Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Starts and dies within seconds. sat for 4 years. hp fuel
starts and dies within seconds. sat for 4 years. hp fuel pump was clogged. soaked in seafoam and got it pumping fine. … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
7,403 satisfied customers
Cranked Westerbeke 5.0 excessively and engine seems to be
Cranked Westerbeke 5.0 excessively and engine seems to be locked up from perhaps too much raw water going into system. Where does it go and how do I relieve the pressure so engine will turn again? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I have a 4hp 4stroke mercury outboard. Replaced impeller
I have a 4hp 4stroke mercury outboard. Replaced impeller last year. Since then, the motor does not shift back into neutral when going forward. I have to go past neutral towards reverse until it goes i… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
the problem is with a Yanmar 20GM20F, a 2 cylinder marine diesel that is installed in a sa
the problem is with a Yanmar 20GM20F, a 2 cylinder marine diesel that is installed in a sailboat. It was installed six years ago, brand new, and has never been started. The crankcase was filled with o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
i have a 1981 westerbeke 58 diesel in my sailboat. About 20
i have a 1981 westerbeke 58 diesel in my sailboat. About 20 minutes ago, I am in the erie canal, it slipped out of gear. I drifted to shore and now tied up in an untenable position. I checked the link… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
have yamahe 50 hp 6h5 motor idles great shifts ok but will
have yamahe 50 hp 6h5 motor idles great shifts ok but will not throttle up i think control cable mis detached in control head. how replace/ repair?… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,805 satisfied customers
How to adjust the rpm on marine genset Westerbeke diesel 15.0
How to adjust the rpm on marine genset Westerbeke diesel 15.0 kw model number BTD15-614. Engine serial no. 153956-C711. Currently voltage is a little low at 114 volts and hertz low at 57.5 with light … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I have a 30B with a JS Transmission in a Beneteau 361. Saturday
I have a 30B with a JS Transmission in a Beneteau 361. Saturday night the transmission stopped working - will not go into gear. Shift arm on top of the transmission moves to stops. No noise - nothing … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 20+ year old Westerbeke 12B two diesel engine that
I have a 20+ year old Westerbeke 12B two diesel engine that for the last couple of years has intermittent rpm drops. Assuming I might have an injector problem, I put some marine diesel additive in it.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Oct 2002 Suzuki DF 25 4 stroke 02501f / 371170Started with
Oct 2002 Suzuki DF 25 4 stroke 02501f / 371170 Started with poor idle, no power, slow to accelerate, Found fuel/water seperator full of water and goo replaced fuel tank,flushed lines, replaced boat an… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2004 westerbeke diseal I have had the injector pump
I have a 2004 westerbeke diseal I have had the injector pump checked I have had the racor changed all the fuel lines are new. How Do i take the lift pump off ? what else could cause no fuel pressure a… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1990 90 horse johnson motorstarts in gear......wont go into
2000 90 horse johnson motorstarts in gear......wont go into neutral or reverse......runs great.......speedometer doest work now… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a W 20B in a Cape Dory sailboat. The v-belt shredded
I have a W 20B in a Cape Dory sailboat. The v-belt shredded on a cruise. I got out my spare (from Westerbeke) but the alternator couldn't swing in far enough to the engine for me to get it on the last… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 1992 yamaha 25hp outboard, 2 cylinder, 1 carb. I
I have a 1992 yamaha 25hp outboard, 2 cylinder, 1 carb. I just purchased this motor and took it to the lake. It cranked up on about the 3rd pull, but the idle was ver high. I waited quite a while for … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
Hi, I need to replace the safety switch on my Johnsn 115
Hi, I need to replace the safety switch on my Johnsn 115 control. Sidemount. How do I take it off of the side to get to the switch? I see 4 screws toward the back and one in the front but I can't get … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
1998 seadoo challanger 1800 sitting on floating dock no throttle
1998 seadoo challanger 1800 sitting on floating dock no throttle control starts up and reves to 4,000 rpm… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I hit a dock when I put my Westerbeke 70 into reverse, and
I hit a dock when I put my Westerbeke 70 into reverse, and the boat was still being driven forward. It never went out of F, even though I paused at N, and put her in R. I suspect a shift linkage probl… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 90 hp evinrude model E90MLCDC serial J1120379. I believe
I have a 90 hp evinrude model E90MLCDC serial J1120379. I believe it dates to 1982. I need to remove the lower unit as the shaft is broken. I have removed all of the bolts that I can see but the unit … read more
FieldServiceTech
FieldServiceTech
Vocational, Technical or Trade Scho
146 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

7,403 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x