How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Randall C Your Own Question
Randall C
Randall C, ASE Master Tech
Category: Cadillac
Satisfied Customers: 12890
Experience:  ASE Master Tech, 32 years exp,Cadillac 6 yrs
13677702
Type Your Cadillac Question Here...
Randall C is online now
A new question is answered every 9 seconds

Cadillac Deville Must replace the left front side marker light.

This answer was rated:

Must replace the left front side marker light. Need bulb id and r & r procedure. 2004 DeVille
Hello, I am unsure of bulb # XXXXX I think it is a standar 194 bulb. Once you have it out, the # XXXXX be on the bulb. The headlamp removal is below to access that bulb


EADLAMP REPLACEMENT

REMOVAL PROCEDURE
  1. Open the hood.
  2. Remove the upper filler panel.


  1. Remove the bolts (2) retaining the headlamp to the headlamp mounting bracket.


  1. Remove the bolt retaining the headlamp to the lower rail.


  1. Pull the headlamp forward and rotate upward order to disengage the nylon grommet at the outboard edge of the headlamp. A firm pull may be required.
  2. Disconnect the headlamp connector.
  3. Remove the headlamp from the vehicle.

INSTALLATION PROCEDURE

  1. Connect the headlamp electrical connector.

IMPORTANT: Do not push too hard while connecting the electrical connector or you could push the connector through the headlamp housing.


  1. Place the headlamp over the lower rail stud.


  1. Position the outboard portion of the headlamp in order to align the nylon grommet with the headlamp mounting bracket.
  2. Press the headlamp rearward in order to engage the nylon grommet with the headlamp mounting bracket.


  1. Install the bolt that retains the headlamp to the headlamp mounting bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the mounting bolt to 6 N.m (53 lb in) .


  1. Install the bolts (2) that retain the headlamp to the headlamp mounting bracket.

Tighten
Tighten the headlamp mounting bolts to 6 N.m (53 lb in) .

  1. Install the upper filler panel.
  2. Close the hood.
REMOVAL PROCEDURE
  1. Remove the headlamp.


  1. Remove the park/turn signal bulb cover.


  1. Remove the socket and the bulb from the headlamp assembly.
  2. Remove the bulb from the socket.

INSTALLATION PROCEDURE


  1. Install the bulb to the socket.
  2. Install the socket with the bulb to the headlamp assembly.


  1. Install the park/turn signal bulb cover.
  2. Install the headlamp assembly.



 

Randall C and other Cadillac Specialists are ready to help you