How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask supertech Your Own Question
supertech
supertech, mastertech
Category: Car
Satisfied Customers: 2251
Experience:  ase master auto tech,triple chrys master tech,42 yr experinece,adv. level spec. ASE. HEV chrys spec.
9510839
Type Your Car Question Here...
supertech is online now
A new question is answered every 9 seconds

No Comment Added

Customer Question

No Comment Added
Submitted: 9 years ago.
Category: Car
Expert:  supertech replied 9 years ago.

Hi my name is John.

What size engine do you have?

Customer: replied 9 years ago.
Reply to supertech's Post: 3.4
Expert:  supertech replied 9 years ago.

graphic

  1. Before servicing the fuel pump the fuel system pressure must be relieved.
  2. Disconnect the negative battery cable.
  3. Raise the car on a hoist.
  4. Remove the fuel tank.
  5. Remove the fuel tank sending unit and pump assembly by turning the cam lock ring counterclockwise. Lift assembly from the fuel tank
  6. Pull the fuel pump up into the attaching hose while pulling outward away from the bottom support. Take care to prevent damage to the rubber insulator and strainer during removal. After the pump assembly is clear of the bottom support, pull the pump assembly out of the rubber connector for removal.

NOTE: Inspect the fuel pump attaching hose for any signs of deterioration. Also check the rubber sound insulator at the bottom of the pump. Replace damaged or deteriorated parts

INSTALLATION:

  1. Push the fuel pump assembly into the attaching hose.
  2. Position the fuel tank sending unit and pump assembly into the fuel tank Use a new "O" ring seal.

NOTE: Care should be taken not to fold over or twist the strainer when installing the sending unit as this will restrict the flow of fuel. Also, verify that the strainer does not block the full travel of the float arm.

  1. Install cam lock over the assembly and lock by turning clockwise.
  2. Reinstall fuel tank

Let me know if you need more.

Please push the accept button when were done.

Thank you for choosing just answer.