Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have hard shafting issue, replace and even replace the
I have hard shafting issue , replace and even replace the lower and shifting control road dog clutch , 2003 115 hp Mercury 4 stroke .. this the first issue I have had with the motor. I have the boat a… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
I have a question about 2011 250hp verado. When i tilt the
Hi, i have a question about 2011 250hp verado. When i tilt the engine all the way down it girks out trim fluid out of the green nylon washer that the motor turns on. It is the large tube that is betwe… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
1999 evinrude ficht E 200 FPLEEN-- fuel response issue- I
1999 evinrude ficht E 200 FPLEEN-- fuel response issue- I replaced a new fuel lift pump- My problem-- after a short idle- once I accelerate- engine bogs down and will not plane boat-however, if I shut… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Have a 115 4 stroke, motor won't start. Makes no noise. Trim
Have a 115 4 stroke, motor won't start. Makes no noise. Trim switch on motor works but not at helm or front.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,309 satisfied customers
When installing new battery I accidently hooked it up
when installing new battery I accidently hooked it up backwards frying some ground wires under the dash. replaced all burned wires and fuse. everything else works, all gauges starter, tilt trim but no… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
I have a Mercury 88 200hp 2 stroke. It ran good years.
I have a Mercury 88 200hp 2 stroke. It ran good for 2 years. Then the 3rd year I put it in the water and it would only run at half speed or so, I don't know rpm whys because my tact odometer is broke.… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
I have a 2011 Yam 4-stroke F40ELHA. It is ideling too low
I have a 2011 Yam 4-stroke F40ELHA. It is ideling too low and missfiring. The higer t RPM the worse it missfires. Have replaced plugs, changed fuel, cleaned VST tank. What am I missing?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,309 satisfied customers
K, I just installed water pump on 2008 mercury 2 stroke
Hi K, I just installed water pump on 2008 mercury 2 stroke 50hp. I'm having problem when placed in reverse to neutral that the trans clicks. If I pull back to reverse 1" it no longer clicks. Any sugge… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
My 2004 225hp Mercury Optimax with 600 hours just started to
My 2004 225hp Mercury Optimax with 600 hours just started to not rev over 3000rpm under load but rev's freely to 6000rpm's in neutral.… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
I recently purchased a 1987 Mercury 115 tower of power
I recently purchased a 1987 Mercury 115 tower of power outboard - inline 6. It has Rough starting and idling and BOG issue. It will "only" start/ idle when we give it throttle in neutral (advance the … read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
I'm looking to buy a two stroke outboard yamaha . How can I
I'm looking to buy a two stroke outboard yamaha . How can I tell if it's carbureted or injected from model numbers… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
Engine starts fine, upon acceleration to 2000, 3000, 4000,
engine starts fine, upon acceleration to 2000, 3000, 4000, i just dies. Then when restarted it lagsfor about 2 seconds and then takes off. I have changed the fuel filter This is a 2002 150 hp, two str… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
I have a 2007 60hp Suzuki 4 stroke engine. It starts great
I have a 2007 60hp Suzuki 4 stroke engine. It starts great and runs great to 3200 RPMs. When I increase the RPMs it begins to "cut out" like it is not getting gas. If I push the throttle home it cuts … read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
My 2007 Yamaha has 190 hours on it. When I took the boat out
my 2007 Yamaha has 190 hours on it. When I took the boat out today it idled fine however when given throttle it bogs down and won't accelerate past 4200 rpms. I hadn't used it for a few months but it … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,309 satisfied customers
My 8hp 4 stroke is not squirting cooling water out the back
my 8hp 4 stroke is not squirting cooling water out the back within about a minute. I shut it down. Next try i could see water coming out half way up the drive column. Very low time engine. Any suggest… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
I have a 2008 167 Cutter sportster with an 2008 Mercury 50
I have a 2008 167 Cutter sportster with an 2008 Mercury 50 hp 2 stroke, the boat weighs 1500 lbs and does 30 mph at 4800 rpm but is sluggish getting up on plane. It currently has a 19 pitch aluminum p… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
20,309 satisfied customers
Have 1999 sprint 296 w mercury 200 efi.... getting 2 alarms...beeping
Have 1999 sprint 296 w mercury 200 efi.... getting 2 alarms...beeping one all time then solid alarm after 5-10mins at throttle....also boat starts hopping very very bad after running a min or 2 at pla… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
A ground wire was accidently hooked to the pos. battery terminal
A ground wire was accidently hooked to the pos. battery terminal now we have no spark to the plugs.2004 115 4cyl. mercury. Small amount of smoke at the engine.Any idea where to start. Thanks… read more
Charles
Charles
Certified Mercury Tech
5,575 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,488 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

20,309 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x