Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a Mercruiser 4.3 with an Alpha One Gen 2 outdrive.
I have a Mercruiser 4.3 with an Alpha One Gen 2 outdrive. Just replaced the impeller, a whole kit assembly with gaskets, house etc. For some reason the drive is not pulling in water. I back flushed it… read more
NicholasH311
NicholasH311
Owner/ lead technician
motorcycle and marine certifications
130 satisfied customers
I just purchased my first boat. It is a 2002 Crownline 225
I just purchased my first boat. It is a 2002 Crownline 225 br with a mercruiser 350 and a bravo one outdrive. It is in very good condition and seems to be very well taken care of, but has been sitting… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,859 satisfied customers
Please hold on 1 minute sorry : overheating : Volvo penta sx
hi, please hold on 1 minute sorry JA: Sometimes things that you think will be really complicated end up being easy to fix. The Marine Mechanic I'm going to connect you with knows all the tricks and sh… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,859 satisfied customers
Jason. I just got my boat back into water after a 4 week repair. Had cylinder head gas
Hi, Jason. I just got my boat back into water after a 4 week repair. Had cylinder head gaskets replaced due to overheating. Now, noticed that the exhaust is bubbling through the shield. I'm guessing a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,859 satisfied customers
Jason, I am changing out my Volvo Penta 280 outdrive to a 290 outd
Hi Jason, I am changing out my Volvo Penta 280 outdrive to a 290 outdrive. I am looking for the dimension from the center of the crankshaft to the bottom of the keel. As it stands now if I use the sam… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,859 satisfied customers
Hi Jason I have a 2008 150 optimax that stalls underload when
Hi Jason I have a 2008 150 optimax that stalls underload when in gear but will clear up when you run it wot then bring it back to idle again . But if you leave it about 15-20 minutes at idle it will b… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,859 satisfied customers
i have a 1988 four winns 160 freedom with a 3.0 omc cobra 120
i have a 1988 four winns 160 freedom with a 3.0 omc cobra 120 hp motor. i am having top speed issues and noises coming from either drive system or motor. scenerio: when im just in gear moving at a slo… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My boat is overheating its a 87 Larson and i just had a new
My boat is overheating its a 87 Larson and i just had a new engine block put into it, the impeller is brand so thats not the source any ideas?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,859 satisfied customers
I bought a used boat with a 350mag mpi with 65 hrs on it. the
I bought a used boat with a 350mag mpi with 65 hrs on it. the boat 2003 model and took it to the lake for the first time. started fine but within 5 minutes the motor got so hot it started melting the … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My 7.4L slowly overheats at 3,000 rpm. At 1,000 rpm it cools
My 7.4L slowly overheats at 3,000 rpm. At 1,000 rpm it cools down to 170 within a couple minutes. I replace thermostat, checked impellar. Water does not seem to be coming in from outdrive as it should… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a seadoo 1998 Seadoo Challenger 1800 and Ive had it
I have a seadoo 1998 Seadoo Challenger 1800 and I've had it out on the water a few times this year. It was recently serviced at a dealership and both engines had carbs rebuild, adjusted, etc. to make … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1990 Sunbird Corsica 198 I got dirt cheap with trailer
I have a 1990 Sunbird Corsica 198 I got dirt cheap with trailer but no engine. I purchased a new Marine power 3.0 L to replace the one that came out. (2.3 had already been upgraded to the 3.0 at some … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hello, I currently have a 1996 Four Winns Sundowner 245 with
Hello, I currently have a 1996 Four Winns Sundowner 245 with a 5.8 Fi Volvo Penta Engine (OMC markings on the engine too) and the Duoprop (DP-S) outdrive. I recently had Skipper Bud's in Pewaukee, Wis… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have recently purchased a used 2004 Crownline 225BR sporting
I have recently purchased a used 2004 Crownline 225BR sporting a 5.7L GXI 350 Mag Volvo Penta and Volvo Penta Duo Prop outdrive. Only to find out later that it was once a salt water vessel. Before eve… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Thanks for your time. I will be inspected at 1989 Celebrity
Thanks for your time. I will be inspected at 1989 Celebrity 199SE this week, for possible purchase. It has a Merc 305 with an Alpha One LX outdrive. Any particular items I should be on the lookout for… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
Recently purchased 96 Four Winns Sundowner 225 w/Volvo Penta
Recently purchased '96 Four Winns Sundowner 225 w/Volvo Penta 5.8efi and FWC and a Cobra outdrive. When I attempt to flush the outdrive most of the water sprays on the outside of the outdrive and very… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I recently had a new transome put on my boat, ( bravo 3 lower
I recently had a new transome put on my boat, ( bravo 3 lower unit with 2 props) it has a 5.0 Mangum engine. Before I would run around 3000 to 3200 rpm at about 58 mph. (Wide Open) Now it runs 4500 rp… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
i have a 79 glasply with a omc 400 outdrive the thing is a
i have a 79 glasply with a omc 400 outdrive the thing is a slug coming out of the hole, i am looking for a cost efective way to increase HP. Are their any larger motors that can easily replace the gm … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,859 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x