Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
After draining gas with water,put in new gas. Motor ran 15
After draining gas with water,put in new gas. Motor ran 15 minutes full speed. stopped and restarted engine about 30 minuts later. Motor started right up ran a few minutes on low speed and died. It to… read more
Charles
Charles
Certified Mercury Tech
5,322 satisfied customers
I have a 40 hp 3 cylinder 1999? Mercury that will run full
I have a 40 hp 3 cylinder 1999? Mercury that will run full throttle for about 30 seconds (about 5000 rpms) then cuts back to 3500 rpms. It will run at idle speed for a longer period. I pump the bulb a… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1990 40 hp Evinrude. It fires right up and idles
I have a 1990 40 hp Evinrude. It fires right up and idles fine. But when you throttle it up in gear, it backfires here and there. Can unburned oil that is there from previous trips cause this? I just … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I just installed a new E-TEC 40 hp and a new E-TEC 60 hp on
I just installed a new E-TEC 40 hp and a new E-TEC 60 hp on two different boats. The 60 hp works just fine, but the 40 hp have an oil related problem. The instrument is warning for NO OIL and the buzz… read more
MarineService8
MarineService8
34 satisfied customers
I have a 1979 115 Evinrude. Replaced the water pump, fuel
I have a 1979 115 Evinrude. Replaced the water pump, fuel lines, fuel pump, new spark plugs, inline fuel filter, and rebuilt the carbs. When I put her in after all of this she ran fine...I even got he… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
Hello: I have a 1989 70 hp E70 TLCEM. After I put a load on
Hello: I have a 1989 70 hp E70 TLCEM. After I put a load on the motor the alarm goes off and the engine RPM drop to an idle. I have been told it is a cooling issue but the engine puts out a good strea… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
15 hp: Honda 15 HP outboard motor. Ran fine in the barrel.
Honda 15 HP outboard motor. Ran fine in the barrel. Get it out on the water and it hauls butt, and then at the end of the run when I slow all the way down, it idles out and dies. And then it won't res… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I ran my boat yesterday for about 30 minutes and it ran fine
I ran my boat yesterday for about 30 minutes and it ran fine with no misfires or anything. I turned the engine off and sat for a few minutes and went to restart and the boat turned over but the engine… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1986 Evinrude 140 HP, I sank it last june after flushing it
1986 Evinrude 140 HP, I sank it last june after flushing it with fress water and had it running within 40 minutes. then took it out for the day and ran ran it every day for 10 minutes after to keep it… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
Hi Just purchased a 2011 25 HP Evinrude E Tec . On the first
Hi Just purchased a 2011 25 HP Evinrude E Tec . On the first fishing trip out it started up on the first bump of the starter and idled perfect for 5 or so hours. Pick up our gear to move to another sp… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I recently purchased a Flats and Bay with 2003 mercury 90 hp
I recently purchased a Flats and Bay with 2003 mercury 90 hp saltwater 2 stoke motor. Ran great when hooked up to water hose and muffler. Took it out on the water would not stay started, Idle was roug… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have 2 2004 200 hp evuinrudes on a 25ft hydra sport center
I have 2 2004 200 hp evuinrudes on a 25ft hydra sport center console, after running @4000 rpm for exactly 20 miles the starboard engine just shuts off, not slows down, just shuts off! then as I bring … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,801 satisfied customers
Brand new out of the box 5 hp mercury outboard On the first
Brand new out of the box 5 hp mercury outboard: On the first trip out, while paying attention to the break-in instructions, it ran nicely for 20 minutes. Stopped to talk for 15 minutes. Cranked up fir… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
2005 Evinrude E-tech 225hp, 124hrs on the engine, never been
2005 Evinrude E-tech 225hp, 124hrs on the engine, never been ran hard. Issue: Boat's been out of the water for just over a month. I've been starting the engine with the water hose attachment on the lo… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
Is my waverunner toast At lake this weekend, was running
Is my waverunner toast? At lake this weekend, was running at full speed and it died. It would restart and idle fine. After that, it appeared to lock up after running a few minutes. It would not crank … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
About two years ago I purchased a used pontoon boat with a
About two years ago I purchased a used pontoon boat with a used 50 HP mercury motor. it has worked fine till this year. On the first time out this year it seemed to run rough but started ok. Took it o… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
1986 Cajun Boat with 150 HP Evinrude OB Jerry Fox Derby
1986 Cajun Boat with 150 HP Evinrude OB Jerry Fox Derby Kansas XXX-XXX-XXXX Purchased January 2007 Ran in the drive way with Muffs and idled OK, a little rough at about 800-900 RPM Memorial Day Weeken… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have already spent over $300 trying to resolve this problem,
I have already spent over $300 trying to resolve this problem, including a paid for reply from "Pappys sales and service". I will pay a nominal sum if I get a solution answer. I have a 1986 Evenrude 1… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

6,471 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x