Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2005 115 Yamaha outboard motor with low compression & oil
Second Opinion] 2005 115 Yamaha outboard motor with low compression & oil coming out of the Idle tube … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,949 satisfied customers
2005 115 Yamaha outboard motor with low compression & oil
Second opinion] 2005 115 Yamaha outboard motor with low compression & oil coming out of the Idle tube … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,949 satisfied customers
I, I have a 2001 50 Hp. Yamaha 2 stroke. I idles fine and
I have a 2001 50 Hp. Yamaha 2 stroke. I idles fine and cranks with ease. On the hose I can run it up to full RPM, but in the water (under a load) it will " bog down". For while it would bog a little and then pick up an run normal. Over time it has progressed to the point now that it will not pick up at all. I can still manually run up the RPM on the throttle in neutral. I have change the fuel tank,, hose, fuel pump, plugs and pulled the top carb bowl to look for trash or gunk. Clean as a whistle. The local shop says they have never sold a power pack for this model. Where do I go from here? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
30hp 2 stroke yamaha motor only reaches half throttle under
30hp 2 stroke yamaha motor only reaches half throttle under load runs rough sluggish not crisp … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 98 Mercruiser 90 outboard 3 cylinder. When I apply
I have a 98 Mercruiser 90 outboard 3 cylinder. When I apply full throttle starting out,the RPMs go right up to 4000 RPMs and in approx. 3 to 4 seconds the motor falls off to approx. 3000 RPMs. I check… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2002 5.0 mercruser with TBI having some issues. the
Hello, I have a 2002 5.0 mercruser with TBI having some issues. the boat starts and idles fine, however when opening up to full throttle from a dead start the motor has some hesitation, it will bog sl… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 75 hp 4 stroke outboard motor, just this week, as
i have a 75 hp 4 stroke outboard motor, just this week, as the weather gets colder, my motor runs hesitantly for a while then runs ok after 20 minutes, however, on the way back, it could only run from… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
James, I have a 4.3 GL volvo penta that emits a popping
Hello James, I have a 4.3 GL volvo penta that emits a popping sound at high rpm. Another way to reproduce misfiring at 4000 rpm is to turn on the exhaust blower or lights, which causes the engine to l… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My 2002 Yamaha 60 hp. outboard runs for approx.15 minutes under
My 2002 Yamaha 60 hp. outboard runs for approx.15 minutes under moderate load and then the motor shudders and the prop slows down (it feels like I have rope around the propeller) and I notice the prim… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1986 yamaha v4 115 hp outboard motor on a 18 hurricain
I have a 1986 yamaha v4 115 hp outboard motor on a 18' hurricain deck boat. The thing starts rite up every time but under load it starts to buck around 3500 rpm. The more load that's on it the more it… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,665 satisfied customers
After replacing all four injectors on my 115 outboard motor
After replacing all four injectors on my 115 outboard motor the engine ran well for about one hour and then went back to running very poorly and will only rev to 2500 rpm. It sounds like fuel starvati… read more
marinedoc
marinedoc
Lead Technician
Vocational, Technical or Trade Scho
73 satisfied customers
My 90 yamaha outboard motor runs fine until 4000 rpms. At
My 90 yamaha outboard motor runs fine until 4000 rpms. At 4000 rpms it will run about 300 yards and then loses power. You can back off of the throtle and run at 3500 rpms and never miss a lick. The bu… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2008 Yamaha f50 outboard with less than 20 hours on
I have a 2008 Yamaha f50 outboard with less than 20 hours on it. It's mounted on a 17ft Carolina Skiff. It will not reach full throttle and the boat will not reach plane. My local marine repair shop c… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I am planing to buy a used 250 E-Tec (100hours) 3 years old
I am planing to buy a used 250 E-Tec (100hours) 3 years old for a 28 ft stepped hull rib boat. Is it durable enough compared with Yamaha and Suzuki? Should I expect higher consumption than the four st… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
i might be buying a 2001, 18ft sea pro with a 115 yamaha. the
i might be buying a 2001, 18ft sea pro with a 115 yamaha. the boat has'ent been used since 2005. the outboard only has 188 hours is there anything i should know about this motor and before i take it f… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
my yamaha 115 outboard boggs very badly comming out of the
my yamaha 115 outboard boggs very badly comming out of the hole and takes forever to plane ... once it planes it does not seem to run at full revs. Is there a simple way to tell if it is running on al… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have a 1999 Yamaha 200 hp outboard. Starts and idles fine,
I have a 1999 Yamaha 200 hp outboard. Starts and idles fine, but will only run on a plane for a couple of minutes before it dies. When it dies, it just dies, no hesitation no miss nothing. It will res… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
cannot get the motor to turn enough rpms. Evinrude ...
cannot get the motor to turn enough rpm''s. Evinrude 115 HP. could it be spark plug wires?… read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x