Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2010 searay 310 sundancer with 350 mag mercruiser
i have a 2010 searay 310 sundancer with 350 mag mercruiser drives and bravo III outdrives. engines have approx 130 hrs. i purchased the boat in november and had it winterized. this spring when i went … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
have twin 470;s,,165 hp,,,just paid 2000.00 to adjust shifter
have twin 470;s,,165 hp,,,just paid 2000.00 to adjust shifter cables,,,both motors forward no problem,,,,into reverse not so much,,,port engine goes into gear at idle speed,,,soon as u apply any,throt… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Hi Mr. Kergan: I have Bravo II outdrive. I serviced it in
Hi Mr. Kergan: I have Bravo II outdrive. I serviced it in the fall. I have not removed the drives for a couple of years now. The port drive has a leak somewhere. The bottle continues to empty very slo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have twin 250 verados. Yesterday I lost battery power to
I have twin 250 verados. Yesterday I lost battery power to the port engine. It continued to run, but the DTS limited my throttle rpm to 4800. When getting to safety, i put both motors in neutral. I th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
i am considering buying a 1969 Chris Craft Commander with twin
i am considering buying a 1969 Chris Craft Commander with twin 8v53 Detroit Engines. They have about 3200 houurs on them. The port engine smokes when fired up, even after about 15 minutes but the star… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Both 496 mags will not stay running. Schared valve had little
Both 496 mags will not stay running. Schared valve had little air. Boat ran fine when docked. Yesterday starboard out lube bottle empty(strange). Alarm going beep-beep.filled bottle with lube. connect… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1986 44 Gibson houseboat powered by twin 454 mercruisers
I have a 1986 44' Gibson houseboat powered by twin 454 mercruisers with bravo II drives. I think it weighs around 19000lbs. I am considering doing the Great Loop and am worried about the reliability o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
My 1991 Maxum 2300SCR was re-powered last winter with a new
My 1991 Maxum 2300SCR was re-powered last winter with a new Mercruiser 350V8. A couple problems my mechanics can't seem to solve: 1. running at plane, the boat suddenly loses power. Engine runs, but i… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Hi, Am writing from Sydney Australia. I have a Riviera M400
Hi, Am writing from Sydney Australia. I have a Riviera M400 fitted with twin 2005 Volvo Penta D6-350 diesel stern drives. On the way home from a day out yesterday, I got a warning light on the analog … read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
Hi, I have a 2006 Searay Amberjack 290 with twin T-VD-350 Mercruiser
Hi, I have a 2006 Searay Amberjack 290 with twin T-VD-350 Mercruiser Marnum MPI Horizon engines (T-300 hp). It is inboard/v-drive, fuel injected, and has the Mercruiser Smart Craft System. The engines… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
7,228 satisfied customers
Port mercury verado will not crank- battery is charged-fuses
Port mercury verado will not crank- battery is charged-fuses checked. When the ignition key is turned nothing happens. Voltage does not show on voltage meter etc. The other engine starts normal. All p… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Hi I have 2- 6.2 Mercruisers in my 2004 Chapperal SSi 28 foot
Hi I have 2- 6.2 Mercruiser's in my 2004 Chapperal SSi 28 foot boat which I bought from the States last August. The boat is in mint condition with 190 hr. on the engines. Last year I got a two min. al… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have 2006 8.1 HO that is dragging to start. I sounds similar
I have 2006 8.1 HO that is dragging to start. I sounds similar to having low batteries but they are fine and the starboard engine has no issue turning over. Just after ignition, the smart craft sounds… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a boat, Bayliner 3250, with 2 Volvo stern drives model
I have a boat, Bayliner 3250, with 2 Volvo stern drives model SX-C21.43 XXXXXXXXXX(NNN) NNN-NNNN SX-C21.43 XXXXXXXXXX(NNN) NNN-NNNNwich all of a sudden started to slipper. I discoverd that it was not … read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
I have a 1982 35 chris Craft. I was out this weekend and
I have a 1982 35' chris Craft. I was out this weekend and when I was coming back to the slip the starboard engine would not go into neutral. I tried to move the lever several times to get it out of ge… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Ive got a 95 Sea Ray with a 5.7L Mercruiser. I recently hooked
I've got a 95 Sea Ray with a 5.7L Mercruiser. I recently hooked up the hose to run it in the driveway before taking it out on the water and shortly thereafter noticed a quarter sized spot of oil on th… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I have a 2001 Rinker 340 FV with twin FWC 6.2 Mercs / Bravo
I have a 2001 Rinker 340 FV with twin FWC 6.2 Mercs / Bravo III drives. I had the duo props removed for service over the winter. Now the boat will barely plane. It bogs down at 3000 rpms and slowly ch… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Just took delivery on a used boat that has twin 4.3 Osi-E engines.
Just took delivery on a used boat that has twin 4.3 Osi-E engines. I noticed the starboard stern drive resevoir was almost empty and the port resevoir was almost full but the oil looked milky. Does th… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

7,228 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x