Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I, I have a 2001 50 Hp. Yamaha 2 stroke. I idles fine and
I have a 2001 50 Hp. Yamaha 2 stroke. I idles fine and cranks with ease. On the hose I can run it up to full RPM, but in the water (under a load) it will " bog down". For while it would bog a little and then pick up an run normal. Over time it has progressed to the point now that it will not pick up at all. I can still manually run up the RPM on the throttle in neutral. I have change the fuel tank,, hose, fuel pump, plugs and pulled the top carb bowl to look for trash or gunk. Clean as a whistle. The local shop says they have never sold a power pack for this model. Where do I go from here? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,608 satisfied customers
Jeremy, I have a 2008 115 4 stroke Yamaha. Start the morning
Jeremy, I have a 2008 115 4 stroke Yamaha. Start the morning and it runs great. sit for a couple hours fishing, starts up great, head back in and it loses power. Drop it down to around 20 to 25 mph an… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling out of channel starboard motor died . we go anchor starts back up when give it gas then dies again . changed both fuel filter water /fue… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,608 satisfied customers
I have an 04 yamaha 150 4 stroke. It is lagging coming out
I have an 04 yamaha 150 4 stroke. It is lagging coming out of the hole. It has never had this problem before. Plugs have been changed. Always run regular Unleaded no ethanol. Fuel is from last Sept. W… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,608 satisfied customers
Yamaha 4 stroke 250. 475 hours. Get alarm when first give gas
Yamaha 4 stroke 250. 475 hours. Get alarm when first give gas to plane off each day. Turn off and reset then no more issues. Think water gas alarm. Yamaha fuel separator shows no water filter in engin… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,608 satisfied customers
I have a 115 yahama 4 stroke, and two recent problems. One
I have a 115 yahama 4 stroke, and two recent problems. One is that motor does not shut off by turning key to off position. This has happened in the past and turning steering wheel has worked most time… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have Yamaha 200 HP (2004, 2-stroke, SX200C) with about 385
I have Yamaha 200 HP (2004, 2-stroke, SX200C) with about 385 hours on it. It's maintained and I use Yamaha Ring Free additive and Stabilz fuel stabilizers; fuels filters are changed out annually. Runs… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
2002 mercury 125hp 2+2 gets up on plane, then starts surging,
2002 mercury 125hp 2+2 gets up on plane, then starts surging, like starving for fuel. This lasts about 5 minutes, then runs well after it warms up.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,608 satisfied customers
Hi: I have problems with my Yamaha F115 again. Last summer
Hi: I have problems with my Yamaha F115 again. Last summer you helped me diagnose what turned out to be a crack in the plastic housing that holds the fuel filter. Afte that i had not trouble starting/… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
21,608 satisfied customers
I have a 1987 Evinrude V4 90 HP motor. I have recently had
I have a 1987 Evinrude V4 90 HP motor. I have recently had my VRO pump removed, and replaced it with a regular fuel pump. It was running great for about 5 weeks. Now it will start fine, and idle fine … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
i have a yamaha 150 that stalls once in a while it feels like
i have a yamaha 150 that stalls once in a while it feels like i am pulling the throttle back and forth once i get it trimmed out it will run fine any help out there… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
2002 yamaha 150txr bogs down/loses power down cant run past
2002 yamaha 150txr bogs down/loses power down can't run past 2000rpms and varies from day to day. loses power from the start and when start to get boat on plane. cleaned fuel seperetor (found in batte… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2008 Yamaha f50 outboard with less than 20 hours on
I have a 2008 Yamaha f50 outboard with less than 20 hours on it. It's mounted on a 17ft Carolina Skiff. It will not reach full throttle and the boat will not reach plane. My local marine repair shop c… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
hi i have a yamaha 150 hpdi that will start and run at idle
hi i have a yamaha 150 hpdi that will start and run at idle fine when you give it full throttle it will accelerate fine for about a minute, then fall flat on its face and barely run..… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I am having a problem with 2003 200 hp HPDI yamaha(counter
I am having a problem with 2003 200 hp HPDI yamaha(counter rotating). It will go to near full throttle then the power fades over about 1 minute until boat will not stay on plane. If at any time I try … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2004 Yamaha Vmax x66 recently had trouble with the
I have a 2004 Yamaha Vmax x66 recently had trouble with the engine shutting off. this happened 3 times. It happened twice 7 hours into the tournament day and not after a long run. The third time the b… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
my yamaha LZ250TXRB outboard loses power at about 3500 rpms.
my yamaha LZ250TXRB outboard loses power at about 3500 rpms. i have drained all fuel, changed all fuel filters and cleaned water seperaters. any clues to what the problem might be?… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1999 Yamaha Vmax 3.1L FI OX66 200hp. It cranks fine
I have a 1999 Yamaha Vmax 3.1L FI OX66 200hp. It cranks fine and runs good until you get to 5000 rpm's and it cuts off like you turn the key off. It will crank back up and sometimes it will start back… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,059 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

21,608 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x