How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mike V. Your Own Question
Mike V.
Mike V., Auto Service Technician
Category: Car
Satisfied Customers: 25677
Experience:  25 years of experience, Certified Subaru Technician and Nissan factory trained.
Type Your Car Question Here...
Mike V. is online now
A new question is answered every 9 seconds

92 honda civic: change the brake power booster..with 1.5 and automatic

Resolved Question:

what all do i need to change the brake power booster on a 92 honda civic with 1.5 and automatic
Submitted: 9 years ago.
Category: Car
Expert:  Mike V. replied 9 years ago.

Hi there! If you are looking for the sizes, I believe the four nuts behind the dash are 14mm. The brake lines off the master cylinder are 10mm.The bolts that hold the master to the booster are 12mm.You have to get under the dash and unhook the four nuts and the brake pedal.When you reinstall the master cylinder,make sure you do not change the length of the push rod.Her is some more info.Hope it helps!Thanks

  1. Disconnect the vacuum hose from the booster.

  2. Disconnect the brake lines from the master cylinder.

  3. Remove the brake pedal-to-booster link pin and the booster-to-fire wall nuts. The pushrod and nuts are located inside the vehicle on the driver's side, under the dash.

  4. Remove the booster with the master cylinder attached.

  5. Install the booster in position and tighten the mounting nuts to 9 ft. lbs. (13 Nm).

  6. Connect the vacuum hose to the booster and the fluid lines to the master cylinder. Tighten the fluid lines to 14 ft. lbs. (19 Nm).

  7. Bleed the brake system.

Mike V. and 2 other Car Specialists are ready to help you