Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Jason, I just took a picture of the rubber grommet I was
Jason , I just took a picture of the rubber grommet I was asking about in a previous question about a week before. I have attached it , can you see it ? I removed my lower end of my 1996 Johnson 88 re… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,626 satisfied customers
I pull my lower end to change the water pump. It is my first
Hi Jason I pull my lower end to change the water pump. It is my first time pulling it and the pump was on for at least 10 years and finally stopped pumping. I couldn't get off the impeller and was pry… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,626 satisfied customers
Does not pump as should new impeller and housing can blow
does not pump as should new impeller and housing can blow air up water tube leaks into mid sec does the same when blown back from hose on bottom of head possible water tube hole? if so how do I get it… read more
Charles
Charles
Certified Mercury Tech
5,638 satisfied customers
My 25hp 1988 Johnson has water and appears to be normal flow
my 25hp 1988 Johnson has water and appears to be normal flow about a mile down the river it runs hot and steams? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,626 satisfied customers
On my 1992 Johnson 4 hp J4RENM a plastic bag caused the
On my 1992 Johnson 4 hp J4RENM a plastic bag caused the motor to overheat and warp the head. After installing a new head and gasket as well as an impeller the engine ran (and idled) well but no water … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1990 70hp evenrude. It seems to be overheating. It
I have a 1990 70hp evenrude. It seems to be overheating. It runs for about 4-5 minutes and then shuts down to an idle speed.(warning horn no longer works) I replaced the water pump and thermostat, but… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,626 satisfied customers
Mercury 225 efi saltwater: I just bought a 1996 merc 225 efi
I just bought a 1996 merc 225 efi saltwater series and at 20 plus knots it cuts power down and starts to smoke or steam until I shut it off for a minute replaced thermostats temp is around 125 f at id… read more
Charles
Charles
Certified Mercury Tech
5,638 satisfied customers
Just finished rebuilding water pump with yamaha water pump
Just finished rebuilding water pump with yamaha water pump kit for a 2006 yamaha f-150 4 stroke out board motor. No problems except when I re-attached the lower unit and put the mouse ears on to test … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2002 mercury 25e - two stroke engine. Water is pushing
I have a 2002 mercury 25e - two stroke engine. Water is pushing out around the lower and mid section housings around the forward area of joint between the two. (Best I can tell) This, just above what … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 91 Mariner 200hp. it has been in salt water. The powerhead
I have a 91 Mariner 200hp. it has been in salt water. The powerhead is froze to the exuast plate. I am trying to seperate them and can't. Any suggestions?… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
509 satisfied customers
hello..my name is dan...i have a jonhson 140 outboard ..i believe
hello..my name is XXXXX XXXXX a jonhson 140 outboard ..i believe is a 1985 model...not sure...in the mist of tryin to change the water pump impeller..an disconnecting everythng..even using wedges an p… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hey i have a 1985 Johnson 120 hp outboard with a 25 lower.
Hey i have a 1985 Johnson 120 hp outboard with a 25'' lower. Ive been using a jackplate to mount the motor on my boat since I have a 20'' transom. Now my lower unit is a V6 thats they way the 120's ca… read more
tom
tom
outboard mechanic
High School or GED
117 satisfied customers
I hooked up water to the intake to test my motor and when started
I hooked up water to the intake to test my motor and when started water comes out the back jet but also in another hole located by the vent screws. I have not noticed it before is this normal it also … read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have 1984 185hp Johnson. replaced the water pump and for
I have 1984 185hp Johnson. replaced the water pump and for whatever reason, can not seem to get water to go from pump grommet (on top of housing) into the water tube to engine block. I've tested each … read more
tom
tom
outboard mechanic
High School or GED
117 satisfied customers
I have a Johnson 2001 115 outboard. Just replaced water pump.
I have a Johnson 2001 115 outboard. Just replaced water pump. While running on hose, notice water leaking from between the leg and lower gear case. There is a small seem there. Never noticed this leak… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hi, I have a 1987 Johnson 200 HP 20 inch shaft with a
Hi, I have a 1987 Johnson 200 HP 20 inch shaft with a blown powerhead. I can get a 1988 Johnson 300 HP 25 inch shaft at a reasonable price. Can I put the 300 HP powerhead on my 200 HP short shaft mid … read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a 1994 25 HP Johnson outboard motor and am attempting
I have a 1994 25 HP Johnson outboard motor and am attempting to replace the water pump. I have taken out the bolts and have the lower unit loose, but it is still being held to the upper housing by som… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
The 1990 Johnson outboard that I just purchased, I was told
The 1990 Johnson outboard that I just purchased, I was told that there is no compression in the 1 and 3 cylinders. I charged the battery and the motor started right up. Although when you increase the … read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,059 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

21,626 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x