Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
It won't stay started. My 1990 70hp 2 stroke has run great
My 1990 70hp johnson 2 stroke has run great until now. The boat has not run and been in storage since October 2017. I always put stabil in take and been fine before. I figured since gas was old I would replace it and fuel filter. It still doesn't stay started. It also doesn't sound right while it's running. I have to keep pushing in choke to keep it running. Checked the ball and it doesn't get completely hard. Don't see any leaks in fuel lines as well. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,282 satisfied customers
Have a 1986 140 hp outboard on our boat. We were out on the
Hello- Have a 1986 Johnson 140 hp outboard on our boat. We were out on the lake today, running about 3500 RPM when the motor just suddenly lost power and shut down. When we got it home I ran a compres… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
OK, I have a 1994 70hp outboard engine. The problem I have
OK, I have a 1994 70hp Johnson outboard engine. The problem I have is, the engine seems to run fine at high idle/speeds, when I bring it down to idle it idles for about 2 to 3 minutes and then starts … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
my 78 model 70hp Johnson outboard will not accelerate it's
my 78 model 70hp Johnson outboard will not accelerate it's as if it's running on only two of the three cylinders.could the power pacts b e bad… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1988 johnson 120 vro 4 cyl outboard. It coughs and
I have a 1988 johnson 120 vro 4 cyl outboard. It coughs and sometimes stalls at idle. It has 95 psi compression in all 4 cyl. Carbs are clean, fresh fuel, new plugs. If you pull the plug wires one by … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I just picked up a 1985 Johnson 70HP (J70TLCO) outboard engine
I just picked up a 1985 Johnson 70HP (J70TLCO) outboard engine on a 1969 Fabuglas 17 foot boat. I do not have any history on the motor. I'm not sure when the last time it was started. The last registr… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1974, 70hp Johnson. it doesNOT want to idle, BUT will
I have a 1974, 70hp Johnson. it doesNOT want to idle, BUT will idle rough at higher RPM. Goes dead when swiching forward to reverse, carbs are clean as a pin. It is on a house boat,runs for hours on e… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I just bought a johnson outboard motor, 75hp, 3 cyl. stinger.
I just bought a johnson outboard motor, 75hp, 3 cyl. stinger. 1968 to maybe 1978. Timeings been checked, rebuilt the 3 carburators. now for my problum. it runs very good untill I try to put it in trav… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Im looking at a boat, just on line at this point and it says
I'm looking at a boat, just on line at this point and it says that two cylinders have low compression. The engine is a 1977 Johnson 200hp. Will they continue to get worse?… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a boat with a 1988 Johnson 3.6GT outboard engine that
I have a boat with a 1988 Johnson 3.6GT outboard engine that I bought, that was begin used at around sea level altitude. I will be using this boat at lakes in the 6,000' - 6,500' altitude exclusively.… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have an 70hp evenrude outboard motor 1984 3 cylinder, it
I have an 70hp evenrude outboard motor 1984 3 cylinder, it runs pretty good, but whern I open it up all the way, the rpm only reads 4200 it was reading 5100, what would cause this.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1990 70HP force outboard which has served me well
I have a 1990 70HP force outboard which has served me well for 19 years. Suddenly it started stalling whenever I put it in gear. It starts fine but as soon as I drop it into gear the motor dies. Once … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1979 Johnson 115 V4 that developed a rough and slow
I have a 1979 Johnson 115 V4 that developed a rough and slow idle speed. Spark plugs looked worn out, replaced them and found no change. Compression check found 3 cylinders at 120 psi and one at 60 ps… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 2002 90 hp Johnson outboard motor... ever since my
I have a 2002 90 hp Johnson outboard motor... ever since my Canada trip last year the boat has had problems with the engine missing… it started at the higher speeds and now it happens even at idle… I … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
Looking to but a 78 16ft Imperial Bowrider with the original
Looking to but a 78 16ft Imperial Bowrider with the original 78 Johnson Stinger outboard, 75hp #75ELR78. He's rebuilt the 3 carbs but said he was unable to adjust the carbs specially the high jets, sa… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Hi. Im thinking of buying a 1989 johnson 70hp vro off an old
Hi. Im thinking of buying a 1989 johnson 70hp vro off an old man who works on outboards from his backyard. The man has recently changed three of the pistons with new ones, new water pump which pumps h… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a Johnson 60hp, 1962, 2 cycle, 3 cylinder outboard motor
I have a Johnson 60hp, 1962, 2 cycle, 3 cylinder outboard motor on my boat. I can start the boat, but cannot get top end speed. (the fastest I can go is about 10 mph. This boat usually goes about 35 m… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1978 70hp johnson that will not accelerate in the
I have a 1978 70hp johnson that will not accelerate in the water. I have fitted new fuel pump, new fuel lines, new plugs and cleaned out the carbys. engine starts no problem & idles ok, but once power… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,242 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,282 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x