Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1995 60 hp 3 cylinder carburated mercury 2 stroke
I have a 1995 60 hp 3 cylinder carburated mercury 2 stroke outboard. very hard starting. The primer solenoid has fuel inlet coming from upper carburator and fuel line oulet going to a fitting located … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,666 satisfied customers
Yamaha c40 outboard that has been sitting for a while. Has
Yamaha c40 outboard that has been sitting for a while. Has fresh fuel, just replaced the fuel line & primer bulb. Pulled the carbs apart to look at them and they are clean-all jets are clear, no gum o… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
531 satisfied customers
02 yamaha 90TLRA will crank but will not start need help. I
02 yamaha 90TLRA will crank but will not start need help. I took carbs apart complete soak and clean and new gaskets and floats. Pulled off prime start and checked with 12v battery it operates correct… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,666 satisfied customers
Just bought a 2003 johnson cold starting is a .I know
just bought a 2003 johnson cold starting is a bitch.I know about the choke but does not help. marnia guy says its my technique. any ideas?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1999 seadoo gti and the problem is at any given time and speed
1999 seadoo gti and the problem is at any given time and speed the machine will just act as if you hit the kill switch , stops cold . to restart you need to reattach the key until you get the two chir… read more
Expert
Expert
I replaced 6 gal.fuel tank and fuel line today with new epa
I replaced 6 gal.fuel tank and fuel line today with new epa required ones for outboards. I cannot get it to start. I pressed in ball valve to allow primer ball to be full. It will start for a second w… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I am having starting my outboard after it warms up. When it
I am having starting my outboard after it warms up. When it is cold. it starts as normal using the electronic primer, but after it runs a while and I cut it off and let is sit for more than 10 minutes… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2002 90hp Johnson J90VLSN that I purchased new. I
I have a 2002 90hp Johnson J90VLSN that I purchased new. I have had problems all along with hard to start and even after it has run for a while. t will even cut off at idle and is a bear to start. The… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Engine is extremely difficult to crank when cold(4-5 days sitting).
Engine is extremely difficult to crank when cold(4-5 days sitting). 1989 Evinrude XP 150 has good compression and will crank easier out of water(why?), but is almost impossible to crank the first time… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
86 merc 75hp i can get it to start only if i squirt fuel into
86 merc 75hp i can get it to start only if i squirt fuel into carbs. i'm thinking i have a problem with enrichment/choke valve system. also am suspicous of the new fuel pump kit i put in because origi… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
150 Gt 89 model johnson V6. If motor sets over a day or two
150 Gt 89' model johnson V6. If motor sets over a day or two it is very hard to start, but once it cranks for the first time it can be started the rest of the day real easy. The fuel pump is pumping f… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 99 Johnson J90PLEEB. It is very hard starting and
I have a 99 Johnson J90PLEEB. It is very hard starting and primer bulb will not stay hard. I have cleaned all4 carbs. replaced all fuel lines, replaced anti-siphon valve, and new fuel pick up tube, pu… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I Have a 1980 35 hp evinrude outboard. Then engine started
I Have a 1980 35 hp evinrude outboard. Then engine started , idled for a few seconds then shut off . Now it turns over but won't start. It's got new plugs and battery. Any ideas?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
While operating my inflatable dinghy with a 9.9 HP 2 cycle
While operating my inflatable dinghy with a 9.9 HP 2 cycle Mercury outboard with tiller control and up on a step and near full power, the trottle stuck wide open and I had to use the safety switch to … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Have a seadoo GSX that has a new battery electrical seems to
Have a seadoo GSX that has a new battery electrical seems to work fine wont start using choke and holding throttle open Have primed cylinders with gas it starts but then cuts out, appears like its not… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Have a 1996 waverunner w/low hours. Has never been neglected
Have a 1996 waverunner w/low hours. Has never been neglected except for one weekend this year when my son left it tied up in the water for two days. Prior to that it had been flushed and washed each d… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Hello, I have a 45 hp honda motor that fires and runs well
Hello, I have a 45 hp honda motor that fires and runs well at idle, but want to die at about half throttle and as you give it more gas it dies, if you pull the manual choke about half out it runs well… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have 2007 mercury 9.9 4 stroke engine that wont start.
I have 2007 mercury 9.9 4 stroke engine that won't start. There is one clear problem in that the run switch is broke. I need to know if the run/off switch is open in the run position or clsed inthe ru… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

8,646 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x