Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Before I pulled my boat last season I had water leaking in
Before I pulled my boat last season I had water leaking in from behind the Starboard engine about 5 gallons an hour. The boat is dry docked at this time a mechanic said he is pretty sure it is leaking… read more
Charles
Charles
Certified Mercury Tech
5,633 satisfied customers
I have no juice on number 6 in the wiring harness. 2003
I have no juice on number 6 in the wiring harness. 2003 Bayliner 2150 5.0 L mercury MerCruiser. I do have juice across the top of the starter. No juice at the circuit breaker. Either side. My trim tab… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2011 mercruiser 5.0 MPI and am getting 1 horn per
I have a 2011 mercruiser 5.0 MPI and am getting 1 horn per minute. My boat is a 21ft hurricane deck boat and it also has trouble getting up on plane with more than 5-6 people on board. Could these be … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,816 satisfied customers
I have a 5.0 2004 Merc. W/Bravo 3 OD 3Point drain system. Engine
I have a 5.0 2004 Merc. W/Bravo 3 OD 3Point drain system. Engine temp. runs about 180 in water. Out of water with freshwater muffs on engine temp over 200 and top of OD hot. Where do I look for proble… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Greetings! I have 2 2000 Mercruiser 7.4 inboards in a 2000Cruisers
Greetings! I have 2 2000 Mercruiser 7.4 inboards in a 2000Cruisers 3375. I noticed the port engine was sluggish and laging behind the starboard engine by about 300 RPM and the boat has lost about 6 MP… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I am in market for used bowrider in $ 25000 range what is
I am in market for used bowrider in $ 25000 range what is the difference in value , reliability and performance etc of the Mercruiser 5.0 TKS 220 HP vs 5.0 MPI 260 HP should I only pursue the later ? … read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
TAN, 1999 Mercruiser v8 5.0 EFI timing procedure needed. What
TAN, 1999 Mercruiser v8 5.0 EFI timing procedure needed. What is the correct timing procedure for this engine? Thanks… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 7.4 2000 mercruiser I am replaciing injectors . Ineed
I have a 7.4 2000 mercruiser I am replaciing injectors . Ineed to know if r849896 is a acceptable substition for the r802632t all so can the be mixed as in 3 of one and 5 of the other. I need the flow… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I am considering buying a brand New left over 18 ft Mariah
I am considering buying a brand New left over 18 ft Mariah boat was wondering if it is a good boat and if there are any issues down the road do they follow through with their warranty?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I ALREADY HAVE BOWRIDER SEA RAY 200 YEAR 2002 WITH MERCRUISER
I ALREADY HAVE BOWRIDER SEA RAY 200 YEAR 2002 WITH MERCRUISER ALPHA 1 STERNDRIVE AND 5.0 MPI 260 HP. THEY HAVE A SERIOUS POOR BOAT PERFOMANCE.WITH MERCURY VENEANCE SS PROP 3 BLADES PITCH 19",TAKE A LO… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
hi. i am looking for the best quality boat with the most economical
hi. i am looking for the best quality boat with the most economical engine. i think 25 to 30 ft. I'm looking for good outside sitting area and comfortable quarters for. i don't see much real in 25-30 … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
Im having a beef with my motor mac regarding work he did on
I'm having a beef with my motor mac regarding work he did on my engine which came in far above the estimate. I need an independent estimate from someone who's familiar with a mercruiser 7.4 330 hp -Br… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,618 satisfied customers
I have a customers boat with two Mercruisers 5L (Ford 302
I have a customer's boat with two Mercruisers 5L (Ford 302 engines) with 4bbl carbs and standard ignition. I need to know the plug gap and dwell angle. One is a clockwise engine the other counter-cloc… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
i have a mercruiser 7.4 2001 model, they di a compression test
i have a mercruiser 7.4 2001 model, they di a compression test and the result are as follows cyl #1 125psi #2 140psi #3 100psi #4 130psi #5 125psi #6 110psi #7 135psi #8 130psi My consern lies with cy… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I am putting a head gasket and intake gasket on a 92 mercruiser
I am putting a head gasket and intake gasket on a 92 mercruiser 3.0 4 cylinder. What should the torque be of the head bolts and intake bolts?… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I have a 2006 Mercruiser 5.0 w/ Bravo III. The engine stalls
I have a 2006 Mercruiser 5.0 w/ Bravo III. The engine stalls at idle after being run 30 minutes or so. The engine will not start again until it has apparently cooled down. I have hade the entire fuel … read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
Trying to get my 1974 Searay SRV-193 running. I am having
Trying to get my 1974 Searay SRV-193 running. I am having difficulty with the proper firing order as I have found info for two different orders. 1-3-7-2-6-5-4-8 which has does nothing for me but seems… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
starboard engine misses under load, I have installed new plugs,
starboard engine misses under load, I have installed new plugs, plug wires, rotor, cap, points, condensor, coil 1976 century mercruiser 233 ford 351's still misses... any ideas?… read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
388 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

7,458 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,618 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x