Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 3 cyl kubota b1550 in my boat.I went out last week
I have a 3 cyl kubota b1550 in my boat.I went out last week all went well the next day it would not start. There is compression fuel pumps all the way to the injectors at the head.The motor starts wit… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
2013 mercury 60 hp efi big foot. Used the boat a few weeks
2013 mercury 60 hp efi big foot. Used the boat a few weeks ago ran like top as usual, Today ran the boat and had a loss of power got back to the dock and started trouble shooting. first was checking t… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Honda 5 HP outboard motor ( a few years old but always
Honda 5 HP outboard motor ( a few years old but always repaired at a good shop), I start the outboard motor and let it warm-up for 5 or so minutes while I removes lines and load the sailboat. Then go … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Second opinion] 70 hp 1989 even rude runs perfect at all rev
Second opinion] 70 hp 1989 even rude runs perfect at all rev ranges for about 15 mins of full throttle then breaks down to mainly 2 cylinders with intermittent surges have fitted new fuel filter and s… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Evenrude. 55 hp 55975: I have a 79. 55 hp outboard with a broken
I have a 79. 55 hp outboard with a broken gear in the lower unit. I took all the mounting bolts out (6). The lower unit is stuck on the splines. Is there something I can di too get it to release.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
have a new 540 blower motor, Whipple 4.0,MSD ignition. My problem
have a new 540 blower motor, Whipple 4.0,MSD ignition. My problem is engine reduction mode cuts in at 3000 RPM. What are some of the causes of this? Had this problem late last summer but it seemed to … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2013 40 hp ETic E40DTLABA with .3 hours , and the
I have a 2013 40 hp ETic E40DTLABA with .3 hours , and the motor runs rough and skips above idle. After 15 minutes the motor reverts to the safe mode and seems to be running on one cylinder. I have ha… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2001 Optimax 225 hp, that has developed a problem
I have a 2001 Optimax 225 hp, that has developed a problem of speed/rpm control after 3500 rpm when the engine has been running for 15 minutes or comes up to running temperature. When the engine is co… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I am looking to re power my 21 foot center console. The boat
I am looking to re power my 21 foot center console. The boat is rated for 250 hp. I have a 125 hp force now and am looking at 1995 Johnson 225 hp and 1996 mercury 200 hp. The price includes removing o… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
i have a 04 90 hp johnson outboard fuel inj. seems after it
i have a 04 90 hp johnson outboard fuel inj. seems after it sits for a while 5-6 weeks it will start and fills like its running on 2 cilenders then after it runs a bit it cleans it self out and runs g… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 150 hp Johnson outboard that starts every time but
I have a 150 hp Johnson outboard that starts every time but recently and suddenly I am unable to accelerate above idle because the engine gets rough and dies. It is a 6 carb 2 cycle engine part number… read more
MRYZ450F
MRYZ450F
74 satisfied customers
I have an old 50 hp merc 500 with thunderbolt ignition. 4 cylinder.
I have an old 50 hp merc 500 with thunderbolt ignition. 4 cylinder. It starts and runs fine with the muffs on ( out of water ) but when in the water it bogs down and dies as soon as I put it in gear. … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2006 evinrude etech 90 hp motor on my boat. while
I have a 2006 evinrude etech 90 hp motor on my boat. while coming back in one day, the motor died. found the compression in cylinders 1 and 3, 120PSI., and cylinder #2 at 15PSI. From what I can see th… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
hello, I have a 1990 50 hp johnson motor that has just started
hello, I have a 1990 50 hp johnson motor that has just started giving me problems. earlier today I went out on the lake and every thing worked fine I came in and went to another lake (5 minutes away) … read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 1988 Evinrude 200 hp motor. Looking to see what the
I have a 1988 Evinrude 200 hp motor. Looking to see what the comperssion needs to be for a good motor. I have all 5 at 90 psi and one at 80 psi. Please let me know. I have had some tell me this motor … read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
Our outboard motor is a 1992 Johnson 175 hp on a 20 ft center
Our outboard motor is a 1992 Johnson 175 hp on a 20 ft center console. The motor runs ok in idle or slow speed but when we accelerate it stalls out. Usually it will restart but sometimes not. Please h… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
motor started to miss bad did compression check #1 cyclinder
have a 1978 johnson 115 hp.motor started to miss bad did compression check #1 cyclinder is at 10 psi rest are 92-95 psi.ok pulled head off #1 cyclinder is all black & so is piston.#3 looks good nice a… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
1986 Cajun Boat with 150 HP Evinrude OB Jerry Fox Derby
1986 Cajun Boat with 150 HP Evinrude OB Jerry Fox Derby Kansas XXX-XXX-XXXX Purchased January 2007 Ran in the drive way with Muffs and idled OK, a little rough at about 800-900 RPM Memorial Day Weeken… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x