Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2006 Mag 350 MPI in a Monterey 270 cr. Idle is ok
Hi Jason. I have a 2006 Mag 350 MPI in a Monterey 270 cr. Idle is ok and runs up to 2000RPM fine, just above it splutters, give it more throttle and it pushes passed to 2800, then runs up to 4500 and … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My throttle position sensor alarm came on. my one engine
my throttle position sensor alarm came on . my one engine shut down … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2007 mercruiser 496 mag ho. The the port reservoir
Hello. I have a 2007 mercruiser 496 mag ho. The the port reservoir keeps filling up with water and overflowing from the cap. Could it be my heat exchanger or my hot water heater. I'm not sure how to d… read more
DAVID BALLARD
DAVID BALLARD
OWNER
Vocational, Technical or Trade School
10 satisfied customers
Are you available to give advice? Electrical problem.
Electrical problem. Accidentally hooked / crossed the 2nd battery wires for a brief moment. Realized it after T … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have Mercury 350 Verados and the port motor is stuck in
I have Mercury 350 Verados and the port motor is stuck in gear (forward) and will not start. Motor turns over, with prop spinning, but will not go into neutral. Motor was shut down in gear because rec… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2008 496 mag with a B1 that i got stuck on a
Hi, i have a 2008 496 mag with a B1 that i got stuck on a sand/mud bar today and now it has a constant warning beep and very reduced power. i turned off and started it again and no beep until i got on… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I'm looking to re-power 1998 502MPI to New 8.2L HO in a 40
I'm looking to re-power 1998 502MPI to New 8.2L HO in a 40 ft. Formula.. any comments would be helpful.. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I just purchased a Sea Ray 390 Sundance which has two
I just purchased a Sea Ray 390 Sundance which has two mericursers 496 Horizon 8.1 engines. I bought the boat out of state and had it shipped to Pittsburgh. I had a complete survey both in and out of w… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I have an 06 mercruiser 496 mag with only 140 hours. Running
I have an 06 mercruiser 496 mag with only 140 hours. Running fine and then I started getting a constant beep when idling in no wake zone. Oil pressure, temp, ans fluid levels are ok. Wouldn't quit unt… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,980 satisfied customers
Im in the process of installing a brand new Vessel View 7 screen
Im in the process of installing a brand new Vessel View 7 screen and a pair of 2014 Verado 300s, and I'm keeping the existing harnesses from the 2006 Verado 275 package. When I disconnected the wiring… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a pair of 496 Mags, (HOs) in my boat, I think teyre
I have a pair of 496 Mags, (HO's) in my boat, I think tey're 2007 vintage. Last night I was running at cruise speed for aboue 30 minutes, and once I slowed down, I noticed a 2 short beep warning, abou… read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
I have 2008 Rinker 350cruiser, equipped with two Mercruiser
I have 2008 Rinker 350cruiser, equipped with two Mercruiser 496 MAG SEACORE DTS B3 375 Engines. Both have about 125 hours of use. I am experiencing rough running and low rpm readings with the starboar… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2005 regal with twin mercruiser 496 mag 8.1 engines...
I have a 2005 regal with twin mercruiser 496 mag 8.1 engines... After running for about 30 minutes. The starboard engine start to cut out. It RPM eventually starts to swing you and down wildly. After … read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,980 satisfied customers
I am looking for answers for two fault codes on my system view. First
I am looking for answers for two fault codes on my system view. First one is can2 fault 16 And the other is dts fault 22 Regards XXXXX XXXXX… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2007 33 formula boat with twin 496 mags. They have
I have a 2007 33 formula boat with twin 496 mags. They have only 215hrs. The boat stay on a lift hooked to shorepower and a battery charger. 3 weeks ago the port engine did not want to start. It seeme… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2005 Regal 2665 with a 8.1 Merc 496 MAG engine. I
I have a 2005 Regal 2665 with a 8.1 Merc 496 MAG engine. I have recently replaced my oil and have been getting a warning alarm (2 beeps every min) can you please tell me if this is related to my oil c… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
i have a 06 baja 23 outlaw with a 375 hp 496 engine. i keep
i have a 06 baja 23 outlaw with a 375 hp 496 engine. i keep it dry stored and i just put in the water for the first time since winterization. i went to trim down the motor and it sounded a little slug… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have 2 Mercruisers 496 mag 375 hsp. (2007). the starboard
I have 2 Mercruisers 496 mag 375 hsp. (2007). the starboard engine stalled and will not start. i changed 2 filters but I can not locate a fuel/water seperator. Is there one on this engine? if not do I… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x