Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I just put a used 25 hp Yamaha 4 stroke on a 13' Livingston.
I just put a used 25 hp Yamaha 4 stroke on a 13' Livingston. On my first trial run the water boiled up around the motor when I put it on a plane. A fair amount of water spilled into the boat over the … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,311 satisfied customers
I just bought 23"seacraft cc, the bat has twin Suzuki 140's
I just bought 23"seacraft cc, the bat has twin Suzuki 140's on a stainless marine motor bracket, manta fins on the anti cavitation plates , bennet trim tabs and hydraulic steering. When I push the boa… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,311 satisfied customers
Our 4.2 metre lifts up on the starboard side when we are travelling
Our 4.2 metre lifts up on the starboard side when we are travelling on the water. We have tried everything, It did not do it until after we replaced the old outboard with a new Yamaha 40 hp, we have t… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 16' scot boat, replaced 90 2 stroke with 90 4 stroke
I have a 16' scot boat, replaced 90 2 stroke with 90 4 stroke .boat runs great ,I put wife in it and boat starts porpoising ,motor is Yamaha, were should motor be mounted on transom,excaty motor is si… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
New to boating! Just bought a 2000 starcraft starfire with
New to boating! Just bought a 2000 starcraft starfire with 90 hp merc with a 9.9 Merc four stroke kicker, pulls hard to the right. Also front end lifts too much at low speeds. Tried adjusting trim tab… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,311 satisfied customers
I purchased a 2008 Fisher 240 Tritoon with no motor and then
I purchased a 2008 Fisher 240 Tritoon with no motor and then purchased a Honda 200 Outboard and attached it with honda rigging. The first two times I went out in the boat with my family it would do 40… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Asked a shop to repower my boat with 90-HP Yamahafour strokes
Asked a shop to repower my boat with 90-HP Yamahafour strokes and they installed long shaft engines instead of the short shaft the boat had. Besides skeg lenght and overall draft, what are pros/cons o… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,739 satisfied customers
I have a boat with a 90 cm draft.Fitted are Twin Yamaha 4 stroke
I have a boat with a 90 cm draft.Fitted are Twin Yamaha 4 stroke 225. The problem is that because of the transom height the trim motors sit underwater resulting in corrosion,leakage through trim seals… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have 19ft open V center console boat that had a 2 stroke
I have 19ft open V center console boat that had a 2 stroke 115 yamaha outbord and ran fine. When I replaced the engine with a DF 115 4 stroke suzuki the shaft was shorter than the first engine, the tr… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 75 HP 4 stroke outboard boat motor. I brought it in
Hi, I have a 75 HP 4 stroke outboard boat motor. I brought it in 2005. I have never replace water pump impellers. Is it time to replace the impellers? Do you have a video clip showing how it is done? … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I am in the process of repowering my 1989 Mako 231 with a 4
I am in the process of repowering my 1989 Mako 231 with a 4 stroke outboard. This boat presently has the original Yamaha V6 200 HP motor. I have seen a lot of newer boats (sea Hunt etc) with comparabl… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,311 satisfied customers
A dealer put on a 2010 9ohp 2 stroke on a 22 ft crestline pontoon
A dealer put on a 2010 9ohp 2 stroke on a 22 ft crestline pontoon boat. It replaced a 70hp 4 stroke Johnson that i put on my fishing boat. The new mercury i put on the ponton was very hard to steer an… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Prop question I have a 2009 War Eagle 1648 (aluminum semi-v)
Prop question? I have a 2009 War Eagle 1648 (aluminum semi-v) on which I just mounted a 2009 Mercury 25 HP 4 stroke short shaft motor (the transom is 16"). I took the motor out for its initial run and… read more
Jason
Jason
Associate Degree
210 satisfied customers
I replaced a 35 Evinrude 2 stroke long shaft with a 25 hp Yamaha
I replaced a 35 Evinrude 2 stroke long shaft with a 25 hp Yamaha 4 stroke tiller--long shaft, on a 16 ft lund WS-16. The Yamaha dealer used about a 1.5 inch high block on top of the transom--he said t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Ihave a 24 ft Robalo center console with twin 4 stroke Yamahas.It
Ihave a 24 ft Robalo center console with twin 4 stroke Yamahas.It has 13-3/4 17 stainless props. The boat slips or cavitates when trolling at 8 -10 knots. I tried 14-1/2 17 aluminum props and the boat… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a Cajun 16 ft bass boat with a 90 HP Evinrude motor.
I have a Cajun 16 ft bass boat with a 90 HP Evinrude motor. The issue is simple--I must hold hard left on the steering wheel to keep the boat from turning sharp right. If I let go of the wheel the boa… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I am attempting to install a stinray hydrofoil on a 2007 15
I am attempting to install a stinray hydrofoil on a 2007 15 hp four stroke yamaha outboard. There is a small plate and a rudder underneath the cavitation plate on the outboard. What is the pupose of t… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the engine cavitates alot some times at 3500 rpm somtimes higher ,cruising at 3000 to 3500 for no reason at all the rpms start climbing. the eng… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

23,311 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x