Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have an 89 Larson with merCruiser 4.3 inboard/outboard.
Hello James, I have an 89 Larson with merCruiser 4.3 inboard/outboard. Just was on the water and brought boat on plane and then opened throttle rapidly to max. Heard a weird noise from the back and su… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a bent prop . but I think I have another problem . when
I have a bent prop . but I think I have another problem . when I accelerate it wont power up like if I was trying to pull a skier . The only way I can get up to speed is to slowly accelerate until it … read more
Charles
Charles
Certified Mercury Tech
5,633 satisfied customers
Mercury 6hp motor used on small 9 1/2 ft dinghy. Engine seems
Mercury 6hp motor used on small 9 1/2 ft dinghy. Engine seems to run ok. Will provide power to get boat on plane sometimes, but periodically prop seems to stop spinning and motor will just rev or wine… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2003 Mercury 115 4 stroke. When you get planed and running down the river the po
I have a 2003 Mercury 115 4 stroke. When you get planed and running down the river the power drops off, if you pull back the throttle just a hair and open it back up it will take off than drops off ag… read more
Charles
Charles
Certified Mercury Tech
5,633 satisfied customers
so i have s 1997 Johnson Fisht 150 Fast Strike. My motor starts
so i have s 1997 Johnson Fisht 150 Fast Strike. My motor starts fine and idles fine but when i run wide open im only at 4000 rpm. stock prop but i ordered a 21 pitch stainless. what would cause this? … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 14.5 foot pride boat with a 175hp Yamaha motor which
I have a 14.5 foot pride boat with a 175hp Yamaha motor which is probably way to big for the boat but that is what it came with. it is very stern heavy and hard to steer especially to port. we have re… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I WAS AT THE LAKE AND HIT A LOW PART OF THE LAKE, NO VISIBLE
I WAS AT THE LAKE AND HIT A LOW PART OF THE LAKE, NO VISIBLE SIGNS OF DAMAGE. COULD I HAVE DAMAGED TRANSMISSION. IT STARTS I CAN PLANE THE PROP UP AND DOWN . I CAN STEER BOTH LEFT AND RIGHT. HOWEVER T… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a Trophy 2352 which has a mercrusier motor. The motor
I have a Trophy 2352 which has a mercrusier motor. The motor has a 2 barrel carburetor and I have tried 4 different props and the motor will not rev past 3800 RPM. My biggest problem is hole shot. I p… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
1996 Seadoo Challenger. Runs fine. No push out of the hole.
1996 Seadoo Challenger. Runs fine. No push out of the hole. You have to feather the throttle and slowly built revs to get it up on plane. If you lean on it it cavitates… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
have a 5.0 gl penta that for some reason is taking a bit longer
have a 5.0 gl penta that for some reason is taking a bit longer to get on plane than usaull, then once on plane speed is normal. also have a duo prop...… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I HAVE A MERCURY 9.9 MLA4ST 1996 SN 0H005430 WITH A PROPELLER
I HAVE A MERCURY 9.9 MLA4ST 1996 SN 0H005430 WITH A PROPELLER 48-828-156-0 ON A LUND WC14 BOAT. THE PROBLEM IS THAT IT WILL NOT BRING THE BOAT TO PLANE WITH EVEN 1 200LB PERSON. I HAVE HAD OTHER 14FT … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
i have a 150 optimax engine outboard i can ,t get up on plane
i have a 150 optimax engine outboard i can ,t get up on plane everytime i try but it will not move it will run when i move at low speed the mph gauge is not moving would this be a spun hub and it seem… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2006 Mercury 60 hp four stroke outboard. On my last
I have a 2006 Mercury 60 hp four stroke outboard. On my last fishing trip I throttled to WOT and the boat felt really sluggish. It would top out at about 4800-5100 rpm. About a mile down river the rpm… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I had purchased a used pontoon boat ( 20) last year with a
I had purchased a used pontoon boat ( 20') last year with a 50 h.p. 2 cycle 4 cyl. mercury for power. I sometimes thought it seemed as though i was running a lot of RPM and not much speed. How do i de… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
We use twin 3 # 250 HP outboard engines to run our ferry made
We use twin 3 # XXXXX HP outboard engines to run our ferry made of Aluminum with the following dimensions: Lenght 50 feet Width 15 feet Draft 1 foot Weight 8 tons We tend to lose the pinion, forward g… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,816 satisfied customers
I have a two stroke 115 Mercury engine, 2002. I was running
I have a two stroke 115 Mercury engine, 2002. I was running up river, and all of a sudden the engine rev'd higher, but the boat came to a crawl. I could get the motor to push the boat at idle, but whe… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
i have a 1988 baretta 18.5 with a 4 cylinder 3.0 liter engine,
i have a 1988 baretta 18.5 with a 4 cylinder 3.0 liter engine, the engine runs well but considering the age what RPM should I consider as full throttle… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
my wave blaster doesnt take off and come out of the ...
my wave blaster doesn''t take off and come out of the water like it should i can give it full throttle and it will wind up but seems to just spin and hardly move i have to feather it and get it to pla… read more
RSRBOB
RSRBOB
MC / Pwc Shop Owner
Vocational, Technical or Trade Scho
423 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,488 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x