Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
On my 1983 Glastron cvx17, a whining sound from the shifter
On my 1983 Glastron cvx17, a whining sound from the shifter area and not the engine started happening 5 minutes after startup. I was cruising through the no wake zone when it happened. In gear, neutra… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,950 satisfied customers
I removed the lower end on my 3.0 mercruiser Alpha1 2nd gen
I removed the lower end on my 3.0 mercruiser Alpha1 2nd gen to replace the impeller. I forgot to put it in forward before dropping the lower end. I put it back together and now it stalls when I put it… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I took my lower unit off of a 50 hp Mercury and replaced the
I took my lower unit off of a 50 hp Mercury and replaced the water pump impeller. As I was replacing the lower unit , I am unable to get it back into place. it's stops about 1/2 inch from getting back into place. I have done this many times without any trouble. now I am at a loss. the gear shift in the lower housing seems to be in forward and don't seem to be able to get it back into neutral . i could use some help … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,666 satisfied customers
My Merc 150hp Optimax shifts very hard from neutral to
My Merc 150hp Optimax shifts very hard from neutral to forward/reverse making loud gear grinding noise. My previous mechanic said it was normal and to just slam it into gear. I think the rpm is to hig… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I just replaced the impeller on my 1989 Alpha One Gen 1. I
I just replaced the impeller on my 1989 Alpha One Gen 1. I have it all back together after a successful battle with the shift lever. LOL Two questions - when the lower was separated and I rotated cloc… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1986 Omc cobra and recently shredded the upper gears.
I have a 1986 Omc cobra and recently shredded the upper gears. I replaced the whole outdrive with a 21:21 off of a 2.3L. Due to the lower gearcase being smaller my 14.5" prop would not fit and caused … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Problem - my husband personally installed Teleflex 7500 series
Problem - my husband personally installed Teleflex 7500 series in 21ft 1996 Wahoo to 1996 Johnson 150 . Had a problem with shift cable- reverse would not fully engage. Took it to boatyard mechanics. B… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2005 Yamaha 50 hp 4 stroke outboard, I had removed
I have a 2005 Yamaha 50 hp 4 stroke outboard, I had removed the lower unit to replace the impeller, after re-assembly and trying to run the boat on the lake the impeller work fine. the bad- at first t… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1993 Reinell with Mercury 150hp XR6 that doesnt go
I have a 1993 Reinell with Mercury 150hp XR6 that doesnt go into reverse . Forward works fine neutral (prop keeps going slow) and reverse doesnt go in at all ..when in reverse it keeps going forward. … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
i have a 115 mercury 1990 model, i have reverse but have no
i have a 115 mercury 1990 model, i have reverse but have no forward. is it possible that i may have a shear pin that gave way, and if so where might it be located?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
So after my injury I was able to get back to the lower unit.
So after my injury I was able to get back to the lower unit. My auto mechanic friend and I managed to get the prop to lock in forward and reverse and be free in neutral. We put the lower unit back on … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I removed my 1990 alphaXXXXXput into fwd Gear first)
I removed my 1990 alphaXXXXXput into fwd Gear first) remove lower runit, replace impellar pump, re-install lower unit, installed outdrive. 1. Boat wouldn't turn over 2. I noticed when we were cranking… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Century Resorter- 72CBW: My question regards XXXXX XXXXX 72C Velvet
My question regards XXXXX XXXXX 72C Velvet Drive Transmission (1:1). It is in a 1963 Century boat. I had it rebuilt about 20 years ago. The boat has not been used (because of the trans issue) for 10 y… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
When I put my boat into gear to go forward or backward the
When I put my boat into gear to go forward or backward the prop does not turn, I was idling down the lake and alternator belt broke and then the prop quit turning. I've replaced the alternator belt an… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
1990 Mercury 200hp Spun Prop, or what I have 2 engines
1990 Mercury 200hp Spun Prop, or what??? I have 2 engines on boat. We were going through inlet at about 2500rpm in strong current when port engine shot up to 4000rpm plus! It sounded like it had poppe… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I can disconnect the throttle cable and the prop engages and
I can disconnect the throttle cable and the prop engages and disengages when I move the drive shaft on the motor. When I re attach the throttle cable and use the console throttle the prop always spins… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My engine was running fine this morning, I have a 85hp chrysler
My engine was running fine this morning, I have a 85hp chrysler , I was at idle by the dock and the boat started drifing towards the dock and I reached over and put the shifter in reverse and the engi… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Took my 1966 merc 500, 50 hp outboard lower unit in for lower
Took my 1966 merc 500, 50 hp outboard lower unit in for lower unit pressure test ( water in oil). Before removing lower unit put shifter in forward gear as manual said. Now cannot get unit together so… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

8,642 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x