Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2013 mercury 60 hp efi big foot. Used the boat a few weeks
2013 mercury 60 hp efi big foot. Used the boat a few weeks ago ran like top as usual, Today ran the boat and had a loss of power got back to the dock and started trouble shooting. first was checking t… read more
Charles
Charles
Certified Mercury Tech
5,632 satisfied customers
Intermittent loss of spark to number 3 on a 2000 70 HP. At
Intermittent loss of spark to number 3 on a 2000 70 HP Johnson. At least I think it is loss of spark. It definitely goes back to 2 cylinders and pulling number 3 HT lead has no noticeable affect on po… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
1987 90HP runs but no power in forward. Idle no problem RPM
1987 90HP Johnson runs but no power in forward. Idle no problem RPM up to 4000 no problem boat in water only 2000 RPM. Idle \s fine starts fine just no power. Like the hi speed jets not open if there … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Evinrude 140hp: I have an evinrude 140hp on a pontoon boat.
I have an evinrude 140hp on a pontoon boat. The boat runs fine, but tops out at 1800 RPMs (15MPH). We can run for about 30 minutes to an hour and then it will jump to 2800 RPM (22MPH). Might run like … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1978 Johnson 9.9 outboard that I salvaged. It has
I have a 1978 Johnson 9.9 outboard that I salvaged. It has new plugs, power packs, carb kit, fuel pump, hoses, impeller, lower unit oil, etc. It has good compression but I can't start it to save my li… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Hello. I have a Johnson 115 outboard motor. The motor was starting
Hello. I have a Johnson 115 outboard motor. The motor was starting right up and idling good. And when in neutral I could rev the motor and it would rev nice and high. But once I put it in gear I could… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2008 Yamaha 25 horse power two stroke. It started
I have a 2008 Yamaha 25 horse power two stroke. It started missing and only runs with the choke pulled. Is this a fuel problem or electrical. It was running wide open and quite while we were running. … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
30 hp johnson, 1987, top cylinder does not fire, switched plugs,
30 hp johnson, 1987, top cylinder does not fire, switched plugs, still top not firing, saw and smelled gas on plug, switched coils, same. Compression checked 120 pds both cylinders. Removed wire to bo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 1996 Evinrude Intruder 150 And had it on the water
I have a 1996 Evinrude Intruder 150 And had it on the water today ran great for about 10 to 15 minutes then my tilt and trim quit working and a check engine light came on and a buzzard then it started… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 1988 Evinrude 40 hp outboard model E40TELCCS. The
I have a 1988 Evinrude 40 hp outboard model E40TELCCS. The motor starts and idles fine when I apply power to the motor my problem is at first it runs fine then the motor will start hesitating and afte… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
1981 35 hp evinrude. No spark to lower plug. replaced the
1981 35 hp evinrude. No spark to lower plug. replaced the coil still no spark. Motor runs on 1 cylinder.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Can I get the ohm specs and color codes to test the ignition
Can I get the ohm specs and color codes and proceedure to test the exciter coil and CD unit and siamese coil on a Nissan 1998 ns18es outboard motor? I have no spark and need to test those three parts … read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
I have a 72 johnson model 65ESL72S. I was running the boat
I have a 72 johnson model 65ESL72S. I was running the boat and the motor quit. I found the wire that plugs onto the neutral swith or button was off. I put it back on and it wouldn't crank. I was told … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1975 50 HP Johnson outboard (Model 50ESL74M and Serial
I have a 1975 50 HP Johnson outboard (Model 50ESL74M and Serial No. E4040729). Last year, I had a problem with the engine only running on lower cylinder. I replaced the Ignition Power Pack (but not th… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1993 Johnson 200hp Ocean Runner that appears to be
I have a 1993 Johnson 200hp Ocean Runner that appears to be skipping. I had all carbs rebuilt, I changed the powerpack, stator, trigger base, spark plugs, and fuel pump assembly. I have good spark and… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have an 1977 Evinrude 55 HP outboard and the other day I
I have an 1977 Evinrude 55 HP outboard and the other day I started the boat up and as we were just starting across the lake the motor started to skip and then sounded like it was just firing one one c… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 9.9 hp two stroke 1995 Evinrude outboard motor with
I have a 9.9 hp two stroke 1995 Evinrude outboard motor with remote throttle. seems to have a fuel problem. not enough fuel to start. i need to give the throttle a lot of gas for it to start up. then … read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have a Johnson 60hp, 1962, 2 cycle, 3 cylinder outboard motor
I have a Johnson 60hp, 1962, 2 cycle, 3 cylinder outboard motor on my boat. I can start the boat, but cannot get top end speed. (the fastest I can go is about 10 mph. This boat usually goes about 35 m… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,488 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x