Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1985 Gibson Houseboat with 454 crusader engines.
I have a 1985 Gibson Houseboat with 454 crusader engines. Carbs rebuilt by National Carb 2 years ago with less than 2 hours running time. The port engine initially ran fine for a few starts then it wo… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
I am looking to purchase a 2001 Sea Ray 340 with Mercruiser
I am looking to purchase a 2001 Sea Ray 340 with Mercruiser 454 mag MPI Horizon engines. I had a compression check done and the port engine showed 145-170psi and the starboard engine showed 130 - 165p… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
I have crusader 454s and the starboard engine runs fine for
I have crusader 454s and the starboard engine runs fine for about 15 minutes and then slowly looses power. My mechanic said it needed a rear transmition seal and he replaces it. The engine was longblo… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
I need to replace the two remote oil filter hoses on the
Hi. I need to replace the two remote oil filter hoses on the port engine of my boat. I have twin Crusader xl 350 engines in a 1995 Tiara 2900 Open. My problem is how in the heck to (1) Remove the old … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
I have the stalling issue referred to by ohers in one of the
i have the stalling issue referred to by ohers in one of the 454 TBI Crusaders I have in my Tiara 1996 2900 open … read more
Boat Doc
Boat Doc
253 satisfied customers
I have 1995 crusader 454 xli engines. Just checked riser
i have 1995 crusader 454 xli engines. Just checked riser temperatures on both engines. Port side engine - Both risers at 98 degrees. Starboard side engine- 1 riser at 150 degrees, the other is 130 deg… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I just compression tested a 1995 crusader 454 xl on a boat
I just compression tested a 1995 crusader 454 xl on a boat that i am buying. Reading came in from 120 dry to 125 with the exception of # 5 cylinder that read 100PSI (the next lowest was # 3 at 115). T… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
Trying to figure out if I want to buy an old boat or not :)
trying to figure out if I want to buy an old boat or not :) … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I bought an 89 Bluewater coastal cruiser with Crusader 454's
I bought an 89 Bluewater coastal cruiser with Crusader 454's 350 hp the port engine needs has poor compression and blowby. Both engines have 1830 hours on them. Removing the engine in such a cramped s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
I'm considering buying a used boat with twin XL454 crusaders
I'm considering buying a used boat with twin XL454 crusaders with 1100 hours on each. The boat has not been used much for the past couple of years. It has been maintained, and was fogged for the cold … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I have a pair of 5.7's V8 Crusaders in a boat I just had
I have a pair of 5.7's V8 Crusaders in a boat I just had surveyed. Port engine was not running the same RPM as starboard on sea trial and compression test showed 160, 155, 135, 135 115, 140, 135, 135.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have 1990 Silverton 34C with 454 crusader engines many
I have 1990 Silverton 34C with 454 crusader engines many years of great boating A problem this year is the starboard engine will not go over 2,000 RPM when running in gear. At the dock it will rev to … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Was looking guidance on my mercruiser 6.2 l serial
Hi was looking for some guidance on my mercruiser 6.2 l serial # ***** Engine runs fine but doesn't get past 3900 tons at wot Ran scan tool at idle and under power on the water at wot. Have data, but … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
I am contemplating the purchase of a 2004 Regal with Mercruiser
I am contemplating the purchase of a 2004 Regal with Mercruiser 4.3MPI engines with around 250 hours. The port engine experienced a hydrolock incident that resulted in replacement of risers, elbows an… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1996 Sea Ray Sundancer -- 7.4l efi mercruiser engines. I am
1996 Sea Ray Sundancer -- 7.4l efi mercruiser engines. I am considering buying the boat and would appreciate an independent answer for my question below. Compression test results port: 1-145lbs, 2-140… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
I am in the process of buying a 1995 Carver 355 with 454 crusaders
I am in the process of buying a 1995 Carver 355 with 454 crusaders that have 448 hrs on them. I have just had the compression chek and the oil samples anylized. I am not sure how bad is bad. Here is t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 454 crusader port engine that starts very hard when
I have a 454 crusader port engine that starts very hard when cold but no problem once it starts even if I leave it off for three or four hours. Overnight and it starts very hard with a lot of cranking… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I am looking at 31 TiarasOne with 1989 7.4L Mercs 1025 Hrs
I am looking at 31 Tiara'sOne with 1989 7.4L Merc's 1025 Hrs and another 31 Tiara with 1995 454 Xl Crusaders 815 Hrs. What will be your preference? Thank you. Stan C.… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,862 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x