Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I just bought a 1991 Bayliner Jazz (jet drive) with a 3
Hey ted; I just bought a 1991 Bayliner Jazz (jet drive) with a 3 cylinder mercury sport jet 90. Im in Minnesota and need to winterize the engine. Are these engines self draining of water? If not how d… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
1998 merc 175xr2 sport jet leaking clean water from behind
Second opinion] 1998 merc 175xr2 sport jet leaking clean water from behind the switch box on the starter side of engine located directly under the ecm,water sprays into the bilge and hoses have been c… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
How much do you charge for answers? I have a 2000 mercury
I have a 2000 mercury 175xr2 sportjet. Thermostats and poppet valve delete. Have good water circulation on hose. In water no water at tell tale. Have water flow on hose through all.lines . The only place under an obstruction is at the starboard side bottom at the brass.fitting on figure 8 style poppet cover. I tried putting air, air.and water, and it does not flow through the small hole behind poppet cover. I.removed cover and ran hose good flow.from.large hole with no poppet valve, but no water from small hole … read more
Charles
Charles
Marine Mechanic
Certified Mercury Tech
5,754 satisfied customers
I have a 1995 Bayliner Jazz Jet boat with a 120HP Mercury
I have a 1995 Bayliner Jazz Jet boat with a 120HP Mercury sport jet. Not knowing how to winterize it last fall we poured some RV antifreeze into the engine thru the water intake hose and fogged the engine. When we went to flush it out. We have the Mercury hose adapter for it. We turned the hose on prior to starting the engine like I would on any outboard not to damage the impeller. The engine would not turn over and in fact would move. I took out the top two spark plugs and they looked fine. I took out the bottom two and water came out of the cylinders. Freaked me out but knew I had to get the water out of the cylinders. I did by turning the engine with out the plugs. I then coated the cylinders with fogging oil and also sprayed in the carbuator. Put the plugs back in and was able to get it started. Felt better. I learned that it had a SS impeller and that it wouldn't get damaged and that I had to start the engine first before we turned the water on as to not flood the cylinders again. We were able to start it and let it run for a while. Everything seemed normal. We went to launch it and couldn't get it started. We opened the hatch and noticed the bilge pump was running because water was coming in the bilge. It seemed that when we were trying to start it that the enging would pump water into the bilge through a small port at the bottom of the bilge. We took it out. It sat for a few weeks and I decided to try and start it again to see if we could figure it out. We got it started but didn't hook the hose up. We noticed that we were getting an exhaust gas from that port that we saw the water coming in a few weeks earlier. I didn't know if this was normal for water to be pumped in there and then the automatic bilge pump would pump it out. I has two bilge pumps. One has a automatic float switch. The other is controlled by the switch on the dash. The spark plugs look very clean and no carbon deposits on them. Is it possible this is just an old boat and needs a good tune up. We bought this last year and it has been a learning experience. Any advice would be appreciated. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have Tige boat with a 5.7 L Marine Power. I noticed the
I have Tige boat with a 5.7 L Marine Power. I noticed the other day water was spraying out of what looked to be the flange where the starter bolts to the engine. I turned it off checked around ,starte… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Hello, I have a 1990 MerCruiser 7.4/V8 Bravo with a stern
Hello, I have a 1990 MerCruiser 7.4/V8 Bravo with a stern drive installed in a Bayliner 2556 Convertible. The engine is leaking water somewhere in between the bell housing and stern drive. I first not… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
cooling water is spraying on engine while running and filling
cooling water is spraying on engine while running and filling bilge with water, where should i look for problem?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Just purchased 2006 32 suntracker with mercruiser 3.0. Previous
Just purchased 2006 32' suntracker with mercruiser 3.0. Previous owner said it is equipped with easy winterization option. He briefly showed us what looked like two cooling hoses that ended at upper s… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
A Mercury Sport Jet 240 EFI. If I start the motor first and
A Mercury Sport Jet 240 EFI. If I start the motor first and then turn on water it runs fine and no problem. If I turn on the water before starting it fills the motor with water. Power head has been ap… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a VX110 2007 Sport jet ski , it seems to take on a fair
I have a VX110 2007 Sport jet ski , it seems to take on a fair bit of water when normal riding as in 3 - 4 inches when pulled out onto boat ramp , water is warm when drain plugs undone , I think this … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1997 Sugar Sands Off-Shore Tango jet boat with a 175
I have a 1997 Sugar Sands Off-Shore Tango jet boat with a 175 HP Mercruiser Sport Jet motor, how do I winterize? Where can I get a service manual?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a1999 seadoo gtx limited jet ski that is slipped on
I have a1999 seadoo gtx limited jet ski that is slipped on the lake taking on water whilesitting in the water. Just had the engine redone and the first two weeks it was fine . Next thing I knew it was… read more
Kenny O.
Kenny O.
399 satisfied customers
I have a 1994 Bayliner Jazz with a merc 90 sport jet. Has
I have a 1994 Bayliner Jazz with a merc 90 sport jet. Has good compression, carbs just cleaned and adjusted, good spark. Boat throttles up ok, new impellar and sleeve, put boat in water and top speed … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have 2005( ) 8-cyl. Mercruiser, Model # MCM 350 MAG MPI,
I have 2005(?) 8-cyl. Mercruiser, Model # XXXXX 350 MAG MPI, Engine serial # XXXXX 326634. I wanted to winterize it and looking for advise how to drain it properly and fill in with antifreeze. Is ther… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
My 1997 Yamaha 135 jet boat is taking in water when it is just
My 1997 Yamaha 135 jet boat is taking in water when it is just sitting at the dock. The bilge seems to fill up in about 8 hours and then seeps into the engine compartment. When I turn the bilge pump o… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 2004 Thunder Jet Boat with a Mercury 175XR2 sport
I have a 2004 Thunder Jet Boat with a Mercury 175XR2 sport Jet that pumps water well but still overheats quickly especially in warmer rivers and lakes or when running hard pulling a tube etc... I have… read more
Carl
Carl
High School or GED
4 satisfied customers
last week I drained and refilled my lower unit on my merc 5.0
last week I drained and refilled my lower unit on my merc 5.0 stern drive. tonight when I checked my boat I could smell gear lube.and there was a fair amount in my bilge. how can it get in there. can … read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
If the wear ring is bad in a 1997 seadoo with the jetski ...
If the wear ring is bad in a 1997 seadoo with the jetski take on wate? How do to tell if the bilge pump is working on a seadoo jetski and a tigershark jetski. I have both and each are taking on water.… read more
RSRBOB
RSRBOB
MC / Pwc Shop Owner
Vocational, Technical or Trade Scho
457 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x