I have 1993 toyota 5 speed, while I was going down hill I pushed in the clutch to come to a stop, I watched the RPM's drop all the way down and the truck died. I rolled it through the the stop and pul… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
my van runs hot..highway speed.i,ve..thermostat & the fan clutch.what
my van runs hot only when i turn on my air conditioner at highway speed.i,ve changed the thermostat & the fan clutch.what could be the problem?… read more
Wydranator
Wydranator
Retired Corrections officer
High School or GED
36 satisfied customers
1997 Ford Taurus: 000 miles..the clutch bearings (it..serpentine belt
My daughter's 1997 Ford Taurus is making noises from the ac compressor, she is away at college, her local Ford dealer wants $800 to repair it and since it has 151,000 miles on it I want to replace the… read more
Don - Mo Lurch
Don - Mo Lurch
Owner
Vocational, Technical or Trade Scho
10,833 satisfied customers
1996 Ford Mustang: an extremely loud noise when I let off the clutch
I have a 1996 Ford Mustang. It has a 5 speed manual transmission. I had a situation where the car would make an extremely loud noise when I let off the clutch. I could not put the car in gear at all. … read more
GearHead1
GearHead1
Prototype technician
Vocational, Technical or Trade Scho
34 satisfied customers
/C clutch engages and disengages within 30 seconds...loud..bearing
A/C clutch engages and disengages within 30 seconds. Sounds loud. Is it a bad clutch or just a bearing? How do I use the tool to remove the hub. 1996 Chevy S-10, 4.3l Optional Information: 1996 Chevro… read more
Steve
Steve
Service Manager/ Technician
5,473 satisfied customers
2000 ford: 5.4 superduty with air..loud..bearing..cab
2000 ford box truck 5.4 superduty with air. At high rpm there is a very loud screaming or bearing noise down near pasangers feet or floor in cab, no noise outside and noise is gone when serpintine bel… read more
Davo
Davo
Master Auto Tech/manager of auto shop
Vocational, Technical or Trade Scho
1,644 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Excellent reply, and also very quick. Really sounds like the Expert knows what he is talking about. I will be back to use your service when I need more help with my RV.

DutchUSA

< Previous | Next >

Meet the Experts:

Chris (aka-Moose)

Chris (aka-Moose)

Technician

1,449 satisfied customers

16 years of experience

Ted G.

Ted G.

ASE Certified Technician

1,769 satisfied customers

20 years auto repair experience, ASE Master Tech, Mechanical Failure consultant, Expert Witness

George H.

George H.

ASE Certified Technician

1,570 satisfied customers

ASE Master Tech 15+ yrs, AAS Automotive Technology, Factory trained Asian specialist

GM Tech (Cam)

GM Tech (Cam)

Auto Service Tech

682 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Amedee

Amedee

Former ASE Master Tech

2,597 satisfied customers

ASE certified tech advanced level specialist. Wisconsin certified emissions state inspector

Jerry

Jerry

Master Mechanic

2,181 satisfied customers

ASE master, 30+ years. All makes and models. Trouble shooter, shop forman, service manager

Richard

Richard

ASE Certified Technician

1,017 satisfied customers

12 years Ford Lincoln/Mercury Jaguar dealership as a technician and shop foreman reparing all makes

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x