Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I've got twin 250 yamaha outboard and the batteries are
I've got twin 250 yamaha outboard and the batteries are fully charged, However at low speeds my voltage read out hovers around 14 yet when I accellerate to cruing speed (4200 rpms) my starboard voltag… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,078 satisfied customers
I have twin 2002 yamaha ox66 250's. Thought i had an ethanol
I have twin 2002 yamaha ox66 250's. Thought i had an ethanol prob;em so changed/cleaned all filters, o2 sensor, and injectors. engine still wont go over 3000 rpm. tested for spark and have none on one… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,078 satisfied customers
Fuel Pressure Problems at high RPMS Volvo Penta D6 370s
I have a twin volvo penta d6 370 engines, 2012. They have 200 hours on them. The PSI for the starboard is 32-33 psi at 3600 rpms and the port gets up to 18-19 psi and falls back down and the engine is… read more
Expert
Expert
I have twin 250 verados. Yesterday I lost battery power to
I have twin 250 verados. Yesterday I lost battery power to the port engine. It continued to run, but the DTS limited my throttle rpm to 4800. When getting to safety, i put both motors in neutral. I th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,078 satisfied customers
Mercury varado 250: i have twin 250 verados. when i am idle
i have twin 250 verado's. when i am idle along for a while and then proceed to take off, the port engine as i slowly accelerate will go to about 3800 rpms and stumble back to around 3200 for a couple … read more
Charles
Charles
Certified Mercury Tech
5,638 satisfied customers
Have twin 250 e- tec s 2010 with 3 I com guages. Motors
Have twin 250 e- tec 's 2010 with 3 I com guages. Motors have 101 hrs. 30 miles offshore engines suddenly powered down. Guages flashed 4 dashes, start stop buttons would not work- shut off motors with… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
evenrude e-tec engine wont turn over no power to tilt &trim
evenrude e-tec engine wont turn over no power to tilt &trim have power to starter solenoid all electronics work… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hello, I have Evinrude 250 ho E-TEC and I am having a problem
Hello, I have Evinrude 250 ho E-TEC and I am having a problem with understanding why I can't get some more speed out of it. I ran last night in a league tourny I was running 50 mph @ 5000 rpm I am not… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,011 satisfied customers
I have a 2007 evenrude e-tec ho and im getting about 4 psi
I have a 2007 evenrude e-tec ho and im getting about 4 psi of water pressure at idle and about 15 to 17 psi at 5000 rpms is that about right? and i was wondering how big a stream of water it is suppos… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have Evinrude E Tech 250 if you start out running at 3500rpms
I have Evinrude E Tech 250 if you start out running at 3500rpms and then troll at 1100rpms for a few hours, then kick it back up to 4000 rpm to get to another spot and while your on the way the engine… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have 2 2004 200 hp evuinrudes on a 25ft hydra sport center
I have 2 2004 200 hp evuinrudes on a 25ft hydra sport center console, after running @4000 rpm for exactly 20 miles the starboard engine just shuts off, not slows down, just shuts off! then as I bring … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,011 satisfied customers
I have twin volvo penta 5.7 GXil-F gas engines, today the port
I have twin volvo penta 5.7 GXil-F gas engines, today the port side engine ran at a much lower RPM than the starboard engine, almost 800 to 900 RPMs lower. After about 30 minutes the port side engine … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 7.4 Mercury twins my port engine was missing then
I have a 7.4 Mercury twins 1993 model they have about 250 hrs on them my port engine was missing then at higher rpms above 2400 it will blow oil out the dip stick, at lower rpms it doesn,t but it has … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
7,675 satisfied customers
How do you take the lower end off an evinrude e-tec 250 We
How do you take the lower end off an evinrude e-tec 250? We have taken all the bolts off, its loose, but something seems to keep holding it up, is there is pin or something?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have twin 05/06 mercruiser 8.1 HOs on a 40 ft Meridian.
I have twin 05/06 mercruiser 8.1 HOs on a 40 ft Meridian. A month ago I went out and the over speed alarm went off on the stbd engine just as I was leaving the marina. I had just started to partially … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I am considering the purchase of a 60HP outboard for my pontoon. First
I am considering the purchase of a 60HP outboard for my pontoon. First choice is a 60 HP Mercury (4 stroke), second is a 60HP Evenrud (2 stroke). I am leaning toward the Mercury because it will be qui… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
We have a problem with one of our two 1995 Yamaha Saltwater
We have a problem with one of our two 1995 Yamaha Saltwater series outboards. We get a speed reduction most of the time but not all the time. The speed reduction stops for about 3 seconds when the dow… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
e-tec, led light #3,and low rpm at full throttle wants to be
e-tec, led light #3,and low rpm at full throttle wants to be in s.a.f.e mode, rpm at only 3000 at wot. ? ok.… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

7,675 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

20,078 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x