Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I got a free 25n motor that is about 15-20 years old. I am
Hey there. I got a free 25n motor that is about 15-20 years old. I am trying to get it running. I'm just wondering if there are some resources you might point me to. I have the service manual. I am pr… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I changed out a original mercury stator on a 1989 80 hp 3
I changed out a original mercury stator on a 1989 80 hp 3 cylinder 2 stroke with what they recommended to me as the Sierra 18-570. The new red Sierra stator is only a 4 wire where as the mercury was a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,689 satisfied customers
Poor water flow out the port side exhaust. I already
Poor water flow out the port side exhaust. I already replaced risers and checked water pump. All good. Shutter is missing on port side so the old shutter might be lodged in the exhaust. Not sure how t… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,689 satisfied customers
Just replaced cylinder heads on 5.7 mercruiser (chev 350)
Just replaced cylinder heads on 5.7 mercruiser (chev 350) … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,689 satisfied customers
I have the Bomar stainless steel port lights on my '99 Sea
I have the Bomar stainless steel port lights on my '99 Sea Ray 270 Sundancer. I have noticed leaks from the port lights so planning to re-bed them. As far as I understand I unscrew them and clean up a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,689 satisfied customers
25 horse,bought in 2000, will only run with choke pulled
Johnson 25 horse,bought in 2000, will only run with choke pulled half way out and at half throttle. Suggestion as to what I should try to do to get it to run normally. Thanks… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I removed the middle vent plug on my omc cobra lower end and
I removed the middle vent plug on my omc cobra lower end and now it wont go back in. It seems the plug/screw is too big. Is it possible the sleeve it screws into fell into my lower end?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I replaced the powerhead to adapter plate gasket but Im having
I replaced the powerhead to adapter plate gasket but I'm having problems with exhaust gases leaking into adjacent water area (port side). This causes that side to be hotter than other side and causes … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Greetings, I am working on a 1989 Mercruiser Alpha One with
Greetings, I am working on a 1989 Mercruiser Alpha One with 5.7 GM. I would like to convert the stock thermostat housing which has 6 ports and sets quite high on the intake manifold, to the newer, low… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1998 3.0 Mercruiser. I had to take the exhaust manifold
I have a 1998 3.0 Mercruiser. I had to take the exhaust manifold off to have the drain rethreaded. Now the replacement gasket I got as the correct one has all the correct holes but they are smaller th… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1988 Mercruiser 3.7LX. I just replaced the exhaust manifold
1988 Mercruiser 3.7LX. I just replaced the exhaust manifold and exhaust elbow. the elbow came with one gasket (two holes for water) that fits between the elbow and the manifold. I have seen somewhere … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,689 satisfied customers
I own a 1974 mercury 200 outboard motor and I am having troubles
I own a 1974 mercury 200 outboard motor and I am having troubles getting it started. I've narrowed it down to the carburetor by process of elimination. The carburetor is getting fuel through the fuel … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hi working on a 2010 gm replacement engine to repower my old
Hi working on a 2010 gm replacement engine to repower my old mercruiser 3.0l 140 HP. The old engine is from 1989. As a part of the repower I am replacing the exhaust manifold. The Old manifold has ben… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Have a 1972 Evinrude 6hp Fisherman 6202D. Just installed retro
Have a 1972 Evinrude 6hp Fisherman 6202D. Just installed retro fit water pump kit #0763758. Does not seem to pump water ie. no water flow out of "tell tale exhaust port". Put pump in bucket of water, … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1997 Cobalt 200 with 5 l Volvo Pentadrive. Power went out,
1997 Cobalt 200 with 5 l Volvo Pentadrive. Power went out, got too cold on lift, and port exhaust manifold has a crack. Stbd manifold may have on, but only a drip - drip - drip. Can I run it to the de… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I recently purchased an 87 Wellcraft 17 boat with a 3.0 liter
I recently purchased an '87 Wellcraft 17' boat with a 3.0 liter engine and a Mercruiser Alpha drive. It would not shift into reverse, so I took the sterndrive off and discovered a piece of a U-joint t… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I need to replace the thermostat on a volvo penta 5.7GXI.
I need to replace the thermostat on a volvo penta 5.7GXI. In looking at the circulation pump, I removed the long bolt on top that attached the single looped bracket. I then removed the bolt at the bas… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have recently lenghtened my 2000 Optimax 225 from an xl
I have recently lenghtened my "2000" Optimax 225 from an xl from 25" to a 30" shafts. I have test run the engine and now observe water coming out from what apear to be telltale ports in the drive shaf… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

23,689 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x