Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Need to know where the hoses go from the thermal air control
Need to know where the hoses go from the thermal air control valve on my 1995 200hp XR6 Outboard … read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,921 satisfied customers
I have a locked up lower unit I want to replace. I need to
I have a locked up lower unit I want to replace. I need to know what to buy. Mercury 150 xr6 nitro series. Serial number 0T947302. No I don't know the gear ratio and the unit is so locked up I can't p… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Want to locate the thermostat on an xr6 150 mercury, please
Second opinion] want to locate the thermostat on an xr6 150 mercury , please ..… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
My oil injection stops pumping from time to time on my
My oil injection stops pumping from time to time on my Mercury XR6 150 Jet outboard … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
2007 Mercury v6 optimal inboard jet driven on a 07 sugar
2007 Mercury v6 optimal inboard jet driven on a 07 sugar sand boat. Engine gets up to speed for a few minutes then starts bogging down from 50mph to 40 mph. It then will kick in to 50 then back down t… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a mercury 2002 xl swb, it is not firing on cylinders
I have a mercury 2002 xl swb , it is not firing on cylinders 3&6 sparkplug coil and main electrical box check out O.K . someone told me it might be the battery is not supplying enough power … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 1995 Bayliner Jazz Jet boat with a 120HP Mercury
I have a 1995 Bayliner Jazz Jet boat with a 120HP Mercury sport jet. Not knowing how to winterize it last fall we poured some RV antifreeze into the engine thru the water intake hose and fogged the engine. When we went to flush it out. We have the Mercury hose adapter for it. We turned the hose on prior to starting the engine like I would on any outboard not to damage the impeller. The engine would not turn over and in fact would move. I took out the top two spark plugs and they looked fine. I took out the bottom two and water came out of the cylinders. Freaked me out but knew I had to get the water out of the cylinders. I did by turning the engine with out the plugs. I then coated the cylinders with fogging oil and also sprayed in the carbuator. Put the plugs back in and was able to get it started. Felt better. I learned that it had a SS impeller and that it wouldn't get damaged and that I had to start the engine first before we turned the water on as to not flood the cylinders again. We were able to start it and let it run for a while. Everything seemed normal. We went to launch it and couldn't get it started. We opened the hatch and noticed the bilge pump was running because water was coming in the bilge. It seemed that when we were trying to start it that the enging would pump water into the bilge through a small port at the bottom of the bilge. We took it out. It sat for a few weeks and I decided to try and start it again to see if we could figure it out. We got it started but didn't hook the hose up. We noticed that we were getting an exhaust gas from that port that we saw the water coming in a few weeks earlier. I didn't know if this was normal for water to be pumped in there and then the automatic bilge pump would pump it out. I has two bilge pumps. One has a automatic float switch. The other is controlled by the switch on the dash. The spark plugs look very clean and no carbon deposits on them. Is it possible this is just an old boat and needs a good tune up. We bought this last year and it has been a learning experience. Any advice would be appreciated. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2004 mercury 225 optimax that i just replaced the
I have a 2004 mercury 225 optimax that i just replaced the water pump impeller and housing and all gaskets and seals and now it wont pump any water out of the pee hole. Ive tried hooking up the hose t… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Hi Tan Dwight Nicholas here. First of all I want to thank
Hi Tan Dwight Nicholas here. First of all I want to thank you for the great advice on my 1995 Mercury XR6. I replaced the coil and found a broken wire from the switchers to the coil on the other cylin… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1978 1400 Mercury that possibly has sand in the out
I have a 1978 1400 Mercury that possibly has sand in the out drain that keeps the water that's cooling it down to a slow dribble.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
my 200hp salt water series leaking oil ,while sitting on the
my 200hp salt water series leaking oil ,while sitting on the tailor .. i fill the oil tank in the console and now it is half empty three day later ..what cause this proplem… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
What suggestions for starting a 1995 Mercury 200HP engine that
What suggestions for starting a 1995 Mercury 200HP engine that has not been run for 2-3 weeks and will not fire when attempting to start?… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
When changing the water pump on a 2005 mercury 150 xr6 do I
When changing the water pump on a 2005 mercury 150 xr6 do I leave it in forward or neutral. I've heard both. Will I need any othe stuff to complete the job other than a water pump kit? Such as silicon… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
2000 Mercury V6 200HP. Is the engine supposed to be leak small
2000 Mercury V6 200HP. Is the engine supposed to be leak small amount of (with hose to lower unit) water on the starboard side at base of motor into the cowl? Is this the bleed fitting and that is wha… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a mid 90s Mercury XR6 150. I believe the impeller has
I have a mid 90s Mercury XR6 150. I believe the impeller has gone bad in the water pump and thought I'd try to remove the lower unit and replace the impeller. No problems, I got the LU separated, exce… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
2002 200hp Mercury Saltwater: It appears that my oil pump is
2002 200hp Mercury Saltwater: It appears that my oil pump is not filling up the top oil reservoir from the big bottom one. I am thinking about mixing my gas with oil and running the boat to see if the… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I am hooking up a Mercury 200hp EFI and want to verify fuel
I am hooking up a Mercury 200hp EFI and want to verify fuel hook up. There is a very small (~1/16" diameter) brass hose hookup that is located near the fuel pump on the lower right side of the front o… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2005 Mercury Verado 200hp. When the engine is running
I have a 2005 Mercury Verado 200hp. When the engine is running there is a backfeed of water squirting out from the flush port. The higher the RPM's the stronger the discharge pressure. There is still … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x