Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Aloha Tan, Got a question on my starboard engine when I
Aloha Tan, Got a question on my starboard engine when I engage the transmission from idle to forward the engine dies at or around 800 rpms when I raise it to 900 and engage it will run albeit not smoo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 4.3L Mercruiser new short block and ignition, its
Customer: i have a 4.3L Mercruiser new short block and ignition, its got a holley 4160 450cfm carb on it with headers. … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1988 ski centurion with a 351. It won't start. If I
Hello. I have a 1988 ski centurion with a 351. It won't start. If I pour gas down the carb it will kinda start and stall and sometimes when I stop cranking the engine it will want to crank backwards f… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1997 Sea Ray with a 3116 Cat Diesel, and a ZF HSW
I have a 1997 Sea Ray with a 3116 Cat Diesel, and a ZF HSW 800 V1 transmission. My port engine idles at around 650 to 700 rpm's. I have no problems under load. When I throttle back to idle speed, the … read more
Cat Man
Cat Man
Vocational, Technical or Trade Scho
165 satisfied customers
I have a 2009 bayliner 3.0 Mercruiser engine when I put it
I have a 2009 bayliner 3.0 Mercruiser engine when I put it in forward gear at idle the boat shakes real bad until I give it gas the dealer I purchased it from said this is normal. I have already tuned… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
Hello, I have a 1986 triton dynasty with a 4.3 omc engine and
Hello, I have a 1986 triton dynasty with a 4.3 omc engine and omc sterndrive. Just purchaced it sept 2013 fron original owner. Did tune up and rebuilt carb because there was a water/fuel issue making … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,618 satisfied customers
I own a Cruisers Inc. Rogue 21.5 (1987) with 350 GM powerplant.I
I own a Cruisers Inc. Rogue 21.5 (1987) with 350 GM powerplant.I replaced engine 100 hrs. ago with marine repl. longblock. Have since installed Edelbrock Performer intake & carb(1409)650 cfm,MSD dist.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
my jhonson 90 vro runs well when used for a while but stops
my jhonson 90 vro runs well when used for a while but stops when put into gear often.Also what is the knob that turns that is below the key on the gear/throttle… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi, I have a 434a volvo penta v6 and when I engage drive to
Hi, I have a 434a volvo penta v6 and when I engage drive to go the rev's drop off and sometimes it cuts out unless I give it a bit more of a handful, I wonder if there is anything I can adjust to stop… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Can I change the primary jets from 66 to 64 to alleviate the
Can I change the primary jets from 66 to 64 to alleviate the motor loading up at low speed in my boat?… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
1986 - rebuilt twice, 351 inboard 4160 4 brrl holley. inconsistent
1986 - rebuilt twice, 351 inboard 4160 4 brrl holley. inconsistent idel speed. idle adjustment on lowest setting, but ususally ideling very high. Do not know if Electronic choke is working. only one v… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Tan I just put my bayliner in the water ran great but when
Tan I just put my bayliner in the water ran great but when I went to put it to idle stalls and now hard to start. But when I can get it into gear quick and power up it runs fine. But as I back off it … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1998 Bayliner 5.7L alpha one I/O Engine recent rebuild, runs
1998 Bayliner 5.7L alpha one I/O Engine recent rebuild, runs good at idle and above about 1000 RPM. Slow or normal throttle move from idle, engine runs very rough about 900 RPM it either stalls or wit… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My 280 duoprop sticks when coming out of forward gear. Reducing
My 280 duoprop sticks when coming out of forward gear. Reducing the idle speed makes it easier. Shifts smoothly when engine is not running. Slips easily into both forward and reverse, and slips out of… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,618 satisfied customers
Runs a little rough at idle 1985 Merc engine is 4 cyl 2.97L
Runs a little rough at idle 1985 Merc engine is 4 cyl 2.97L midium hrs Dwell at 32 degrees Cleveland Oh Timing at 6BTDC Idle speed 750-800 New plugs, points, condencer What can I do to smooth it out… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2008 Reinell 246 LSE with duoprop Volvo Penta outdrive.
I have a 2008 Reinell 246 LSE with duoprop Volvo Penta outdrive. When I engage drive there is an extreme loud knock (forward and reverse) and the boat jars quite a bit. Could this be a clutch dog issu… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Need an OMC Cobra expert. Shifts well when cold but dies whe
Need an OMC Cobra expert. Shifts well when cold but dies when shifting in or out of gear after a cruising run (warm engine). Replaced ESA(deletes overstroke switch)/Coil(oem equivalent)/cap/rotor/wire… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
1981 Mercury 40hp 2cylinder 2 stroke. Compression 140 both
1981 Mercury 40hp 2cylinder 2 stroke. Compression=140 both cyl. New cdi, carb rebuild, fuel pump rebuild, fuel lines. Electrical components seem to OHM out ok (stator triger etc.). Motor will stall wh… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,059 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

21,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x