Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I pull my lower end to change the water pump. It is my first
Hi Jason I pull my lower end to change the water pump. It is my first time pulling it and the pump was on for at least 10 years and finally stopped pumping. I couldn't get off the impeller and was pry… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a riptide 112# thrust with ipilot.. the greenlight is
I have a riptide 112# ***** with ipilot.. the greenlight is on. I'm able to steer the trolling motor, but mtor will not come one. The propeller symbol is on for about 10 seconds on remote. Whats going… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I just got a new lower unit for my 2003 Riptide. It does not
hello, I just got a new lower unit for my 2003 Riptide. It does not have the yellow and white wires that come from the controller. Can I still use it? … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a bad vibration and knocking when I put boat in
I have a bad vibration and knocking when I put boat in drive. Hit a stump in water after that is when it started this.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Have a 2000 omc/Johnson outboard 70 hp. Pulled hairpin from
Have a 2000 omc/Johnson outboard 70 hp. Pulled hairpin from shift linkage, disconnected shift linkage , pushed shift "L" bar in and disconnected shift shaft to lower unit. Removed lower unit and insta… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Problems with my outboard. Running her today and heard a loud
Problems with my outboard. Running her today and heard a loud pop. Engine started vibrating. Limped back to boat ramp. Not sure if it is the prop hub or possibly lower unit. Doing some research now.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My Yamaha outboard F4 LMHA motor goes into reverse fine, but
My Yamaha outboard F4 LMHA motor goes into reverse fine, but would not latch in place which causes the propeller to kick up. What can I do to fix this?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a new 2011 Mercury 60 HP non Big foot and replaced
I have a new 2011 Mercury 60 HP non Big foot and replaced the shear hub recently. Now there is a noise when motor in neutral but no noise when in gear. can you help… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Our 2011, 9.9 mercury on our sailboat raises up (out of water
Our 2011, 9.9 mercury on our sailboat raises up (out of water and into a tilt) when we put it in reverse using even the slightest acceleration. Something is not holding it down in reverse. Please advi… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Im fairly positive that the prop shaft is bent. I can see
I'm fairly positive that the prop shaft is bent. I can see that the end of the shaft is rotating in an oblong pattern and I am getting water in the lower unit. I assume that the seals are bad because … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
i just changed the impeller in my outdrive(alpha 1) now when
i just changed the impeller in my outdrive(alpha 1) now when i am putting the lower unit back on the prop is just spinning what do I need to do to get it to stay in gear? I took it off in gear I figur… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
How do I lift the engine block on a 1968 Mercury 65hp outbaord.
How do I lift the engine block on a 1968 Mercury 65hp outbaord. The upper shift shat dislodged and is jammed between the block and carburetor. (Replacing water pump impeller.)… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1972 Evinrude 65hp motor that Ijust got with a boat.
I have a 1972 Evinrude 65hp motor that Ijust got with a boat. The boat was setting for about 4 years unused. I removed the shroud off the motor and mie have built a nest inside the cover covering the … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 200d riptide transom Mouunt RT forty s. I received
I have a 200d riptide transom Mouunt RT forty s. I received a seal kit which does not seem to match the original.. The stainles seal which butts up to the pin is the same but the next black seal is no… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi, I am having cooling problems on an evinrude 65HP 3cyl outboar
Hi, I am having cooling problems on an evinrude 65HP 3cyl outboard engine. I have removed the lower unit. Turned the shaft with a drill and the water shoots up via the waterpump housing. Then connect … read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
I have a 1979 mariner 70 hp outboard. It shifts great with
I have a 1979 mariner 70 hp outboard. It shifts great with the muffs on but will not shift into reverse once it is submerged in the water. The cables are new and adjusted properly, the idle is below 9… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 1998 yamaha outboard on my sailboat. I can tilt it
I have a 1998 yamaha outboard on my sailboat. I can tilt it up and down but can't get it to lock? I see the back locking mach. but it doesn't go over the adjusting bar to keep the motor from popping u… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
how to replace water pump(impeller) on mercury force 40 hp
how to replace water pump(impeller) on mercury force 40 hp serial # XXXXX 1998 40 ELPT 5250 MAX RPM 40 187 30 85 CE 97… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

9,103 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x