Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
My 2002 Yamaha 225 stb engine starts right up but while
My 2002 Yamaha 225 stb engine starts right up but while running under a load it starts to cough and bog down after 2500rpm. If I continue to run the engine for about a 1/2 hr it tends to clear up and … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
My starboard 225 HP yamaha outboard motor (4 stroke) is
My starboard 225 HP yamaha outboard motor (4 stroke) is running roughly. It barely runs at idle, and knocks about every 4-6 seconds. I also noticed that there are a lot of large air bubbles coming fro… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I have a Yamaha 225 - ran fine all summer - used almost
I have a Yamaha 225 - ran fine all summer - used almost every Saturday and Sunday from mid-May - early Sept. I hadn't run the engine for about 25-28 days and it was rather warm down here. Anyway, took… read more
Charles
Charles
Certified Mercury Tech
5,638 satisfied customers
I have a 2004 VZ 225 hpdi very slow out of hole an only 5100
I have a 2004 VZ 225 hpdi very slow out of hole an only 5100 rpm top end. All filters where changed last fall. 50 psi to high pressure pump. I borrowed another pump from a friend an it still does the … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I have 2 twin 150 yamaha 2 stroke on a grady white. When throttled
I have 2 twin 150 yamaha 2 stroke on a grady white. When throttled up 1 engine seems to run fine at full throttle and one completely cuts out. Motor will start missing then power back up. If I back th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
1.) Have a 2005 VZ250TLRD / HPDI YAMAHA and it had a cylinder
1.) Have a 2005 VZ250TLRD / HPDI YAMAHA and it had a cylinder failure. I brought it to shop and the oil line was found to be off #4 cylinder and believed to have been the cause of failure. 2.) engine … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
looking at a whaler with a 2003 Mercury 225 hp 4 stroke engine
looking at a whaler with a 2003 Mercury 225 hp 4 stroke engine (made by Yamaha I believe) with 180 hours on it. I cant tell if I should stay away because of the corrosion issue or if I just need to ge… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Looking to talk to a certified Yamaha outboard mechanic that
Looking to talk to a certified Yamaha outboard mechanic that feels confident helping me with some fuel system maintenance for my VZ300 HPDI. (Used on bass boat).… read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
I need to replace my ECU (60V-8591-00-00) on my 2003 Yamaha
I need to replace my ECU (60V-8591-00-00) on my 2003 Yamaha (Z250TURB) 250hp HPDI outboard. They have 2 new updates to this ECU: 60V-8591-01 and 02. New ones are $1350 and I have found a used one for … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
1998 stratos motor is evinrude 115glecm intruder power trim
1998 stratos motor is evinrude 115glecm intruder power trim wont trim up or down i replaced eletrical motor connected to hydraulic motor still wont trim . how do i reset it after service . if motor wa… read more
Scott Martin
Scott Martin
Service manager
Vocational, Technical or Trade Scho
167 satisfied customers
I have a 2004 150 HPDI (less than 300 hrs) that was running
I have a 2004 150 HPDI (less than 300 hrs) that was running great until a month ago. While running fast the boat came off a plane and would not go past about 2000 rpm's. It bogs down after that and so… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I have a Wellcraft Coastal 290 with twin Yamaha 225's. Both
I have a Wellcraft Coastal 290 with twin Yamaha 225's. Both heads recently developed a small hole where the cooling system water is now being ejected. They are 2005's with only 200 hours. Why would th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
i have a 14 ft Nautica Rib with a Yamaha T60 and am have big
i have a 14 ft Nautica Rib with a Yamaha T60 and am have big performance issues with a 13 1/2 x 15 propeller. Do you have and suggestions?… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
hi my name is Ayoze, i have a original 225 jhonson , which
hi my name isCustomer XXXXX have a original 225 jhonson , which is the best propeller for higest performance and speed? beacause i feel it to slow, it runs well and star very good, but i don't know wh… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Looking at a used 2001 29 Pro sport cat has twin 2001 200 HP
Looking at a used 2001 29 Pro sport cat has twin 2001 200 HP Yamaha HPDI outboards on it. I know the newer 200 HP Yamaha HPDI outboards are pretty good reliable motors but I was wondering if the older… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a 2003 250 hpdi yamaha that i did not run for 10-12
I have a 2003 250 hpdi yamaha that i did not run for 10-12 months but i added fuel conditioner to my tank. Before launching i added 20 gallons of fresh gas and the boat ran great for about 6 gallons o… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
i just put a 2003 225 yamaha outboard motor on my boat and
i just put a 2003 225 yamaha outboard motor on my boat and cant get enough rpms or speed out of it. I put a 15 1/4 x 15 prop on it and it only gets 5100 rpm and 21 mph. motor seems to ecelerate great … read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I am sea trialing the following a year 2000 264 cobia center
I am sea trialing the following:a year 2000 264 cobia center console, with twin year 2000, 150 yamaha HPDI,s. My question is what is the maximum RPM rate that we should see on the tach to indicate goo… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,488 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x