Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
1999 mercury outboard, 40hp, running rough at low speed,
1999 mercury outboard, 40hp, running rough at low speed, already cleaned all 3 carburators, replace plugs and gas filter. Coil 1 resistance 8.8ohm Coil 2 resistance 7.9ohm Coil 3 resistance 8.4ohm...… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
Mercury 40 hp efi will idle at start. Will run fast no
mercury 40 hp efi will idle at start. Will run fast no problems there. However as soon as I go from forward to neutral it will beep 1 time and die It will start up everytime, just go in forward and ba… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
Need to change water pump on a 2006 4 stroke 3 cilinder efi
need to change water pump on a 2006 4 stroke 3 cilinder efi or 154449 v f25ml … read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
I have a 2003 Yamaha 2stroke 40hp 3cyl outboard. Idles good
I have a 2003 Yamaha 2stroke 40hp 3cyl outboard. Idles good but when you gas it sometimes it will start to plane then just fall dead. Max speed is 8 mph. Carbs look great, new cables and shifter, plug… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 1985 mercury 115 inline six outboard. It runs fine
I have a 1985 mercury 115 inline six outboard. It runs fine when just started and will run at any speed you set the throttle at. After about 10 minutes after engine warms up and you back it down to id… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1980 evinrude 35 hp electric start remote control
i have a 1980 evinrude 35 hp electric start remote control outboard on my 16' sea nymph. the motor has 115 PSi compression on both cylinders and has a strong spark. fuel lines, gas tank, primer bulb a… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have 2006 mercury 115 efi optimax 2 stoke just bought it
I have 2006 mercury 115 efi optimax 2 stoke just bought it was setting up for A while was ruining fine then stopped stared right up at low rpms long story short had old dryed up varnished fuel in line… read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
I have a 06 mercury 40hp EFI 3cyl outboard motor. It runs great
I have a 06 mercury 40hp EFI 3cyl outboard motor. It runs great out of water with a hose connected to it. When I put the boat in the water it takes off just fine then drops RPM's. It's suppose to run … read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
Ive only had moderate success with just answer. I love
I've only had moderate success with 'just answer'. I love to pay when you solve my problem. I don't pay if you don't; so if this is an issue please don't respond. I have a new (run less than 100 hrs) … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 22 ft Talon Tunnel hull with 2 Mercury 2.4 litre EFI
I have a 22 ft Talon Tunnel hull with 2 Mercury 2.4 litre EFI outboards running off a single foot accelerator. Engines are 1989-1990 with only 170 hours.Have not seen much recent use. I run both engin… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have 2 MERCURY 2.4 LITRE EFI Outboards ( 1989 and 1990) models
I have 2 MERCURY 2.4 LITRE EFI Outboards ( 1989 and 1990) models but very low time. 170 hours.They run off a single foot acccelerator. The boat has not been used much in recent years. I periodically r… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Have 3-year old Mercury 40HP EFI motor. Runs great after initial
Have 3-year old Mercury 40HP EFI motor. Runs great after initial start, and after 3-4 minutes 1/2 to 3/4 full speed, suddenly "pulls back" as if I pulled back power. Then will idle slowly or die. Then… read more
Outboard Guy
Outboard Guy
Vocational, Technical or Trade Scho
66 satisfied customers
I have a 1999 225 mercury efi, it will start and idle just
I have a 1999 225 mercury efi, it will start and idle just fine, you can even give it gas and go at a very fast idle. But when you give it enough gas to try to get on plane , it will fall on its face … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 89/90 40HP oil injected Mercury outboard (SN#0C160126).
I have a 89/90 40HP oil injected Mercury outboard (SN#0C160126). Had not run it for three years. New plugs/new gas with STARTRON. Starts with choke, but will not idle. As long as choke is engaged engi… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
I have a 40hp-4cylinder Mercury Mariner Magum outboard motor
I have a 40hp-4cylinder Mercury Mariner Magum outboard motor on my pontoon boat. When I am thru using the boat and it sits awhile in the sun gas starts dripping off the throttle return spring on both … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 10 year old 40 HP Suzuki outboard that runs OK, at
I have a 10 year old 40 HP Suzuki outboard that runs OK, at low speed, but after about 10 seconds acceleration, it almost stalls, and has to be returned to low speed. Gas is about 45 days old (stored … read more
OutboardVA
OutboardVA
Boat mechanic,rigger and salesman
Yamaha Drive Train Systems
6 satisfied customers
My motor starts fine and idles fine, but wont get up to speed...just
My motor starts fine and idles fine, but wont get up to speed...just chuggs along at full throttle. I have run it for about 20 minutes trying to burn out water if it is in system...would thing it woul… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
Evinrude E-Tec engines claim to need NO MAINTENANCE for 300
Evinrude E-Tec engines claim to need NO MAINTENANCE for 300 hrs. How do these compare to 4-Stroke Hondas?… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x