Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Had a rebuilt lower unit installed on my 1999 225 Mercury
Had a rebuilt lower unit installed on my 1999 225 Mercury Outboard and now it overheats when idling, what would cause this? … read more
Tyler
Tyler
108 satisfied customers
False overheating light and buzzer going into limp mode at
False overheating light and buzzer going into limp mode at speeds above 3000 rpm . I replaced impeller last year and just replaced the thermostats. Water pressure is 7 lbs at idle and 20 at speed. I c… read more
CalebA820
CalebA820
Technician
Marine technology
22 satisfied customers
False overheating light and buzzer going into limp mode at
False overheating light and buzzer going into limp mode at speeds above 3000 rpm . I replaced impeller last year and just replaced the thermostats. Water pressure is 7 lbs at idle and 20 at speed. I c… read more
CalebA820
CalebA820
Technician
Marine technology
22 satisfied customers
I've been trying to diagnose an overheating problem. It's a
I've been trying to diagnose an overheating problem. It's a mericruiser 4.3lx 1993. Serial number 0d853277. Impeller has been changed, oil cooler passage is checked and it's clear. Risers and manifold… read more
Yachtwork
Yachtwork
2,990 satisfied customers
I asked you a question a couple weeks back about the
Hello Charles, I asked you a question a couple weeks back about the operating temps of my 2005 150xr6. You helped me narrow down that the exhaust tuner was loose and that was probably causing my eleva… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Boat is run in salt water only.........impeller is less than
Boat is run in salt water only.........impeller is less than year old. two days ago, i lowered boat into the water and started the boat. While it was idling, i ran into the house to get something - i … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
The temperature in my boat is a 140 when idling and cruising
The temperature in my boat is a 140 when idling and cruising at about 2000 rpm. If I go higher starts going up at about 3000 it goes to 175 and 180 if I continue at same, rpm. I lower and slowly goes … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have an overheating problem on my 260 mercruiser engine.
I have an overheating problem on my 260 mercruiser engine. The engine stays oround 140-150 degrees while trolling but when I run the rpm's up to go somewhere it will climb to around 180 degreese but a… read more
Jason
Jason
Marine Mechanic
24,193 satisfied customers
i own a 1986 boat that has a 120 hp i/o mercruiser. i just
i own a 1986 boat that has a 120 hp i/o mercruiser. i just bought this unit. it appears to have been well maintained. the seller showed me repair reciepts that included a new impellar. took the boat o… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have a perkins 4-108. at 2000 rpm the sailboat runs at 6
i have a perkins 4-108. at 2000 rpm the sailboat runs at 6 knots and 180 degrees. if i increase the rpm to 2300 (max at full throttle) the boat hits 6.3-6.5 knots but the temp jumps to over 200 degree… read more
Yachtwork
Yachtwork
2,990 satisfied customers
I have a 2001 Mercury 250XL EFI motor on my 26 angler panga
I have a 2001 Mercury 250XL EFI motor on my 26' angler panga boat...I'm running a 19P Rev 4 prop...going out in the morning I'm turning 5800 to 6000 rpm depending on trim setting....on the way back in… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
1989 Mercruser 5.7 L V-8, Alpha one drive. Engine starts to
1989 Mercruser 5.7 L V-8, Alpha one drive. Engine starts to overheat when pushing RPMS 3800 & above. It creeps slowly from 146 to 180 degrees or more. As soon as I back off the throttle it comes down … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
hi, i have an aqad31a,my tempreture gauge is staying around
hi, i have an aqad31a,my tempreture gauge is staying around 150 when im steaming around and then when i slow down it goes up to about 200+ and then slowly comes back down to 150 again,ive changed my t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Just fitted a mates prop to my mercruiser 3ltr with alpha 1
Just fitted a mates prop to my mercruiser 3ltr with alpha 1 leg 21 p engine over heats at certian revs very quickly then just as quick goes back to normal temp took his prop off and put my origanel ba… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
2004 had a new 350 mercruiser installed in 1980 boat always
2004 had a new 350 mercruiser installed in 1980 boat always ran at 180 heated up to 220 upon stopping told by installer of motor that it was normal. This year heated up to 200 would not cool down, sho… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
My Mercury Optimax 150 slowly heats up and eventually overheats
My Mercury Optimax 150 slowly heats up and eventually overheats even while running at 1000 to 2000 rpm, but only when in gear. When I go back to neutral, the temperature will drop 30 degrees F in less… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
88 Mercruiser 5.7, w Alpha 1. Gets too warm, 200 degrees indicated.
88 Mercruiser 5.7, w Alpha 1. Gets too warm, 200 degrees indicated. Found perforated outdrive to transom hose, fixed it. Still over 180 degrees. Found ruined impeller and melted water tube, rebuilt st… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
I have a 1987 mercruiser alpha-one V-6 185 on a Wellcraft.
I have a 1987 mercruiser alpha-one V-6 185 on a Wellcraft. I can not get the temprature to raise above 120 deg. even after it runs for over 30minutes. I replaced the temp gauge and sender with an elec… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

10,059 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,193 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

3,046 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x