Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Mercruiser 8.1 s/n:0M312434 straight onboard. This motor is
Mercruiser 8.1 s/n:0M312434 straight onboard. This motor is fresh off of rebuild and is in Guardian mode. This motor is fresh off of rebuild and is in Guardian mode. Throwing codes PRT emct lo, EST 7 … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
I have a 2008 Trophy Pro with a Mercruiser 3.0 TKS.. Several
I have a 2008 Trophy Pro with a Mercruiser 3.0 TKS.. Several weeks ago she started stalling when I tried to throttle her up to about 3500 to 4000 rpms. She began to diesel when I shut her down. She th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
I HAVE A 1991 SEARAY WITH A 305 V8 5.0 XL ENGINE AND I CANT
I HAVE A 1991 SEARAY WITH A 305 V8 5.0 XL ENGINE AND I CANT GET IT STARTED. I REPLACED THE COIL, INITION (KEY) SWITCH, DISTRIBUTOR CAP, ROTOR, PLUG WIRES, CLEANED BATTERY TERMINALS AND STARTED CONNECT… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
Mercury mercruiser: I have a 3.0L mercruiser and I am trying
I have a 3.0L mercruiser and I am trying to put a est ignition system in place of a ddis system.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
Now that I have the Delco Voyaher EST installed and running
Now that I have the Delco Voyaher EST installed and running I can not get the base timing set as the engine dies when I connect to the B+ source. Any ideas. This is a Sea Ray 160BR with a 3.0.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
I have a Delco Voyager Electronic Ignition. I trying to find a diagram for the shift inter
I have a Delco Voyager Electronic Ignition. I trying to find a diagram for the shift interrupter, Terminal Block and Delco Voyager unit… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
Tan I have another question for you its pertaining to my distributor.
Tan I have another question for you its pertaining to my distributor. On the 350 Mercruiser I had originally it had an external coil, but the new one I have purchased does not have the coil I believe … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
Have a 1994 Baja , Mercruiser 4.3 thunderbolt ignition , Have
Have a 1994 Baja , Mercruiser 4.3 thunderbolt ignition , Have power at the coil ( both sides ) But no power coming out , I have a solid purple wire up near the carb that doesn't go anywhere but shows … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
I need help troubleshooting a Mercruiser TBV ignition problem.
I need help troubleshooting a Mercruiser TBV ignition problem. I am pretty good with a wrench and multi meter but have run into a dead end on this problem. My 1998 Mercruiser 5.7 died suddenly a coupl… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,157 satisfied customers
I am working on a 1987 Four Winns 160 Freedom with a 140 hp
I am working on a 1987 Four Winns 160 Freedom with a 140 hp 3.0. I have just replaced the camshaft and timing gears. the boat has not ran in two years. The trouble is it will not start. I am not getti… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1989 Mercruiser 350 with an Alpha One Gen II drive
I have a 1989 Mercruiser 350 with an Alpha One Gen II drive and now need to replace the shift interruptor. It comes on a new shift plate since the original shift interruptor is changed to a new, diffe… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hello, I have a 1989 Mercruiser 454 Mag that wont start. No
Hello, I have a 1989 Mercruiser 454 Mag that wont start. No spark at the coil wire. Cranks over fine. There is voltage at the positive side of the coil. I did put in a new coil yesterday. I installed … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a Mercury outboard 50HP motor that I am having trouble
I have a Mercury outboard 50HP motor that I am having trouble getting to start. The previous owner cut the wires to the key switch and installed a toggle switch for the starter and one for a cut-off. … read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
I have an 87 Mercruiser 3.0L and decieded to put in an electronic
I have an 87 Mercruiser 3.0L and decieded to put in an electronic conversion kit for the distributor and it does'nt work. I called a mercruiser shop about information on either a ballast resistor or w… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
I have a 1991 V6 L Mercruiser engine in a Harris Flot boat
I have a 1991 V6 L Mercruiser engine in a Harris Flot boat that want start. One of the exhaust manifolds was cracked and I repaired it and reinstall the manifold. Now the engine want start, it want ev… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
i have a 1999 ebbtide w/ 5.0 mercruiser w/ thunderbolt 5 ignition.
i have a 1999 ebbtide w/ 5.0 mercruiser w/ thunderbolt 5 ignition. I have replaced coil, module and i am still not getting spark from coil. The engine was taken out to fix small crack in block. There … read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 1978 Mercury 90hp 2 stroke engine. A short ...
I have a 1978 Mercury 90hp 2 stroke engine. A short somewhere in the wire harness caused the battery to melt along with some internal components. I put on a new harness, the engine is cranking but wil… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a around 1969 Evinrude Outboard 65 horsepower.
I have a around 1969 Evinrude Outboard 65 horsepower. Engine starts fine, idles good and has full power. However after about 1/2 hour of running in various power modes from near idle to full power the… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,157 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x