Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2006 Sea Ray 240 with a mercruiser engine. the last
I have a 2006 Sea Ray 240 with a mercruiser engine. the last few times I have used the boat, there has been a vibration while going at speeds above 10 mph and it seems the vibration is worse when the … read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
When moving the throttle from neutral to forward idle it has
When moving the throttle from neutral to forward idle it has a delay of approximately 5 seconds for the boat to start moving … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,872 satisfied customers
My Bravo 3 engine has really bad grinding noise, but it
My Bravo 3 engine has really bad grinding noise, but it usually started. Now it grinded then stopped and killed all electric on the boat… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 7.4 Mercruiser Bravo 3 on a 2000 Monterey 262. The
I have a 7.4 Mercruiser Bravo 3 on a 2000 Monterey 262. The boat will not shift into forward, but will go into reverse and back to neutral just fine. We changed the gear oil, pulled the outdrive off, … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
I have a 90 rienell 24ft cuddy with a small block chevy( not
I have a 90 rienell 24ft cuddy with a small block chevy( not sure on actual size) it has the king cobra outdrive. The boat shifts fine out of the water when running with the ears on. When in the water… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have and alpha 1 Mercruiser. I see crank raw water pumps
I have and alpha 1 Mercruiser. I see crank raw water pumps for boats. Is there one of these pump kits made for the Alpha so I dont have to get into the outdrive to fix an impeller? I would like to cha… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I own a 2005 Chaparral with a 5.0 Volvo Penta. The outdrive
I own a 2005 Chaparral with a 5.0 Volvo Penta. The outdrive is a duo prop. The boat has 120 hours on it. It makes a "clunk" when going from neutral to reverse and from neutral to forward. My mechanic … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
A new Mercuusier Alpha 1 drive mated to a new 5.7 MPI engine
A new Mercuusier Alpha 1 drive mated to a new 5.7 MPI engine with a new shift cable installed twice. All measurements match Merc specs. Shift stall works as designed of a new shift control. He's the r… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have recently purchased an 85 Chris craft Scorpion 230 with
I have recently purchased an 85' Chris craft Scorpion 230 with mercruiser outdrive removed from it du to rock damage a replacment Alpha drive was given to me with the the boat upon trying to install I… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
What is the correct gear ratio for the outdrive on a MCM 5.7Lv8
What is the correct gear ratio for the outdrive on a MCM 5.7Lv8 the boat is a Rinker, Engine serial # XXXXX Trans serial # XXXXX there is a 1.84:1 on at the moment but we think it has been changed, an… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I own a boat with a two year old Mercury Bravo One outdrive.
I own a boat with a two year old Mercury Bravo One outdrive. If I Slowly shift it into reverse before it in-gauges into reverse I sometimes can feel a little almost click feel in the Shifter. If I shi… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
Hi I have a 1979 cobalt w/mercruiser 260 issues with the shifter after
Hi I have a 1979 cobalt w/mercruiser 260 issues with the shifter: after two days of nice boating with some idling problems (would conk out when in neutral or slow speed) I can start in neutral and rev… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a boat with twin Mercuriser 7.4L Engines and Mercruiser
I have a boat with twin Mercuriser 7.4L Engines and Mercruiser Outdrives. Today while boating, we lost one outdrive (a couple of shutter from the outdrive....like shifting gears), but the engine still… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
i shifted my outdrive from a foward position while moving at
i shifted my outdrive from a foward position while moving at about 5 mph into reverse to avoid contact with apontoon drunk driver pulling out of his slip at which he hit a boat directly across from hi… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I own a 1988 Marathon 21 ft cuddy with a mercruiser alpha 1
I own a 1988 Marathon 21 ft cuddy with a mercruiser alpha 1 cuopled to a 350 cu in V8. When docking the boat shifting from forward to revervse or reverse to forward, the gears grind and when it finall… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have 2001 Chaparral witrh twin 5.7 EFIs and Bravo 3 Stern
I have 2001 Chaparral witrh twin 5.7 EFI's and Bravo 3 Stern Drives On Sunday I had to run the boat up to 4000 RPM's to cruise at 26-27 MPH Seemed like the port engine was lagging - Tried put both eng… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
403 satisfied customers
I just purchased a 1998 Stingray with a 5.7 mercruiser with
I just purchased a 1998 Stingray with a 5.7 mercruiser with the dual prop (stainless) i believe its the brovoXXXXX Anyway when I'm put the boat in gear to go forward it shifts in no problem, after goi… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a 7.4 FI engine and a Bravo lll outdrive. I was in forward
I have a 7.4 FI engine and a Bravo lll outdrive. I was in forward gear idling and increased the throttle to get up on plain and it went out of gear and it would not go back in gear forward or reverse.… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,872 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x